Two Input Nand Gate

Solderless Breadboard has 1680 tie points. Provided with 2 Terminal strips and 4 Distribution strips. Built in DC Regulated Power Supply. DC Supply ± 5V/ 1 Amp. 0 to ± 15V DC (Variable), 1 Amp. Built-in Function Generator. . Waveform : Sine, Square and Triangle (with selector switch), Frequency : 1 – 100 Hz Variable Amplitude : Variable up to 10 V, TTL 5V p-p Data Switches (Bounceless) – 8 No. LED Display (buffered) – 10 No. Clock Pulsar – 2 No. Seven Segment Display with Decoder IC 7447 – 2 No. Speaker 2.5” Dia. with sockets – 1 No. BNC Plug with 2 mm Sockets – 2 No. 4 mm socket connected with 2 mm sockets – 2 No. Interconnection leads having 2 mm plugs at one end – 10 No. Interconnection leads having 4 mm plugs at both end – 10 No. 22 SWG Hook Up Wire of 20 cm length – 100 No. Comprehensive User’s Manual – 1 No. Input 220 V, 50 Hz. AC with On/Off indicator.

Bridge rectifier is designed with four LED’s internally arranged in bridge pattern fitted inside a plastic moulded case. Two LED’s are red and two LED’s are green. This device is used to demonstrate the functioning of a bridge rectifier, i.e., to convert alternating current (AC) into direct current (DC). Two yellow sockets are used for AC input. Two sockets, one red and one black, are used for DC output. For the easy understanding of the internal circuitry, the circuit diagram is printed on the box.

Instrumentation amplifier is a switched gain precision operation amplifier. This is used for precise and accurate, low noise differential signal acquisition. 4mm sockets are used for the input signal. It can be interfaced with a wide range of sensors. It can take small voltage changes from a sensor and make those changes large enough to be measured using CRO. It is not able to drive a low impedance load such as a loudspeaker or relay. The output can be read on CRO. Digital multimeter may also be used to read the output. With switched gain of 5 to 1000, it can handle signal inputs over a very wide range making it suitable for almost all applications.

Mounted on transparent covered base for easy demonstration. Diagram and two sockets are provided for use with some circuit. Thermistor is mounted above the base to avoid the damage from heat.