XTEMOS ELEMENT
AJAX PRODUCTS TABS
Arthropoda
| Daphnia WM | Cyclops Male WM |
| Cyclops Female with egg sac WM | Anopheles Male adult WM |
| Anopheles Female adult WM | Anopheles Mouth Parts Male WM |
| Anopheles Larva WM | Anopheles Egg WM |
| Cockroach Mouth Parts WM | Cockroach Malpighian Tubules WM |
| Cockroach Hepatic Caeca WM, TS | Cockroach Ovary TS |
| Cockroach Testis TS | Cockroach Leg WM |
| Cockroach Thoracic Spiracle WM | Cockroach Abdominal Spiracle WM |
| Cockroach Abdominal Spiracle WM | Cockroach Gizzard TS |
| Cockroach Trachea WM | Cockroach Striated Muscles WM, TS |
| Cockroach Wing WM | Cockroach Compound Eye VS |
| Culex Mouth Part Male WM | Culex Mouth Part Female WM |
| Culex Male WM | Culex Female WM |
| Honey Bee Mouth Parts | Honey Bee Leg with Pollen Basket WM |
| Honey Bee Sting Apparatus WM | House Fly Mouth Parts |
| Butter Fly Mouth Parts | Bed Bug WM |
| Bed Bug Mouth Parts WM | Prawn Gill TS |
| Prawn Gill WM | Prawn Statocyst TS |
| Prawn Hastate Plate WM | Prawn Compound Eye V.S. |
| Different Type of Insect Mouth parts WM | Different Type of Antenna WM |
Human Placenta
Needle Steel Handle
XTEMOS ELEMENT
AJAX PRODUCTS TABS SIMPLE
Refrigerant Gas Leak Detector
3Ø – 3Ø Matrix Converter
FEATURES:
• 9 No. Bi-directional Switch with IGBT and Fast Diode Bridge,Rating@1200V 50A Forms 3 Phase to 3 phase Matrix Converter Power Circuit • Output of Matrix Converter Terminated by Banana Connector in the Front Panel • 9 No. High Speed Opto- IC Provided for Gate PWM Isolation. • 9 No. Single Channel IGBT Driver IC with Current Limiting Facility Provided for IGBT Gate Driving. • 9 No. 15V DC Power Supply Provided Internally for Control Circuit. • 3 No. Inductor and AC Capacitor Provided for Three Phase Input Filter. • One No Three Phase Synchronizing Transformer (230/9V) Provided for three Phase Supply Synchronization • 6 nos Hall-effect Current Sensor with Signal Conditioning Circuit Provided for Output and Input Current Measurement and Protection. • AC voltmeter is provided for measure the input AC voltage. • +/- 15V DC Internally Provided for Sensor Signal Conditioner Circuits. • MCB Provided for Input power ON/OFF and OL Protection ON/OFF Switch. • Test points are provided on the front panel to measure the voltage, current and PWM signals • 34 pin FRC Connector Provided for IGBT Gate PWM Inputs. • Input : Three Phase 440V AC, 50 Hz. • Output : Three Phase Variable Voltage, variable frequency • Rating : Suitable for 1 HP 3Ø AC Induction Motor
XTEMOS ELEMENT
AJAX PRODUCTS TABS ALTERNATIVE
Fashion
Water Table Model
Three Step Inductor
Description
This three step inductor consists of a coil of enamelled copper wire wound over an insulated spool. The coil consists of 4 layers of 200 turns each. The tappings at 200, 400 and 800 turns are brought out at 4 mm sockets. The output inductances at these tappings are as follows. No. of turns Resistance 200, Inductor 0.3 mH, Resistance 0.6Ω No. of turns Resistance 400, Inductor 1.2 mH, Resistance 1.2Ω No. of turns Resistance 800, Inductor 5.0 mH, Resistance 2.6Ω. One can easily change the inductor value of the instrument on just inserting a soft iron core inside the bobbin
Sieve Shaker (Hand Operated)
XTEMOS ELEMENT
AJAX PRODUCTS TABS ARROWS PAGINATION
Plate Type Heat Exchanger Apparatus
The unit consists of a plate type heat exchanger, in which cold fluid is cold water and hot fluid is hot water, which is obtained from geyser. The inlet and outer connections of the fluids are positioned so as to make the exchanger counter flow type. Hot and cold fluids pass between alternate plates various measurements provided enables the students to determine heat transfer rate, LMTD, heat transfer coefficients and effectiveness of the heat exchanger.
SPECIFICATIONS:
1.Heat Exchanger- S.S. Plate heat exchanger wiles nos. of 200 X 400mm. 2.Geyser to obtain hot water – 3 KW capacity. 3.Calibrated water flow measuring vessel 4.Thermometers to measure inlet and outlet temperatures of fluid. 5.Flow controls valves. A technical manual accompanies the unit.OPTIONAL ACCESSORIES:
Rotameters to measure water flow rates instead of measuring vessel. Multi channel digital temperature Indicator to measure the temperatures instead of thermometers.SERVICES REQUIRED:
1.Floor space 1.5m. X 1m, 2.230V, 15A, AC supply with earthing connection, 3.Water supply at the rate of about 10 lit/min at constant heat.
CNC Lathe Trainer1
CONTROLLER:
Type of control system: PLC based system Main Spindle Drive : AC Motor with VFD Z and X Drives : Stepper drive with RAMP function Input to Stepper Motor : Optically Isolated Motor Drive :TTL Compatible Run Speed Control : Computer controlled through software Interpolation : Linear / Circular / Parabolic Cycles Used :G,M,S,T,F,I,K,M,F Cycles : Circular Interpolation / Canned Threading : Straight / Taper Power Devices : Short Circuits and over Temperature Protected Real Time Tool Path Simulation : ProvidedMACHINE DETAILS:
Center height : 100mm Swing over Carriage : 80mm Distance between Centre : 250mm Longitudinal Travel : 250mm Weight : 350 kg Dimension in mm : 1100 x 750 x 1700 Rapid Travel : 500mm/min Resolution X & Z Axis : 10micron Dt. Motor Power : 40V – 4A Lubrication : ManualSPINDLE:
Spindle Speed : Continuous Variable Spindle Power : 1.5 HP Inside Taper : MT3 Speed Range : 100 to 3000 RPM
Automatic Knife Sharpener
Description
Portable, precision automatic knife sharpener with timer 0-60 minutes to adjust sharpening time. This equipment can sharpen all microtome knives up to 140 mm in length. Complete with one universal holder, two honing plates, one bottle honing glass compound, one knife inspection block and one re-dressing pad but without micro abrasives.XTEMOS ELEMENT
AJAX PRODUCTS TABS WITH ICONS
Bernoulli S Theorem Apparatus
DESCRIPTION:-
The Set-up is designed to verify Bernoulli’s Theorem experimentally. Set up consists of a one piece clear acrylic test section with convergent and divergent part section, supply tank, measuring tank, inlet water tank and pump for closed loop water circulation. The test section is connected to Piezometer tubes through pressure tapping at different locations on the section to demonstrate the Bernoulli’s Theorem. The flow rate of water is measured using measuring tank and stop watch provided.EXPERIMENTS:-
Ø To verify Bernoulli’s Theorem experimentally.FEATURES:-
Ø Clear test section Ø Closed loop water circulation Ø Compact & stand alone setup Ø Stainless Steel tanks and wetted parts Ø Superb Painted structure Ø Simple to operate & maintainUTILITIES REQUIRED: –
Ø Electricity Supply: Provide 230 +/- 10 VAC, 50 Hz, Single Phase electric supply with proper earthing (Neutral – Earth voltage less than 5 VAC) 5 A, three pin socket with switch for pump Ø Water Supply : Tap water connection ½ “ BSP, Distilled water @ 60 Ltrs. (Optional)TECHNICAL SPECIFICATION: –
Ø Test Section : Material Acrylic, Size Ø Inlet Tank : Capacity 20 Liters., Stainless Steel Ø Supply Tank : Capacity 70 Liters., Stainless Steel Ø Measuring Tank : Capacity 20 Ltrs. Fitted with Piezometer Tube & Scale Ø Piezometer Tubes : Material P.U. Tubes (9 Nos.) Ø Pump : FHP Capacity make Tullu/Crompton Graves Ø Piping : GI / PVC Size BSP Ø Stop Watch : Electronic Ø The whole Set-up is well designed and arranged in a good quality painted Structure.
Calorimeter copper
Human Upper And Lower Jaw without internal wall
Suspension Bridge Apparatus
DESCRIPTION:
Cables are frequently used to support loads over large spans such as cable stayed for suspension bridges, cable car systems and stadium roof. They are used extensively for permanent guys on structures such as microwave towers and derricks. They are also used for temporary guys during erection. The only force in a cable is direct tension. They are too flexible to carry any moment. A cable is used to carry concentrated loads, uniformly distributed load along its length and uniformly distributed load along the horizontal span. It takes the shape of a polygon under concentrated loads, a catenary under uniform load along its length (such as its own weight), and a parabola under uniform load along the horizontal span.EXPERIMENT:
• Study the Extension of each spring Balance Left & Right Both. • Study of the effect of a point loadTECHNICAL SPECIFICATION:
• Apparatus Consists of two mild steel cables 0.5cm diameter in cross section and 150cm long, pinned to two supports 90cm apart situated symmetrically. • One of the ends can be converted to a roller by applying a known load at the end with the help of suspended pulley system. • Vertical loads can be applied at various points along the span of the beam. • A dial gauge with 25mm travel (with a magnetic base) is to be supplied with the apparatus complete with a supporting stand and a set of weights.XTEMOS ELEMENT
AJAX PRODUCTS TABS LOAD MORE PAGINATION
SILICA CRUCIBLE WITHOUT LID
PRODUCT DESCRIPTION
- Crucible is glazed inside and outside.
- Highly resistant to alkalis and hot temperatures
- 50ml capacity
- Outside diameter 55mm, 42mm height
- No lid includedSilica crucible is glazed inside and outside. Highly resistant to alkalis and hot temperature SIZES ARE: 15ML 25ML 50ML 80ML 100ML 150ML
SILICA CRUCIBLE TALL FORM Without Lid, Translucent
XTEMOS ELEMENT
AJAX PRODUCTS TABS CAROUSEL
Leaf Area Meter
Description
Leaf Area Meter We have been affianced in offering an exclusive collection of Leaf Area Meter which is used to obtain measurements of leaf area without detaching the leaf from the plant. The offered meter is manufactured with the use of high grade components and latest tools in order to meet the set industry standards. These are extensively used for conducting various tests and studies on the leaves of a tree.
Bottle Cap Sealing Machine
Specifications
Bottle Cap Sealing Machine which is used by the industries for sealing the cap of the bottles. It is supplied with complete electric fittings accessories. Finds usage in pharmaceutical, chemical and food & beverage industries, the offered range is available in different specifications, in order to meet the variegated expectations of our valuable customer. Our provided Bottle Cap Sealing Machine is tested by the team of our professionals. Furthermore, our clients can avail the entire range from us at market leading prices. (a) Hand operated. (b) Electrical operated.
