Description
[contact-form-7 404 "Not Found"]
Pulse Code Modulation/Demodulation
FEATURES:
• In-built sine wave generator
• Test points to study different waveforms
• In-built DC Power supply
Technical Specifications:
• Sine wave Generator : Frequency : 1 KHz, Amplitude : 0 to 3Vpp
• DC Voltage : -1.5 V to +1.5V
• Clock Generator : Crystal based, 4.096MHz
• Data rate : 64 kbps (for 8 KHz sampling rate)128kbps (for 16 KHz sampling rate)
• ADC and DAC bits : 8
• Demodulator filter type : Butterworth low pass filter
• Filter type : 6th
• Filter cut-off frequency : 3.4 KHz
• Mic Pre-amplifier : Transistor based
• Compandingrange : -80dBm to +20dbm
• Switched faults : 4
• Test points : 35
• Fuse : 30V, 100mV
• DC Supply : ±5V, ±12V
• System Bandwidth : 3.4 KHz
Related products
PAM-PPM-PWM Modulation and Demodulation Trainer
PAM- PPM- PWM is the basic pulse modulation techniques. This trainer provides complete setup to the students for performing Experiments on these techniques. They can study Sampling, Pulse Modulation &Signal reconstruction process. Separate circuits are provided for each Techniques.
FEATURES:
• PAM- PPM- PWM Modulation and Demodulation Techniques,using Natural and Flat - top Sampling. • Natural Sample, Sample and Hold and Flat-top outputs. • Selectable 2 different sampling pulse frequencies on board. • On board Sine wave generators. • Voice communication using dynamic microphone and speaker • On board Filters and Amplifier • Functional blocks indicated on board schematic • Input- Output and Test points provided on board. • Built in DC Power Supply • Fully documented operating ManualTECHNICAL SPECIFICATION:
• Crystal Frequency : 6.14MHz • Sampling Frequency : 16 KHz, 32 KHz • Sine wave Generator : 1 KHz &500Hz, Amplitude (0-5)V, Tolerance +5% • Low Pass Filter : 4 Order BW Filter • Cut off frequency : 3.4 KHz • Voice Communication : Voice Link using dynamic mic& speaker • AC Amplifier : With Adjustable Gain control • Microphone type : Dynamic, 600 Ohm. • Audio Pre-amplifier : Op-amp based • Power amplifier : 1W Mono • Interconnections : BS2 Connector. • Power : 230V, 50Hz
Ultrasonic Interferometer
Ultrasonic Interferometer is a simple and easy to use unit for the accurate measurement of ultrasonic velocity in a Liquids and Liquid systems at the desired temperature (and at desired frequencies).
FEATURES:
• Accuracy in wavelength measurement – 0.01mm • Digital Panel Meter ( DPM) for observing the change in the reading between nodes /anti nodes (75mV approximate between a node and anti node) • Easy replacement of transducers with other frequency • Only one Liquid cell is required for all frequencies • Built in IC regulated power supplies. • The frequency of the Crystal oscillator at the piezo electric transducer is so matched at the 3 digit Decimal accuracy • The accuracy of Meter is 3 Digit Decimal • Stainless Steel based mechanical setup.ACCESSORIES:
• Liquid cell - One (with provision for water circulation) • Transducer (Longitudinal, 2MHz) - One • Micrometer assembly - One (with Tx)
Beat Frequency Oscillator Trainer
FEATURES:
• On board sine generator • Transistor based mixer • Built in power supply • Easy interconnections are made by patch chords • Detailed documentationTECHNICAL SPECIFICATIONS:
• Sine Source - Fixed Frequency : 43.5 KHz - Variable Frequency : 41 KHz to 45 KHz • Transistor based mixer provided • Built-in amplifier • Power supply - + 12V DC, 200 mA - Unit is operated using 230V AC Power.
Reviews
There are no reviews yet.