Description
[contact-form-7 404 "Not Found"]
DC Network Analyzer
Specification
• Here we provide the bi-polar Transmission Line.
• Simulated long, medium & short distribution lines selectable by patching in various length of DC Transmission line
• Two no of bi-polar DC generator sources with ON/OFF control and voltage regulator potentiometer.
– Two wire or Three wire Transmission Line operated in +12V DC
– Each DC generator are independently control by potentiometer.
• 2 digital voltmeters and ammeters provided in the input side and 2 digital volt meters and ammeters are provided in the output side
• of transmission line to read the input & output parameters of transmission line.
• One no of microcontroller based measuring system provide to read the input and output parameters.
• 4 nos of digital ammeters provided to read the load current
• 4 nos of resistive load and 4 nos of lamp loads are provided to load the transmission line.
Related products
Microcontroller Based Differential Relay
This test set-up consists of a. Microcontroller based differential relay. b. 300VA transformer set-up
Specification
• One PIC Microcontroller used as processor to read all current, (PY, SY) & activation of relay function • One LCD to indicate, - Set value, All currents - Set time, DMT/IDMT type - Relay tripping time. - Biased/Unbiased type status • Four numbers of key used - To select IDMT/DMT type or biased un-biased type - Set current value adjustment - Set time adjustment - Reset function • Six 5A CT used to sense primary and secondary current. • One 12V TPTT auxiliary relay used for contactor operation. • Specification: - Current input : 0-5Amp - Voltage input : 0-230V - Number of contact : Three number No contact @ 220V, 10Amp rating. - Auxiliary supply : 230VAC, 50Hz • PC interfacing facility power ON/OFF switch with indicator. • Make : VI MICRO • Model : VPL - 83A
Electro Mechanical Type Over Voltage Relay Study Trainer
This test set-up consists of a. Electromechanical over voltage-relay. b. Relay test setup with meter.
Electromechanical over voltage-relay
• One electromechanical type over voltage relay - Make: Megawin - Voltage setting multiplier (121V, 132, 143, 154, 165, 176, 187V) - Time setting multiplier. - One “NO” contact @ 220V, 10Amp rating. - One “NC” contact @ 220V, 10Amp rating. b. Relay test setup with meter • One 0-300V, 1AMP variable AC source provided for relay coil. • One auto transformer provided for AC voltage adjustment. • One illuminated rocker switch provided for power ON/OFF. • One digital voltmeter used to indicate applied voltage. • One digital timer provided for relay tripping time measurement. • One automatic relay tripping time measurement circuit. • One start/stop push-to on switch provided for time measurement circuit. • One reset switch provided for timer reset.
Three Phase Transmission Line Fault Analysis Trainer
Three phase Transmission line fault Simulation Study Module
Specification
• 3 phase power supply from 3 phase generator • To simulate 3 phase balanced system fault and unsymmetrical faults • Fault study with single line and double line in 3 phase system • Faults : - L-G-Fault - L-L-Fault - L-L-G-Fault - Single Conductor open fault - Double Conductor open fault - Fault through impedance • Theoretical calculations and verification with practical results. • The transmission lines are simulated by high frequency Inductance & resistance for short, medium and long line.
Microcontroller Based Distance Impedance Relay Trainer
It consists of many components i. Transmission line module ii. Voltage and current signal conditioners iii.Distance Relay iv. Multifunction Meters
Reviews
There are no reviews yet.