Description
[contact-form-7 404 "Not Found"]
Pressure Measurement Trainer
This module consists of a (0-100) psi pressure transducer of strain gauge type fixed in a pressure tank, one manually operated pump to develop pressure, pressure gauge and 3½ digital indicator to display the pressure.
Specification
• One metal pressure tank fitted with strain gauge type pressure cell.
• A ball valve fitted in a pressure tank to release the pressure.
• Bourden type pressure gauge provided in the tank to indicate pressure.
• One manually operated foot pump to generate a pressure of the tank.
• Signal conditioner for pressure cell output (0-5V)
• Provision for offset/span adjustment.
• A 3½ digit digital display indicator to indicate the pressure inside the tank
Related products
Wheatstone Bridge
Specification
• Four arms with one unknown arm to connect the unknown resistance • Two range selection arms provided to select the nearest range of unknown value. • Range of Measurement : 5Ω-100KΩ • Accuracy (Min to Max.) :±0.2 ± 5Ω • Tolerance : ±5% • Digital voltmeter (Range +5V to - 5V) is provided to indicate the Balance conditions • Built-in power supply
Transducer Trainer
Specification
• RTD acts as a temperature sensor • Strain gauge based load cell • Linear variable resistive transducer • LDR, Photo diode, photo transistor • Precision servo potentiometer • Inductive type proximity sensor • Heat source, Filament lamp, Buzzer • 3½ digit LED display • Analog type 10V Center-Zero meter • Inverting and Non-inverting amplifier • Amplifier with Gain and offset control • Instrumentation and summing amplifier • Low pass filter • Precision Rectifier • Timer and buzzer oscillator • Electric switch
Hall Effect Transducer
Voltage Measurement:
• One Voltage Signal conditioner is provided to interface with ADC • Output Voltage Range: (0-5V) • One Analog meter is provided to indicate the input voltage.Current Measurement:
• One Current Signal conditioner is provided to interface with ADC • Output Voltage Range: (0-5V) • One Analog meter is provided to indicate the input current. • Built-in Power Supply • One Auto Transformer is provided to vary the input voltage and current • 3½ Digit digital indicator
Level Control Measurement Module
This module consists of a process tank with a miniature pump, level sensor for 2 levels, a power supply, etc., To establish a ON/OFF control for the level of water. Circuitry is provided for stand alone operation or through a 8255 port of a Microprocessor kit.
Reviews
There are no reviews yet.