Two Input Ex-or Gate

This panel is used to demonstrate the number systems such as binary, decimal and hexadecimal numbers. Toggle switches used to activate the displays showing the particular number entered. Input may be entered either as decimal or binary numbers with a toggle switch for mode selection. Decimal numbers are shown on a three digit seven segment LED display. 12 V / 2 A DC adaptor is required to operate it.

Instrumentation amplifier is a switched gain precision operation amplifier. This is used for precise and accurate, low noise differential signal acquisition. 4mm sockets are used for the input signal. It can be interfaced with a wide range of sensors. It can take small voltage changes from a sensor and make those changes large enough to be measured using CRO. It is not able to drive a low impedance load such as a loudspeaker or relay. The output can be read on CRO. Digital multimeter may also be used to read the output. With switched gain of 5 to 1000, it can handle signal inputs over a very wide range making it suitable for almost all applications.

Objective : To study Efficiency and Ripple factor in case of Half wave, Full wave and Bridge rectifier on application of load and filters. Features : Instrument comprises of AC Power Supply, 3 meters to measure Output Voltage, Output Current and ripple factor on electronic AC Voltmeter, 4 PN Junction Diodes, Filter Circuit kit, load Resistances selectable using bandswitch and all important connections points at 4mm Sockets. Optional Acc : Digital AC millivoltmeter.

Solderless Breadboard has 1680 tie points. Provided with 2 Terminal strips and 4 Distribution strips. Built in DC Regulated Power Supply. DC Supply ± 5V/ 1 Amp. 0 to ± 15V DC (Variable), 1 Amp. Built-in Function Generator. . Waveform : Sine, Square and Triangle (with selector switch), Frequency : 1 – 100 Hz Variable Amplitude : Variable up to 10 V, TTL 5V p-p Data Switches (Bounceless) – 8 No. LED Display (buffered) – 10 No. Clock Pulsar – 2 No. Seven Segment Display with Decoder IC 7447 – 2 No. Speaker 2.5” Dia. with sockets – 1 No. BNC Plug with 2 mm Sockets – 2 No. 4 mm socket connected with 2 mm sockets – 2 No. Interconnection leads having 2 mm plugs at one end – 10 No. Interconnection leads having 4 mm plugs at both end – 10 No. 22 SWG Hook Up Wire of 20 cm length – 100 No. Comprehensive User’s Manual – 1 No. Input 220 V, 50 Hz. AC with On/Off indicator.