Description
Error: Contact form not found.
Dissolution Rate Test Apparatus
Specification
Consist of thermostatic control water bath which maintains temp. at 37DegC with + 0.5 Deg
C variations.
Provided with borosilicate vessel 1000 ml, variable speed motor, cylindrical wire
mesh basket & shaft with blades of stainess steel.
Single Basket, (Analog)
Single Basket, (Digital R.P.M)
Single Basket, (Digital) Temp. & R.P.M
Related products
Leak Test Apparatus (S.S BODY)
Ideal instrument to check blister Packs, Strip for Leak Test.
The old method of separate desiccator and the huge vacuum pump is replaced with the new Leak Test Apparatus in GMP Stainless Steel Body with phenomenal compactness.
The instrument is equipped with Diaphragm type vacuum pump gives the higher level of vacuum in shortest possible time.
Die pressed polycarbonate vacuum desiccator sustains vacuum for a long time.
A vacuum gauge is provided to indicate vacuum level which is connected to isolation valve to disconnect the source.
Thus avoiding the need of continues running of the vacuum pump.
| Body: | Stainless steel. 304 | |
| Desiccator: | SPolycarbonate, 8” Desicator Provided with Digital Timer | |
| Timer: | S3999 sec. Digital | |
| Vacuum Level: | S 22" Hg | |
| Current: | S 5A | |
| Voltage: | S 230 |
Autoclaves Pressure Steam Sterilizers Economy
Specification
These autoclaves are made of 10 gauge aluminum. The drum is deep drawn & the ring on top is riveted. The lid is made by casting. Locking of lid by 6 nuts with rubber gasket seal in between (not metal to metal seal). Two safety valves, pressure gauge, flexible metal rubbing to exhaust air. Includes outer stand, inner aluminum container, inner tripod stand.| Capacity (Lt.) | Power | Size | |
|---|---|---|---|
| 20 Lt. | Electric | 300 x 300mm = 12” x 12” | |
| 20 Lt. | Non Electric | 300 x 300mm = 12” x 12” | |
| 25 Lt. | Electric | 300 x 380mm = 12” x 15” | |
| 25 Lt. | Non Electric | 300 x 380mm = 12” x 15” | |
| 35 Lt. | Electric | 350 x 380mm = 14"x15" | |
| 35 Lt. | Non Electric | 350 x 380mm = 14"x15" |
Bacteriological Incubator
Specification
Standard Double Wall Fabrication, inner & outer chamber made of thick mild steel sheet. Painted with hammer tone paint finish. The gap between the walls is fitted with special grade glass wool. Provided with two or three removable shelves. Heating elements provided on three sides to attain quick and uniform heating in range of 30°C to 110°C + 1°C controlled by hydraulic type capillary thermostat. An L- Shaped prismatic thermometer is fitted to the unit for reading the chamber temperature. Equipment suitable to be working on 220V AC 50Hz single phase.Optional
Air circulating fan. Timer 0-24 hours.| Chamber Size In mms | Chamber Size | Cap. (App.) |
|---|---|---|
| 300x300x300 | (12"x12"x12") | 28L |
| 350x350x350 | (14"x14"x14") | 45L |
| 400x400x400 | (16"x16"x16") | 65L |
| 450x450x450 | (18"x18"x18") | 95L |
| 600x450x450 | (24"x18"x18") | 125L |
| 600x600x600 | (24"x24"x24") | 224L |
Disintegration Test Unit
Features
Digital timer with 1 second resolution. Accurate time out provided by microprocessor based time totalizer. Baskets move Up & Down as per IP/USP test specifications. Temperature Controlled by sensitive thermostats. Digital Tablet Disintegration Apparatus is designed for accurate estimation of disintegration time of tablets as per IP/USP standards. The instrument is designed to test to batches of six tablets, simultaneously. The unit consists of two beakers having capacity of 1000 cc each. In these beakers, suitable disintegration media can be taken. These can be temperature controlled using a in-built heater and a highly thermostat fitted inside the instrument. Microprocessor based time to talizer is provided for accurate time readout.Specifications
System :Digital Tablet Disintegration Apparatus. Up and Down Speed:30 rpm ± 2 rpm. Accuracy: 2% Resolution:1 sec. Operating Temp. Range:0 - 100°C Power:230V ± 10%, 50Hz.AC
Sieve Shaker (Gyratory Motion)
Ensuring durability during performance, this machine is made of mild steel and cast iron and comes with one Lid and a Pan.
This unit is used with up to 7 sieves of 150mm or 200mm (8 Inch) sieves and up to 6 sieves of 300 mm (12 Inch).
Heavy duty motor (1/4 HP) ensures the whole performance through a reduction gear immersed in oil.
Along with featuring gyratory motion, this units also performs upward and downward movement ensuring that each "square cm" of the sieve is fully utilized.
This Gyratory Sieve Machine also supplied with a pair of rods and a holder which ensures tight grip of sieve set from the top.
| Product: | Gyratory Sieve Shaker | |
| Capacity: | 7 sieves of 150mm, 6 sieves of 300mm | |
| Design: | Table Top | |
| Construction: | Cast Iron, Painted Mild steel | |
| Motor: | ¼ HP | |
| Timer: | 0 - 60 Minutes | |
| Timer Type: | Digital / Analog | |
| Power Supply: | 220 Volts |
Flourimeter (Digital)
A digital photofluorometer, you can perform precise analysis of flurophors and quinine.
Designed specifically for life science laboratories, this smart instrument fulfills your requirements of accurate results with the sensitivity you demand.
This fluorometer is a compact system, which occupies very low bench space, while offering convenient and excellent throughput for fluorescence assays.
It is a fluorometer model has been designed and manufactured for laboratories, where routine analysis of fluorophors is a prime requisite.
This system uses 50 W tungsten halogen lamp,
This digital fluorometer greatly enhances productivity of your laboratory, designed with latest technology, use of imported mechanical and electrical parts, imported lamp and other components; it allows you to perform fluorometric determination of quinine more quickly.
| Covers entire visible range: | Excellent detection sensitivity | |
| Compact and efficient: | Bright red seven segment LED display | |
| Occupies low bench space: | Precise analysis of Flurophors & Quinine |
Specifications
| Fluoro Sensitivity: | Full-scale deflection obtained with 1 ppm quinine sulfate in 0.1 N sulphuric acid (primary wavelength 360 nm) | |
| Display: | 3 digits bright red seven segments LED display | |
| Excitation Source: | 12V, 50W Tungsten Halogen Lamp | |
| Sensitivity Range: | Adjustable in 4 ranges | |
| Detector: | Highly sensitive wide range photodiode/cell | |
| Sample Test Tube Size: | 15 mm (D) x 80 mm (H) | |
| Minimum Sample: | 4 ml | |
| Power: | 230 V ± 10%, 50 Hz. AC | |
| Dimension: | 260 x 335 x 160 mm (Approx.) |
Permeability Cup
(S.S 304) 120mm Dia. Permeability cups for determining the water-vapor transmission of paints, varnishes, coatings, coating systems and related products.
The Permeability cup consists of a cup, seal ring and cover ring.
The seal ring is designed to prevent turning when closing the cover.
The Permeability cup is suitable for testing both self-supporting coating and non-self-supporting coatings. Water-vapor transmission is of interest for high humidity conditions.
The wet cup method is thus the reference method for determining water-vapor transmission, if agreed up on otherwise, other procedures or conditions the dry cup method may be used.
Reviews
There are no reviews yet.