XTEMOS ELEMENT
AJAX PRODUCTS TABS
Rheostat, Single Tube
Description
A layer of oxidized resistance wire is wound on a porcelain tube which is supported by end supports. A sliding contact and three 4 mm socket terminals are provided for use as a rheostat or as a potentiometer. Other ranges also available on request.| Ohms | Ampere | Tube length | |
|---|---|---|---|
| 23 | 2.3 | 150mm | |
| 10 | 3.3 | 150mm | |
| 22 | 2.8 | 200mm | |
| 24 | 3.3 | 250mm | |
| 28 | 4.2 | 400mm |
Rat & Mosquito Cage
Description
Made of aluminium angle framework supported on wooden batons. Provided with fine wire mesh on sides. Wide wire mesh partition in the centre to facilitate mosquitoes pass into other portion. On one side a round opening with black cloth sleeve and on other side a sliding window with drop closure provided in centre. Size 45x30x30cm.
XTEMOS ELEMENT
AJAX PRODUCTS TABS SIMPLE
Spring Unit of Mechanical Model
Description
For showing potential energy in a wound-up spring and its conversion to electrical energy by driving a dynamo and lighting a lamp. May also be used to wind up a weight on a cord showing the change from potential energy to kinetic and back to potential in the raised weight. The steel shaft carries a clock spring with a free wheel device and winding ratchet, also an aluminium 'V' pulley 56 mm. diameter. One end of the shaft overhangs the base for use as line shaft when winding up a weight. Dimensions 220 x 100 x 100 mm. high Supplied complete with driving belt.
Plantation Pots
Plantation Pots, moulded in polypropylene, are available in four different sizes.
The Plantation Pots have a downward extended rim, which provide convenient lifting even if the pot is filled.
The bottom of the pot is provided with holes for drain purpose.
Material : Polypropylene
| Particulars | Pack (Pcs) | |
|---|---|---|
| Plantation Pots 100 mm | 20 | |
| Plantation Pots 150 mm | 20 | |
| Plantation Pots 200 mm | 20 | |
| Plantation Pots 250 mm | 20 |
Transfer Case Assembly Actual Cut Section
Transfer Case Assembly – Actual Cut Section
The working of transfer case is shown with the help of actual parts assembled on square iron pipe frame. All the necessary parts of transfer case are shown in actual working form. This model helps the student to understand the working of the transfer case very easily. It is specially made dissectible for demonstration purposes.
XTEMOS ELEMENT
AJAX PRODUCTS TABS ALTERNATIVE
Fashion
Allihn Condensers (Bulb Condenser)
Human Physiology Charts
Description
Poly art Charts are multi colored, accurate in details, printed on plastic, laminated on both sides, washable, non-tearable and long lasting with plastic rollers, size 75 x 100 cm. Skeletal System Muscular system Circulatory system Nervous system Digestive system Teeth & skin Human eye, ear & head Lymphatic system Respiratory system Endocrine system Nutrition Immune system Human Nose Human Heart Excretory system Human Eye Human Ear Human Kidney Human Lungs Human Liver
Angel Sum Property of Triangle
XTEMOS ELEMENT
AJAX PRODUCTS TABS ARROWS PAGINATION
Gas Tap, Regular
Description
Made of brass with superior black powder coating. Regular construction having lever handle with locking arrangement to ensure lever rotation does not go beyond 90°. Output nozzle having 4mm bore. Inlet 3/8 X 26. Flange diameter 50mm with two holes to fix on bench or any other surface with screws. Provided with adapter (6/8, 3.8mm bore) and corresponding nut (8mm bore). Designed to operate at pressure up to 2 psi (0. 14kg/cm2). Suitable for use with coal gas, natural gas and L.P.G.Particulars
Gas Tap, One Way Gas Tap, Two Way Gas Tap, Three Way Gas Tap, Four Way
Mammal
ZigBee Debugger/Dongle
Brush, Pipette
XTEMOS ELEMENT
AJAX PRODUCTS TABS WITH ICONS
Plant Mitosis
Lagged Pipe Apparatus
Lagged Pipe Apparatus:
The apparatus consists of three concentric pipes mounted on suitable stand. The space between innermost and the middle pipe is fifed with a lagging material and the space between the middle and the outer most is filled with and other lagging material. The lagged pipe is heated with a cartridge heater inserted at the axle length of the pipe. Voltmeter and ammeter on the panel can measure the input to the heater. The intermediate temperatures can be measured by the thermocouples attached at the surfaces of the pipe. Thus the resultant conductivity of the materials can be found out.
SPECIFICATIONS:
1.Pipes : a)Gl pipe (innermost) – 6 cm. (Outer Diameter). b) Gl Pipe (Middle) – 8.5 cm. (Mean Diameter) c)G! Pipe (Outermost) – 10.7 cm. (inner Diameter) d)Length of pipes 1 Meter. 2.Heater : Nichrome wire cartridge heater placed centrally, of suitable capacity. 3.Control Panel : a)Single Phase Dimmerstat – 1 No. b)Voltmeter (0 – 250V) – 1 No. c)Ammeter (0- 2A) – 1 No. 4.Temperature Indicator : Multichannel Digital Temperature Indicator ranging (0 – 300 C) using Cr/AI ThermocouplesServices Required:
1. A.C. Single Phase 230 V electric supply 2. Floor Area-1.5 Meter X 1 Meter X 0.5 Meter High
Autoclaves / Pressure Steam Sterilizers Superior
Specification
Superior quality & finish. All these autoclaves are made of 8 gauge aluminum. The drum is deep drawn. The lid is die casted. Locking of lid by 6 nuts with rubber gasket seal in between (no metal to metal seal). Two safety valves, pressure gauge, flexible metal tubing to exhaust air. Includes outer stand, inner tripod stand.Features
Equipped with two stages "over pressure" protection system incorporating a calibrated continuous bleeding Pressure stopcock and pressure release weight valve.Pressure Gauge
Colour coded pressure gauge showing internal chamber conditions during the cycle. Sterilization zone in green colour is shown from 15 psi to 20 psi (or 1.034 bar to 1.378 bar) which is equivalent to temperature of 121°c to 127°c. Dial size : 2.5". Dial show measurement in 2 units. (i) kg/cm2 (ii) lb/inch2 Full scale dial of pressure gauge is 0-30 lb/ inch2 or 0-2 kg/cm2 Caution zone in red colour. Equipped with steam release /control valve and flexible metal exhaust tube.| Capacity (Lt.) | Power | Size | Type |
|---|---|---|---|
| 21 Ltr | Electric | 300 x 300mm = 12” x 12” | Mirror Finish |
| 21 Ltr | Non Electric | 300 x 300mm = 12” x 12” | Mirror Finish |
| 27 Ltr | Electric | 300 x 380mm = 12” x 15” | Mirror Finish |
| 27 Ltr | Non Electric | 300 x 380mm = 12” x 15” | Mirror Finish |
| 37 Ltr | Electric | 350 x 380mm = 14"x15" | Mirror Finish |
| 37 Ltr | Non Electric | 350 x 380mm = 14"x15" | Mirror Finish |
XTEMOS ELEMENT
AJAX PRODUCTS TABS LOAD MORE PAGINATION
SILICA CRUCIBLE WITHOUT LID
PRODUCT DESCRIPTION
- Crucible is glazed inside and outside.
- Highly resistant to alkalis and hot temperatures
- 50ml capacity
- Outside diameter 55mm, 42mm height
- No lid includedSilica crucible is glazed inside and outside. Highly resistant to alkalis and hot temperature SIZES ARE: 15ML 25ML 50ML 80ML 100ML 150ML
SILICA CRUCIBLE TALL FORM Without Lid, Translucent
XTEMOS ELEMENT
AJAX PRODUCTS TABS CAROUSEL
Narrow Mouth Reagent Bottle
We are the well known Exporter and Trader of Narrow Mouth Reagent Bottle.
Our Narrow Mouth Reagent Bottle are available in Polypropylene.
The PP Narrow Mouth Reagent Bottle is Rigid, Translucent and have an Excellent Contact Clarity.
The Narrow Mouth Reagent Bottle can be autoclaved filled as well as empty.
The Polypropylene Cap has a built in seal ring to make the Narrow Mouth Reagent Bottle Leak Proof.
| Particulars | Pack (Pcs) | |
|---|---|---|
| Reagent Bottle (Narrow Mouth) 4 ml | 100 | |
| Reagent Bottle (Narrow Mouth) 8 ml | 100 | |
| Reagent Bottle (Narrow Mouth) 15 ml | 100 | |
| Reagent Bottle (Narrow Mouth) 30 ml | 12 | |
| Reagent Bottle (Narrow Mouth) 60 ml | 12 | |
| Reagent Bottle (Narrow Mouth) 125 ml | 12 | |
| Reagent Bottle (Narrow Mouth) 250 ml | 12 | |
| Reagent Bottle (Narrow Mouth) 500 ml | 12 | |
| Reagent Bottle (Narrow Mouth) 1000 ml | 6 |
Cyclone IV FPGA Controller
FEATURES:
• Based on Altera family Cyclone IV, Device : EP4CE30 • One 34 pin header used for IPM Interface. - 16 PWM output - 8 capture inputs. • One 26 pin header ADC. - 4 channel 1MSPS ADC. - Total 8 channel using 2 Nos of ADC. - 12 bit resolution. - Input range -10V to 10V / -5V to 5V. • One 5 pin phoenix connector DAC - 4 channel DAC, 12 bit resolution. - Output range -10V to 10V / -5V to 5V. • 8 output Light Emitting Diodes (LEDs). • 8 input slide Switches. • 4 user push button switches. • 2-user limit switch. • 20 x 4 Alphanumeric LCD display. • On Board Isolated JTAG Programmer Compatible with QuartusII software. • Isolated USB (USB to Serial) interface. • 3 Nos of 20 pin header each have 16 IOs.
Force Table
To verify the law of composition and resolution of forces consisting of a aluminium table 40cm in dia.
its raised rim has a engine divided scale, graduated in 360° mounted on heavy vertical support rod & tripod base provided with leveling screws.
Body under study in a ring in center of the table fastened by cords passing over four pulleys attached with the table.
Complete with four pulleys, four weights hangers twelve weights (2x10gm, 2x20gm, 4x50gm, 4x100 gm.)
Dissolution Rate Test Apparatus
Description
Dissolution rate test apparatus is designed to carry out simultaneously SIX TESTS of dissolution rate of tablets & capsules as per USP standards. Dissolution Rate Test Apparatus consists of water bath made of transparent acrylic fitted with an inbuilt water circulation system. Machine has a DUAL TEMP. SENSOR system which controls both water bath temperature within +/- 0.1º C & senses the temperature of jars. The motor is digitally controlled to give speed between 20 to 160 RPM precisely within +/- 1 RPM. The micro-processor also have digital timer to control test timings from 00:01 to 99:59 (HH:MM). The machine is fitted with a LCD Display which keeps the user updated about the RPM, TIME & TEMPERATURE all the time. The unbreakable jars prevent accidents related to breakage & spilling of media in the lab. The jars have acrylic lids which allow passing of stirring shaft. The shafts are suspended from the top & are operated by the motor. Stirrer Assembly can be lifted with auto lifting mechanism for easy operations.Specifications
| Speed: | Variable from 20 to 160 with accuracy of +/- 1 RPM. | |
| Temperature | 30º C to 80º C (+/- 0.5º C) | |
| Timer | 00:01 to 99:59 Hrs. with alarm. | |
| Display | 20 x 4 LCD Display | |
| Bath | Made up of 8 mm thick clear acrylic (10mm Optional) | |
| Heater | 1000 Watts Stainless Steel | |
| Sensor | Dual Sensor System (PT-100) | |
| Auto Lifting Assembly | Available | |
| Jars | Unbreakable Ploycarbonate clear jars (6 Nos.) | |
| Power | 220 / 230V AC, 50 Hz |
