[contact-form-7 404 "Not Found"]
SCR Characteristics Trainer
Specification
• Basic static characteristics study trainer. • LM723 based variable DC power supply (0-30V) for SCR Vak. • LM723 based variable DC power supply (0-12V) for gate voltage of all devices. • Separate section for SCR/TRIAC characteristics. • Separate section for IGBT/MOSFET characteristics. • Two nos. fixed load resistor for all devices. • Four nos. potentiometer to vary all voltages. • LED indication for all power supply. • Three nos. digital multimeter for measurement of device parameters. • For Diac external power supply to the provided.
SCR VI Characteristics Study Trainer
Specification
• Basic VI characteristics study trainer. • Consists of one no. TYN612 SCR with heat sink. • LM723 based 20V DC power supply for gate voltage. • One no. potentiometer used to vary the gate current • 0- 30V DC variable power supply for anode, cathode voltage variation. • One no. potentiometer used to vary the Vak. • One no. high voltage fixed load resistor. • One no. toggle switch to ON/OFF gate voltage. • Two nos. DC ammeter, voltmeter/multimeter provided to measure Ig&Vak, Ia. • 230V AC input. Power ON/OFF switch. • All components are mounted on a screen printed PCB fixed on a nice wooden cabinets.
Single Phase Bridge Firing Circuit
Specification
• Line synchronized IC based linear firing circuit for SCR applications. • Line synchronization achieved by 230 / 9V step down transformer. • Four nos. firing pulses to trigger four SCRs. • 1:1:1 Pulse transformer used for gate pulse isolation. • One no. potentiometer used to vary the firing angle (180° - 0°). • All four pulses terminated on the front panel for external SCR device module interface. • Carrier logic circuit implemented for SCR self start, carrier frequency 4KHz. • Debounce logic circuit implemented for SCR gate pulse ON/OFF. • One no. toggle switch for gate pulse ON/OFF. • 230V, 5Hz AC input, fuse provided for over load protection. • One no. ON/OFF switch with LED indication for power ON/OFF. • Provision to control the firing angle through external 0 to 5V DC.
Single Phase Cyclo Converter
Specification
• Consists of firing circuit, SCR power circuit and load. • Line synchronized IC based linear firing circuit. • Line synchronization achieved by step - down transformer. • Four nos. firing pulse with pulse transformer isolation to trigger four SCR. • One no. potentiometer used to vary the firing angle (180° - 0°). • Carrier logic implemented with carrier frequency of 4KHz. • One no. toggle switch with debounceogic for pulse ON/OFF. • EPROM Based firing pulse frequency variation. • Two nos. toggle switch to select different frequency (Hz, 50/2Hz, 50/3Hz, 50/4Hz). • Power circuit consists of Four nos. SCR with fuse protection. • Anode, Cathode, Gate terminals are terminated in the front panel for user connection. • 24V AC, 1Amp Provided for power circuit input with ON/OFF switch. • One no. fixed R, load provided Center tapped inductor for power circuit. • 230V, 50Hz AC input with ON/OFF rocker switch, fuse for over load.
Three Phase Cyclo Converter
This module is designed for three phase half wave-step down cycloconverter. It consists of 18 Synchronized firing pulses, 18 SCRs, Relevant power supply and circuitry for frequency divisions.