Description
[contact-form-7 404 "Not Found"]
Transducer Trainer
Specification
• RTD acts as a temperature sensor
• Strain gauge based load cell
• Linear variable resistive transducer
• LDR, Photo diode, photo transistor
• Precision servo potentiometer
• Inductive type proximity sensor
• Heat source, Filament lamp, Buzzer
• 3½ digit LED display
• Analog type 10V Center-Zero meter
• Inverting and Non-inverting amplifier
• Amplifier with Gain and offset control
• Instrumentation and summing amplifier
• Low pass filter
• Precision Rectifier
• Timer and buzzer oscillator
• Electric switch
Related products
Hall Effect Transducer
Voltage Measurement:
• One Voltage Signal conditioner is provided to interface with ADC • Output Voltage Range: (0-5V) • One Analog meter is provided to indicate the input voltage.Current Measurement:
• One Current Signal conditioner is provided to interface with ADC • Output Voltage Range: (0-5V) • One Analog meter is provided to indicate the input current. • Built-in Power Supply • One Auto Transformer is provided to vary the input voltage and current • 3½ Digit digital indicator
Level Control Measurement Module
This module consists of a process tank with a miniature pump, level sensor for 2 levels, a power supply, etc., To establish a ON/OFF control for the level of water. Circuitry is provided for stand alone operation or through a 8255 port of a Microprocessor kit.
Specification
• A transparent tank of height 150mm with adjustable electrodes to vary the high level and low level. • A pump with tank for water circulation • Water level can be monitored under software control/automatic mode • One power relay 230V/6Amp for pump ON/OFF control • Miniature connectors are provided to operate as stand alone controller or through software under a Microprocessor trainer. • Built in power supply.
Wheatstone Bridge
Specification
• Four arms with one unknown arm to connect the unknown resistance • Two range selection arms provided to select the nearest range of unknown value. • Range of Measurement : 5Ω-100KΩ • Accuracy (Min to Max.) :±0.2 ± 5Ω • Tolerance : ±5% • Digital voltmeter (Range +5V to - 5V) is provided to indicate the Balance conditions • Built-in power supply
Pressure Measurement Trainer
This module consists of a (0-100) psi pressure transducer of strain gauge type fixed in a pressure tank, one manually operated pump to develop pressure, pressure gauge and 3½ digital indicator to display the pressure.
Reviews
There are no reviews yet.