Ignition System of a Car

Description

This model uses the same basic assembly as the motor, but is mounted on a baseplate 230 x 90 mm approx. which also carries a hand-drive pulley 120mm. diameter coupled to the smaller dynamo pulley by a rubber belt to give a step-up ration. Electrical output is via a pair of 4mm sockets. The model may also be used as a motor on a 6-8 V D.C. supply.

Description

For use with a large motor/generator and a lamp unit to demonstrate the conversion of electrical energy to kinetic energy and then back again. Comprising an iron flywheel, mounted in cast brackets with bearings. The shaft has an aluminium 'V' pulley for driving with the spring belt supplied.

Description

For the construction of a unit to demonstrate cam action and the effect of different cam profiles cut from card.

Description

The cut section is constructed model is of light and strong metal showing air intake, axial flow, double stage compressor, fuel supply, combustion chamber, turbine rotor, jet thrust, exhaust etc. Complete on base.