XTEMOS ELEMENT
AJAX PRODUCTS TABS
BURETTE STAND
Magnetising & Demagnetising coil
Magnifier, Folding
XTEMOS ELEMENT
AJAX PRODUCTS TABS SIMPLE
TI MSP430 Development Board
ON Chip Features
• CPU - MSP430F1611 • Core - 16 bit RISC Architecture. • Speed - Up to 8 MHZ. • Flash - 48 KB + 256B. • SRAM (on-chip) - 10KB. • 48 GPIO Lines. Two UARTs. • One I2C Module. One SPI Module. • Two 16 bit Timers. • Five Power Saving Mode. • 12 bit ADC with single channel. • 12 bit DAC with two channel.ON Board Features
• Eight Digital Output - LED Interface. • Two Digital Input. • 16 x 2 Character LCD Interface. • 7 Segment Display via I2C Interface. • 10 Base T Ethernet Connectivity. • SD Card Interface Support. • Audio Interface. • Jtag connector is provided for Debugger. • USB to serial interface provided.
Rocks And Minerals Collection
Desert Cooler Trainer
Desert Cooler Trainer works on the principle of evaporative cooling. It is used mostly in the dry hot regions; it consists of a fan which sucks the air from atmosphere through the pads which are used in desert coolers very frequently. The difference in DBT & WBT at inlet and outlet can be measured hence the RH from the charts. Also the amount of water evaporated can be calculated by knowing the water level difference in the reservoir.
SPECIFICATIONS:
1.Fan connected to 1/2 HP motor. 2.Air Cooler Pump to circulate water. 3.DBT & WBT Measuring Thermometer at inlet and outlet. 4.Orifice meter with manometer to measure the air flow. A technical manual accompanies the unit.SERVICES REQUIRED:
1.Floor Area – 1, X 1 m. X 1 -5m. Height. 2.220 V., 15 Amp. , Single Phase Stabilized power supplyXTEMOS ELEMENT
AJAX PRODUCTS TABS ALTERNATIVE
Fashion
4 Stroke 4 Cylinder Diesel Engine
4 Stroke 4 Cylinder Diesel Engine – Motor Driven Actual Cut Section Working Model With Valve Timing Attachment
The engine be sectioned to show the internal constructional details.The working of individual part and accessories like Valves,Pistons,pumps,Crank and Camshaft,etc.will be demonstrated.It is provided with Flyweel and it is mounted on a sturdy iron frame. This actual cut section engine helps the student to understand about the parts and the working of the engine very easily. It is specially made dissectible for demonstration purposes.The actual cut section engine will be supplied with key card & very interesting literature regarding working.
4 Stroke 6 Cylinder Diesel Engine
4 Stroke 6 Cylinder Diesel Engine – Motor Driven Actual Cut Section Working Mode
The engine be sectioned to show the internal constructional details.The working of individual part and accessories like Valves,Pistons,pumps,Crank and Camshaft,etc.will be demonstrated.It is provided with Flyweel and it is mounted on a sturdy iron frame. This actual cut section engine helps the student to understand about the parts and the working of the engine very easily. It is specially made dissectible for demonstration purposes.The actual cut section engine willbe supplied with key card & very interesting literature regarding working.
Coil, High Inductance
XTEMOS ELEMENT
AJAX PRODUCTS TABS ARROWS PAGINATION
Centrifugal Blower Test Rig
The apparatus consists of a spiral casing, which houses an impeller. Impeller is driven by a variable speed D.C. motor. Three, interchangeable impellers, viz. Radial forward and Backward curved vanes are provided with the unit. Digital indicators are provided for speed of impeller. A venture provided measures the discharge. Thus students can evaluate the performance of different impellers at various speeds.
SPECIFICATIONS:
1.Blower – Spiral casing with three interchangeable impellers viz. forward, backward and radial vanes. 2.Drive Motor-1 HP DC motor, 3000 RPM with Dimmer control to vary the speed from 300 to 3000 RPM. 3.Digital Speed indicator for speed measurement. 4.Ventura with water manometer to measure air flow. 5.Water manometer to measure discharge pressure. 6.Discharge pipe with flow control valve. 7.A technical manual accompanies the unit.SERVICES REQUIRED:
1.Floor space of about 2m X 1.5m X 1.5m height. 2.230 V. 5A., 50 Hz, AC Supply.
LCR Resonance Apparatus
Objective : To plot Frequency Vs. Current Characteristics of LCR circuit when connected in series or in parallel.
Features : Instrument comprises of 3 Resistances, 3 Capacitors and 1 Inductance connected inside and connections brought out at Sockets. 2 AC moving coil meters to measure voltage and current.
Optional Acc. : Audio Frequency Function Generator
Magnetic Counters
Perfect for whole classroom demonstion, individual price or Tution center activities set of 48 magnetic counter provides o tactile and visual model of key moth's concept including sorting, patterning. counting and operooons, Also to understand the concept of integers by showing positive and negative counters. Provided with soft magnetic backing, easy to use on magnetic board Measure in 48 mm Diameter thickness 8mm. Set of 48 counters in 2 color.
XTEMOS ELEMENT
AJAX PRODUCTS TABS WITH ICONS
Signal Generator, Digital
This signal generator is a useful test instrument capable of generating multiple waveform and offers excellent waves shape, signal linearity, waveform symmetry and frequency range with selection of sine, triangular and square wave and amplitude variable 10 V peak to peak. 1 Hz to 100 kHz in five decade ranges selected by rotary switch named as frequency multiplier. Sine, triangular and square waveforms selected by push switch with LED indication. Output signal is 0 – 3.5 Vrms (10 V peak to peak) open circuit continuously control with uncalibrated amplitude control knob. Mains rocker switch with indicator Light. Signal Generator is versatile for general laboratory use; output signal is adjustable with the combination of frequency multiplier and set frequency dial with a low level of distortion. Set frequency is displayed on a 4 seven segment display. Output Voltage is continuously variable with selector range 1 V and 10 V.There is two pair of output safety sockets. One for CRO output (experiment for amplification, filter etc.) and another pair of sockets to speaker to drive a speaker and to demonstrate the audio signal frequency range 20 Hz to 20 KHz.
Motor With Solar Cell
RF Telemetry
RF telemetry system consists of a radio frequency transmitter and matching radio frequency receiver both operating at 433 MHz. The system is designed for the radio frequency transmission and reception. The radio frequency transmitter sends out a variable audio signal and the radio frequency receiver with built in loud speaker receives the signal. The system enables the teachers to demonstrate a variety of wave phenomenon. The system also enables the properties of the radio communications to be investigated and compared with those of visible light and other wave motions such as audible sound and water waves etc. For the operation of the system, a 9 V PP3 battery is required.
XTEMOS ELEMENT
AJAX PRODUCTS TABS LOAD MORE PAGINATION
SILICA CRUCIBLE WITHOUT LID
PRODUCT DESCRIPTION
- Crucible is glazed inside and outside.
- Highly resistant to alkalis and hot temperatures
- 50ml capacity
- Outside diameter 55mm, 42mm height
- No lid includedSilica crucible is glazed inside and outside. Highly resistant to alkalis and hot temperature SIZES ARE: 15ML 25ML 50ML 80ML 100ML 150ML
SILICA CRUCIBLE TALL FORM Without Lid, Translucent
XTEMOS ELEMENT
AJAX PRODUCTS TABS CAROUSEL
Laser Reflection and Refraction Tank
Description
Laser Reflection and Refraction Tank demonstrates the principle of reflection and refraction. The clear circular acrylic tank has a circular scale graduated on the white base of the tank, making it easy to measure angles. Adjust the pivot-arm mounted laser to any angle along its full 360° range and measure the angle of reflection or refraction. Rotate the laser and observe first a reflected ray, then both a reflected and refracted ray, and finally just a refracted ray. Leveling screws on the tank’s base make leveling quick and easy. The laser is attached to the pivot-arm by a magnet and can be removed for use in other experiments. Instructions included.
Pipette Pump
fast release Pipette Pump for precise pipetting & zip quick emptying.
The Knurled thumb wheel can be rotated to draw up or dispense liquids while the releaser may be pushed in for zip-quick emptying.
The moulded chuck has silicon rubber coller inside to hold various pipettes of standard sizes.
The Pipette Pump resists acids & alkalis and can be easily disassembled for thorough cleaning.
Material : Acrylonitrile Butadiene Styrene
| Particulars | Pack (Pcs) | |
|---|---|---|
| Pipette Pump 2 ml | 12 | |
| Pipette Pump 10 ml | 12 | |
| Pipette Pump 25 ml | 12 |
Botany Charts
Description
Poly art Charts are multi colored, accurate in details, printed on plastic, laminated on both sides, washable, non-tearable and long lasting, with plastic rollers, size 75 x 100 cm. T.S. in Dicot & Monocot stem Pinus-1 Male & Female Strobli L.S. Shoot Apex & it’s different regions T.S. Shoot Apex & it’s different regions Plant Tissue Cork L.S. in Flower with T.S. in Anther Plant tissue Xylem T.S. in simple Pit Pinus II through female Strobilus L.S. through ovules Plant tissue Collenchyma Marchantia Life Cycle Plant Tissue Parenchyma L.S. in Root Tip & T.S. in its different regions Marchantia T.S. of Root (Secondary Growth) Adiantum Life Cycle Stages of formation of Female Gametophyte with the process of Pollination, Fertilisation & Formation of seed Plant Tissue Phloem Plant Tissue Sclerenchyma T.S. in Stem to show growth with a drawing of Lenticel Adiantum T.S. Dicot & Monocot Root Typical plant cell, English only Plant Mitosis English only Plant Meiosis, English only Classification of Plants, English only
Water Bath Incubator Shaker
Specifications
Similar to other water bath but fitted with inbuilt shaker for differrent experiments demanding shaking at constant speed under controlled temerature conditions. The temprature is controlled by capillary type thermostat from ambient to 100°C. RPM range :- 40-140 with variable electronic speed regulattor workable on 220V AC 50 Hz Single Phase.| Chamber Size In mms (dia x depth) | Capacity (L) | |
|---|---|---|
| 275x275x150 | 12 L | |
| 405x300x150 | 18 L |
Optional (Extra Cost)
Microprocessor PID digital temp. indicator cum contrroller. Digital RPM meter. Auto cut off device when water level is low.
Wide Mouth Reagent Bottle
Our Wide Mouth Reagent Bottle is available in Polypropylene.
The PP Wide Mouth Reagent Bottle, offered by us, are largely demanded for their unique features.
These features include Rigid, Translucent and have Excellent Contact Clarity.
Moreover, our Wide Mouth Reagent Bottle is available at affordable prices.
| Particulars | Pack (Pcs) | |
|---|---|---|
| Reagent Bottle (Wide Mouth) 30 ml | 12 | |
| Reagent Bottle (Wide Mouth) 60 ml | 12 | |
| Reagent Bottle (Wide Mouth) 125 ml | 12 | |
| Reagent Bottle (Wide Mouth) 250 ml | 12 | |
| Reagent Bottle (Wide Mouth) 500 ml | 12 | |
| Reagent Bottle (Wide Mouth) 1000 ml | 6 | |
| Narrow Mouth Bottle 4000 ml | 1 | |
| Wide Mouth Square Bottle 4000 ml | 1 | |
| Heavy Duty Vaccum Bottle 2000 ml | 1 |
L Shaped Spreader
We are a prominent Exporter & Trader of L Shaped Spreader.
The L Shaped Spreader is sterile & smooth and enables even spreading of liquid samples across the surface of a jar plate without grouping & cutting the medium.
Avail the L Shaped Spreader from us at nominal market prices.
Material : Polypropylene
| Particulars | Pack (Pcs) | |
|---|---|---|
| L Shaped Spreader | 100 | |
| Micro Pestle (for 0.5 and 1.5 ml MCT) | 12 | |
| Micro Pestle (for 1.5 ml MCT) | 12 |
