Two Input Nand Gate

This Trainer Consist of : 1. Regulated power supply of ± 12 V / 250 mA. 2. Variable 0 to ±5 V / 250 mA. 3. Sine wave oscillation of 1 KHz. 4. Digital Voltmeter of 0-20 V DC, LCD display, 3 ½ Digit. 5. Functional diagram of IC 741 is printed with 2 mm sockets. 6. One extra 8 pin IC Base with 2 mm sockets. 7. Potentiometer of 10K Ohms. 8. Required Resistance and Capacitances mounted on board. 9. Interconnection Leads and Manual to perform 15 experiments on IC741 e.g. inverting, non-inverting, summing, difference, multiplier, differentiator, integrator etc.

Instrumentation amplifier is a switched gain precision operation amplifier. This is used for precise and accurate, low noise differential signal acquisition. 4mm sockets are used for the input signal. It can be interfaced with a wide range of sensors. It can take small voltage changes from a sensor and make those changes large enough to be measured using CRO. It is not able to drive a low impedance load such as a loudspeaker or relay. The output can be read on CRO. Digital multimeter may also be used to read the output. With switched gain of 5 to 1000, it can handle signal inputs over a very wide range making it suitable for almost all applications.

Mounted on transparent covered base for easy demonstration. Diagram and two sockets are provided for use with some circuit. Thermistor is mounted above the base to avoid the damage from heat.

To study the EX-OR digital logic gate and verification of the truth table.