Description
Error: Contact form not found.
Three Phase Cyclo Converter
This module is designed for three phase half wave-step down cycloconverter. It consists of 18 Synchronized firing pulses, 18 SCRs, Relevant power supply and circuitry for frequency divisions.
Specification
• Eightin nos. SCR with RC snubber protection is provided for 3phase
• cycloconverter power circuit (each phase consist of 6 SCRs) Rated at 1200V@25Amps.
• Three nos. center tapped inductor (0%.50%, 100%) is provided for power circuit.
• Eightin nos. Isolated gate pulses for SCR power circuit.
• One potentiometer is provided to vary the frequency.
• One potentiometer is provided to vary the output voltage.
• MCB protection.
• Housed in sleek screen printer cabinet.
• Provision for V/F control Power Supply.
• Input 440V ± 10%, 50HZ three phase AC supply.
• ± 15V DC, 9V, 9V, 9V AC (3phase) for the firing circuits.
• 24-0-24V 3phase input for power circuit.
Related products
Single Phase Cyclo Converter
Specification
• Consists of firing circuit, SCR power circuit and load. • Line synchronized IC based linear firing circuit. • Line synchronization achieved by step - down transformer. • Four nos. firing pulse with pulse transformer isolation to trigger four SCR. • One no. potentiometer used to vary the firing angle (180° - 0°). • Carrier logic implemented with carrier frequency of 4KHz. • One no. toggle switch with debounceogic for pulse ON/OFF. • EPROM Based firing pulse frequency variation. • Two nos. toggle switch to select different frequency (Hz, 50/2Hz, 50/3Hz, 50/4Hz). • Power circuit consists of Four nos. SCR with fuse protection. • Anode, Cathode, Gate terminals are terminated in the front panel for user connection. • 24V AC, 1Amp Provided for power circuit input with ON/OFF switch. • One no. fixed R, load provided Center tapped inductor for power circuit. • 230V, 50Hz AC input with ON/OFF rocker switch, fuse for over load.
SCR VI Characteristics Study Trainer
Specification
• Basic VI characteristics study trainer. • Consists of one no. TYN612 SCR with heat sink. • LM723 based 20V DC power supply for gate voltage. • One no. potentiometer used to vary the gate current • 0- 30V DC variable power supply for anode, cathode voltage variation. • One no. potentiometer used to vary the Vak. • One no. high voltage fixed load resistor. • One no. toggle switch to ON/OFF gate voltage. • Two nos. DC ammeter, voltmeter/multimeter provided to measure Ig&Vak, Ia. • 230V AC input. Power ON/OFF switch. • All components are mounted on a screen printed PCB fixed on a nice wooden cabinets.
SCR Characteristics Trainer
Specification
• Basic static characteristics study trainer. • LM723 based variable DC power supply (0-30V) for SCR Vak. • LM723 based variable DC power supply (0-12V) for gate voltage of all devices. • Separate section for SCR/TRIAC characteristics. • Separate section for IGBT/MOSFET characteristics. • Two nos. fixed load resistor for all devices. • Four nos. potentiometer to vary all voltages. • LED indication for all power supply. • Three nos. digital multimeter for measurement of device parameters. • For Diac external power supply to the provided.
Reviews
There are no reviews yet.