XTEMOS ELEMENT
AJAX PRODUCTS TABS
Large Rectangular Transparent Tank
Coelenterata
Monocot Stem Anatomy T.S &L.S
Description
This model exhibits the various tissues and the scattered, closed and collateral vascular bundles in transverse and longitudinal sections in maize. The large pitted vessels, spiral and annular vessels show the cell wall thickenings in L.S. Useful model for teaching anatomy of monocot stem. Mounted on base with keycard.XTEMOS ELEMENT
AJAX PRODUCTS TABS SIMPLE
Oxygen And Carbon Cycle In Nature
ANALYTICAL BALANCE
DESCRIPTION
- Student Physical Balances with flat beam.
- Chemical Balances with Flat beam and rider using facility.
- Chainomatic Analytical Balances with external alteration of weights up to 100 mg.
- Analytical Balances with Triangular beam with rider using facility / Flat beam with vernier scale.
- Capacity 1mg to 100gms
- Capacity 1mg to 200gms
- IDDC Certified & Tested, 100gm
- Capacity 1mg to 500gm
- 1gm
- 2gm
- 5gm
- 10gm
- 20gm
- 50gm
- 100gm
- 200gm
francis turbine test setup
DESCRIPTION:
Francis Turbine is a reaction Turbine, which was developed by English born American Engineer Sir J.B. Francis. The water enters the turbine through the outer periphery of the runner in the radial direction and leaves the runner in axial direction and hence it is called a mixed flow turbine. As the water flows to the runner, a part of pressure energy goes on changing into kinetic energy. Thus the water through the runner is under pressure. The runner is completely enclosed in an air tight casing and the casing & runner is always full of water. The present Set-up consists of a runner. The water is fed to the turbine by Means of centrifugal Pump, radially to the runner. The runner is directly mounted on one end of a central SS shaft and other end is connected to a brake arrangement. The circular window of the turbine casing is provided with a transparent. The circular window of the turbine casing is provided with a transparent acrylic sheet for observation of flow on to the runner. The runner assembly is supported by thick cast iron pedestal. Load is applied to the turbine with the help of brake arrangement so that the efficiency of the turbine can be calculated. A draught tube is fitted on the outlet of the turbine. The Set-up is complete with guide mechanism. Pressure and vacuum Gauge are fitted at the Inlet and Outlet of the turbine to measure the total supply head on the turbine.UTILITIES REQUIRED:
● Water Supply and Drain.● Electricity 15 kW, 440V Ac, Three Phase
TECHNICAL SPECIFICATIONS:
| MODEL | HM 101 (1.33 HP) | HM 101 (2 HP) | HM 101 (5 HP) |
| Output Power | 1.33 HP / 1 Kw | 2 HP / 1 Kw | 5 HP / 3.75 Kw |
| Discharge | 1000 LPM (Approx.) | 1000 LPM (Approx.) | 2000 LPM (Approx.) |
| Supply Head | 10 m | 10 m | 15 m |
| Rope Brake Dynamometer | Dia 200 mm | Dia 200 mm | Dia 300 mm |
| Sump Tank | Capacity 300 Ltrs. | Capacity 300 Ltrs. | Capacity 600 Ltrs. |
| Water Circulation Centrifugal Pump | Capacity 5 HP, Three Phase | Capacity 5 HP, Three Phase | Capacity 15 HP, Three Phase |
| Speed | 1500 RPM (approx.) | ||
| Runner | Having Curved Vanes | ||
| Discharge Measurement | Pitot Tube with Manometer | ||
| Control Panel | Star/Delta Starter, Mains Indicator, MCB for overload protection | ||
| The whole set-up is well designed and arranged in a good quality painted structure. | |||
XTEMOS ELEMENT
AJAX PRODUCTS TABS ALTERNATIVE
Fashion
Lab Tubing Connectors
We are engaged in providing high quality range of Lab Tubing Connectors.
These Lab Tubing Connectors are sourced from highly reliable manufacturers who ensure the usage of high grade components for its manufacturing.
Our clients have always appreciated our range of Lab Tubing Connectors for its supreme quality and durability.
our Lab Tubing Connectors comes in a wide range which includes Cross Connector , Y Shaped Connector , L Shaped Connector and T Shaped Connector.
| Particulars | Pack (Pcs) | |
|---|---|---|
| T-Connector 6 mm | 36 | |
| Y-Connector 6 mm | 36 | |
| T-Connector 8 mm | 36 | |
| Y-Connector 8 mm | 36 | |
| T-Connector 10 mm | 36 | |
| Y-Connector 10 mm | 36 | |
| Cross Connector-6 mm | 36 | |
| Cross Connector-8 mm | 36 | |
| Cross Connector-10 mm | 36 | |
| L Connector-6 mm | 36 | |
| L Connector-8 mm | 36 | |
| L Connector-10 mm | 36 | |
| Pinch Clip | 12 |
Digital Kymograph
Digital Kymograph has gained immense recognition in exporting and supplying quality assured array of Digital Kymograph Consists of a revolving drum that is wrapped with a sheet of paper and this kymograph is used to measure atmospheric pressure, the functioning of steam engines and tuning fork vibrations. Offered kymograph is made in complete compliance with predefined industry norms at our well-equipped unit. Furthermore, this Digital Kymograph is extensively appreciated and demanded in the market due to its rugged design and excellent performance.
Features
Excellent performance. Power efficient. Easy operation. Result accuracy.Specification
Digital Speed Selection. Spirit Level: For adjusting level. Auto Stop after One Complete Cycle. 16 x 2 LCD Digital Display with Back Light simultaneous display of all functions on the display and selection through display. Highly Accurate Speed : E/C System Speeds available -0.12.,0.25,0,.50,0.75,1.00,1.25,mm/Sec With Accurance of +/-0.01%. Timer With Alarm Time Multiplier (o-10 min in multiple of 30 sec.) for indicating washing Cycle Drug Injection times etc. Very Low Power Consumption (12 volts 1 Amp.). Operated with Stepper Motor which is highly accurate and run by Microprocessor based program. Battery Back Up (Optional): Auto Conversion to Battery Mode in Case of Electricity Failure. Back up 1 to 4 hours. Special Chrome Plated and Powder Coated Body: Extremely Resistant to Corrosion and Leak Proof Design. Self Lubrication Gear. And More Feature Available.
XTEMOS ELEMENT
AJAX PRODUCTS TABS ARROWS PAGINATION
Car Chassis All Wheel Drive Actual Cut Section
Car Chassis Rear Wheel Drive Actual Cut Section – Motorised
4 Stroke 4 Cylinder Petrol Engine With Clutch, Gear Box, Propeller Shaft, & Rear Axle Assembly With Differential Gear
The chassis of the four stroke four cylinder engine cut section model. The cut section model is constructed such that all the following systems can be demonstrated in working conditions.
ENGINE:
Maximum parts and accessories of an engine like cylinders, cylinder head, inlet and Exhaust manifolds, FIP, injectors, self-starter, alternator, water pump, radiator, etc., are sectioned to show the internal constructional details. The complete sectioned model is coupled with FHP 220/230V A.C single phase motor through a Reduction drive unit.TRANSMISSION SYSTEM:
This system consists of a Clutch and four speed gearbox assembly, the casing of which is suitably cut to demonstrate its operation. The gearbox is coupled to Differential gear box with propeller shaft and the different coupling used for this transmission can be demonstrated. The Differential gear box is also cut so as to clearly to demonstrate its complete operating principle. The gear shifting including the forward and reverse gear operation can be clearly shown. The speed variation and the rotation of the Differential gear box can be seen while gear shifting. By running the motor connected to the engine assembly the entire system with gear box, rear axle etc. can be demonstrated in running. FUEL SYSTEM: The Fuel tank is cut to expose the mounting of the level sensor and the position of Fuel section. The system is complete with mechanical Fuel pump. EXHAUST SYSTEM: It consists of Exhaust Manifold and silencer in cut section to explain internal construction. LUBRICATION SYSTEM: It consists of the engine Lubrication system along with the Lubrication oil pump is suitably sectioned. SUSPENSION SYSTEM: This will explain both the Hydraulic Suspension systems at the front and the leaf spring Suspension at the Rear. One of the hydraulic arrangements of Suspension mechanism is highlighted (with shock absorbers) and explained cut sectionally.BRAKING SYSTEM:
The Hydraulic or Air circuit Brakes. The movement of the Brake Shoes on operating the brake pedals can be seen in the area where the Brake drum is cut. The front and rear brakes will be operational. STEERING MECHANISM: The can be seen and included in the Steering wheel. Steering gear box and coupling of the same to the wheels will be shown by rotating the steering wheel, the operation of the steering system can be demonstrated. The entire system will be mounted on the chassis, and suitable mounting option with caster wheels will be provided for easy movability.
Discrete Component Trainer
Trainer consisting of Power Supply of +5 V / ±12 V (each of 250 mA), Silicon, Germanium diodes, Zeners, PNP and NPN Transistors, FET, One speaker, 12 different values of carbon film resistances of ¼ W, ½ W and 1 W. 12 assorted values of capacitors from 100 pF to 1000 ?F, Integrated Circuit (IC) Base and IC 74LS00 1 No. each. LED, LDR, Photo diode, Solar Cell Logic Switches (4 No.) and LED Indicators (4 No.) etc., 2 mm Interconnection Leads -10 No. and Comprehensive User’s Manual
Aluminium Tripod Stand Dual Lock
Description
We are supply and Export of aluminum tripod stands that are procured from the trustworthy sources, who make these using high quality raw material such as brass and aluminum. These products are also available in a powder coated finish and are especially developed for providing maximum stability and strength. Moreover, all our products are available in various sizes, shapes and designs to fulfill the diverse needs of our clients.XTEMOS ELEMENT
AJAX PRODUCTS TABS WITH ICONS
Mammals
Description
All Charts are made on PVC rexine, hand drawn, waterproof, in fast multi colors with a black background. Each chart is provided with rollers to hang on wal, Size 75×100 cm. Rat External Development Rat General Anatomy Rat Digestive system Rat Male Reproductive system Rat Female Reproductive system Rat Arterial system Rat Venous system Rat Nervous system Rat Respiratory system Rat Skeleton Rat Brain, different views Rat Heart, different views Rabbit External Development Rabbit General Anatomy Rabbit Digestive system Rabbit Male Reproductive system Rabbit Female Reproductive system Rabbit Arterial system Rabbit Venous system Rabbit Nervous system Rabbit Respiratory system Rabbit Skeleton Rabbit Brain, different views Rabbit Heart, different views
Open Pit Mine Model
Description
Open pit mining often results in a large hole or pit being formed in the process of extracting a mineral. Deposits mined by open pit techniques are generally divided into horizontal layers called benches. The thickness of the benches depends on the type of deposit & the mineral being mined. Mining is generally conducted on a number of levels at any one time.
Atomic Model Set
We present to you, Atomic Model Set.
The Atomic Model Set consists of moulded balls of different colors & sizes along with connectors of different sizes.
The sizes & shapes of the balls & connecting lugs have been designed in accordance with internationally acceptable standards.
Material : Polystyrene
| Particulars | Pack (Pcs) | |
|---|---|---|
| Atomic Model Set - Senior Set | 1 | |
| Atomic Model Set - Junior Set | 1 | |
| Atomic Model Set (Euro Design) - Student Set | 1 | |
| Atomic Model Set (Euro Design) - Teacher Set | 1 |
XTEMOS ELEMENT
AJAX PRODUCTS TABS LOAD MORE PAGINATION
SILICA CRUCIBLE WITHOUT LID
PRODUCT DESCRIPTION
- Crucible is glazed inside and outside.
- Highly resistant to alkalis and hot temperatures
- 50ml capacity
- Outside diameter 55mm, 42mm height
- No lid includedSilica crucible is glazed inside and outside. Highly resistant to alkalis and hot temperature SIZES ARE: 15ML 25ML 50ML 80ML 100ML 150ML
SILICA CRUCIBLE TALL FORM Without Lid, Translucent
XTEMOS ELEMENT
AJAX PRODUCTS TABS CAROUSEL
Digital Bomb Calorimeter
DIGITAL BOMB CALORIMETER
Bomb Calorimeter outfit provides a simple and inexpensive method for determination of heat of combustion of organic matter and the calorific value and sulphur content of solid and liquid fuel. The outfit supplied is complete for analysis as per the method recommended by British Standard Institution BS 1016. All parts of the outfit have been finished of petroleum and British Standard Institute.SUPPLIED WITH
Calorimeter Vessel with bomb support, Water jacket, Combined Lid for calorimeter vessel and water jacket, Stirrer, Connecting Leads, Connecting tube to connect bomb & pressure gauge, Connecting tube with fine adjustment valve, to connect pressure gauge, pressure gauge on stand, Spanner for oxygen tube connection, Ignition Wire, (2 meters) Nichrome, Cotton Real, stand for bomb lid, Hook for lifting bomb, stainless steel Crucible, Gelatine capsules, Gas release valve, Bomb firing unit, Vibrator, Timer, Benzonic acids. ‘O’ Ring Big, ‘O’ Ring Small, ‘O’ Ring for Stirrer Valve for Bomb, Valve Kay. Complete with Instruction manual.
Bryophyta, Pteridophyta
Description
All Charts are made on PVC rexine, hand drawn, waterproof, in fast multi colors with a black background. Each chart is provided with rollers to hang on wall, Size 75×100 cm. Riccia structure & reproduction Marchantia structure & Life History Anthoceros structure & reproduction Moss (Funaria) life history Selaginella structure & reproduction Psilotum structure & life history Marselia structure & reproduction Lycopodium structure & life history Equistem structure & reproduction Fern (Aspidium) structure & life history Fern (Pteris) structure & life history Fern (Nephrolapis) structure & life history
Curved Member Apparatus
Apparatus consists of a steel bar which is used to make the different curved members Viz. circle, semicircle with straight arm, a quadrant of a circle and quadrant of a circle with straight arm. The bottom ends of the members are fixed to the base. Under the application of load at free end, its horizontal and vertical deflection can be measured with the help of dial gauges. A dial gauge with 25mm travel (with a magnetic base) is supplied with the apparatus. Apparatus to be supplied should be complete with a supporting stand and a set of weights.
Experimental Capabilities: Apparatus is supplied complete with a supporting stand and a set of weights.
