Coils are wound with highly insulated copper wire impregnated with paraffin wax; input 6-8 V dc through two 4 mm socket terminals, with an adjustable trembler system.
The spark suppression capacitor is housed in the base.
A pair of pointer electrodes with insulated handles for adjustment of the spark gap is provided. Spark length 10 mm
Spark length 25 mm
Spark length 50 mm
Spark length 75 mm
Spark length 100 mm
Wound on rectangular bobbin, for use with 220 – 240 V AC mains with detachable mains connector with moulded plug, A 4 mm socket is provided for earthing.
Generates both AC and DC.
When the two brushes of the generator are put in the two ends of the commutator, the output is an AC.
When the brushes are put in the middle of the commutator, the output is a DC.
Includes Instructions.
This motor-generator set gives students an insight into the physical and technical relationships on which electric motors, generators and transformers are based.
The modular system allows to set up different function models without tools: Various DC motors Series and shunt motor Synchronous motor DC generator and alternator Transformer.
This set allows the performance of 10 student experiments about the following topics:
Magnetic field of a coil
Conversion of electrical energy into kinetic energy
Commutator
Direct current motor
Synchronous motor
Series and shunt-wound motors
Electromagnetic induction
The electrical generator
Engine-generator
Transformer
A solar cell and solar motor mounted on metal base.
Solar cell unit comprises a 30 x 70 mm selenium photo-voltaic cell Low-power motor is designed specifically to run from solar cells Demonstrates conversion of solar energy to electrical energy then to mechanical energy
This setup is designed to investigate the charging and discharging characteristics of typical re-chargeable batter with external voltmeter and ammeter connected, you can manually measure the input and output energy by taking reading from these meters.
A toggle switch is provided to select between charging and discharging.
Connection are made via 4 mm plugs.
To demonstrate Ohms Law.
Consisting of a wooden enclosure with milliammeter, voltmeter, rheostat, push key and terminal posts.
Requires an external battery (not supplied) and a suitable resistance (not supplied).
Resistance can be calculated using Ohm’s Law by noting current and voltage.
A rheostat is provided to control current flow.
Circuit diagram is provided on the panel with instructions.
A plastic box enclosed four electrolytic capacitors.
The series and parallel combination of these capacitors can be used with an external AC source to introduce 90° Phase shift between current and voltage.
Connections are made via 4 mm sockets.
Platinum wire of about 2 ohms resistance, non inductively wound on a mica frame with copper leads, together with a pair of compensatory leads, all being connected to 4 mm socket terminals, for temperatures up to 150 °C.