Description
[contact-form-7 404 "Not Found"]
Demonstration Gear Model System
Description
A series of models to demonstrate different gearing systems.
With transparent slideplates, the gears may easily be seen and where necessary there is an index on the primary and secondary shafts to show the change in the direction of rotation and the relative speed of rotation.
A simple three-speed and reverse-gear system using spur gears.
Reverse gear is obtained by interposing a small lay-shaft mounted pinion between the two main shafts.
Gear selection is by means of a short ball-ended lever.
Related products
Spring Unit of Mechanical Model
Description
For showing potential energy in a wound-up spring and its conversion to electrical energy by driving a dynamo and lighting a lamp. May also be used to wind up a weight on a cord showing the change from potential energy to kinetic and back to potential in the raised weight. The steel shaft carries a clock spring with a free wheel device and winding ratchet, also an aluminium 'V' pulley 56 mm. diameter. One end of the shaft overhangs the base for use as line shaft when winding up a weight. Dimensions 220 x 100 x 100 mm. high Supplied complete with driving belt.
Line Shaft Unit
Description
For showing the conversion from electrical energy via mechanical, to potential energy by winding up a weight on a cord. One end of the 6mm. steel shaft carries an aluminium 'V' pulley 56 mm. diameter, and the other end is fitted with a cord anchoring collar. Supplied complete with driving belt.
Demonstration Dynamo
Description
This model uses the same basic assembly as the motor, but is mounted on a baseplate 230 x 90 mm approx. which also carries a hand-drive pulley 120mm. diameter coupled to the smaller dynamo pulley by a rubber belt to give a step-up ration. Electrical output is via a pair of 4mm sockets. The model may also be used as a motor on a 6-8 V D.C. supply.
Reviews
There are no reviews yet.