Description
Error: Contact form not found.
Related products
Turbine/Pump Unit
Description
For use as a water turbine to drive a generator producing electricity or for use as a pump driven by a motor and raising a head of water to produce potential energy. The rotor has eight 'bucket' blades and is housed in a block turbine chamber with a clear Perspex front. Two inlet tubules (for turbine and pump operation respectively) and one outlet tubule are provided and the shaft carries a 15 mm. diameter pulley. With driving belt.
Fly-Wheel Unit
Description
For use with a large motor/generator and a lamp unit to demonstrate the conversion of electrical energy to kinetic energy and then back again. Comprising an iron flywheel, mounted in cast brackets with bearings. The shaft has an aluminium 'V' pulley for driving with the spring belt supplied.
Mechanical Training Model
Description
Highly useful for demonstrating the most fundamental and frequently used mechanism. Very useful for engineering students. All the components are made of high degree of precision. These modules are assembled on transparent perspex sheets to facilitate teaching. Easy to assemble or disassemble.
Demonstration Dynamo
Description
This model uses the same basic assembly as the motor, but is mounted on a baseplate 230 x 90 mm approx. which also carries a hand-drive pulley 120mm. diameter coupled to the smaller dynamo pulley by a rubber belt to give a step-up ration. Electrical output is via a pair of 4mm sockets. The model may also be used as a motor on a 6-8 V D.C. supply.
Reviews
There are no reviews yet.