XTEMOS ELEMENT
AJAX PRODUCTS TABS
Porcelain Crucible Lid
Continuously Variable Transmission
Continuously Variable Transmission – Actual Cut Section
The working of CVT is shown with the help of actual parts assembled on square iron pipe frame. The CVT is driven through permanent magnet D.C. motor with variable speed control drive. RPM Sensor With Digital Display Is Also Provided. All the necessary parts of CVT are shown in actual working form. This model helps the student to understand the working of the CVT very easily. It is specially made dissectible for demonstration purposes.
Induction Coil, Ruhmkorff
Description
Coils are wound with highly insulated copper wire impregnated with paraffin wax; input 6-8 V dc through two 4 mm socket terminals, with an adjustable trembler system. The spark suppression capacitor is housed in the base. A pair of pointer electrodes with insulated handles for adjustment of the spark gap is provided. Spark length 10 mm Spark length 25 mm Spark length 50 mm Spark length 75 mm Spark length 100 mmXTEMOS ELEMENT
AJAX PRODUCTS TABS SIMPLE
Bell Jar and Vacuum Pump Set
Description :- Simple, innovative kit allows you to perform a number of experiments on vacuum and air pressure.
The kit clearly demonstrates the method by which a pump works.
Also illustrates that air has mass and helps find its mass and density.
Explain the effect of surrounding air pressure on a sealed balloon.
The balloon will expand when the surrounding air is removed.
And also demonstrate that liquid boils at reduced temperature when the surrounding air pressure is reduced with instructions.
Three Phase Cyclo Converter
This module is designed for three phase half wave-step down cycloconverter. It consists of 18 Synchronized firing pulses, 18 SCRs, Relevant power supply and circuitry for frequency divisions.
Specification
• Eightin nos. SCR with RC snubber protection is provided for 3phase • cycloconverter power circuit (each phase consist of 6 SCRs) Rated at 1200V@25Amps. • Three nos. center tapped inductor (0%.50%, 100%) is provided for power circuit. • Eightin nos. Isolated gate pulses for SCR power circuit. • One potentiometer is provided to vary the frequency. • One potentiometer is provided to vary the output voltage. • MCB protection. • Housed in sleek screen printer cabinet. • Provision for V/F control Power Supply. • Input 440V ± 10%, 50HZ three phase AC supply. • ± 15V DC, 9V, 9V, 9V AC (3phase) for the firing circuits. • 24-0-24V 3phase input for power circuit.
XTEMOS ELEMENT
AJAX PRODUCTS TABS ALTERNATIVE
Fashion
Centrifugal Pump Test Rig
Centrifugal Pump Test Rig
Closed Circuit Type With S.S. Tanks, ISI Mark Pumps & Motors, Powder coated The closed circuit test rig consists of a “kirloskar make” monoblock centrifugal pump. The pump is provided with a vacuum gauge on suction pipe and a pressure gauge on discharge pipe. The gate valve is used to adjust the head on the pump. The discharge is measured by measuring tank / water flow meter. The input power is measured by energy meter.
Specifications:
l. Centrifugal monoblock- 1 h.p. 2. Pressure gauge and vacuum gauge for measuring the head. 3. Measuring tank of 400×400 x400 mm OR Water flow energy meter for measuring the discharge. 4. Stop watch. 5. Sump tank of sufficient capacity. 6. Energymeter to measure input power. 7. A technical manual accompanies the equipment.Features:
1. The equipment is coated with an attractive and anticorrosive powder coating. 2. The equipment consists of ISI standard (i) Monoblock ————————- Kirloskar make (ii) Energymeter ————————- Maxwell Jaipur make (iii) Water flow meter ————————- Kranti/Anand make.Services required :
(i) 440 v, 15 A, stabilized three phase A.C. supply. (ii) Floor area-2 mx2mxl.5m height (iii) Tachometer for speed measurement (can be supplied at extra cost)
Histology (Shark)
TDS Meter
XTEMOS ELEMENT
AJAX PRODUCTS TABS ARROWS PAGINATION
BOD Incubator
Specification
BOD Incubator is designed for low temperature incubation and determination of Bio Chemical Oxygen Demand (B.O.D). The BOD Incubator comes with a double wall construction. The Inner chamber is made of richly anodized aluminum or highly polished stainless steel with two / three removable perforated shelves. The exterior chamber of the BOD Incubator is made of thick mild steel sheet duly finished in enamel paint. Outer double wall door is provided with magnetic gasket and lock & key arrangement. The inner door is made out of clear acrylic sheet allowing inspection of material in the chamber without disturbing the chamber temperature. Door operated inner illumination has been provided. The gap between walls of equipment are filled with glass wool for temperature insulation. The cabinet is mounted on castors. The temperature in the BOD Incubator is controlled by a sensitive thermostat from 5oC to 50oC ± 1oC. For lower temperature working, a standard cooling unit with sealed compressor with protective devices has been provided below the chamber for safe and efficient working. Heating arrangement has made within the chamber for higher temperature. Inner air circulating system is provided to achieve uniform temperature in the whole chamber.| Inner Chamber Size | Cap. | Material |
|---|---|---|
| 455 x 410 x 610 mm | 4cu. Ft. or 112 Ltr. | Aluminium |
| 455 x 410 x 610 mm | 4cu. Ft. or 112 Ltr. | S.S. |
| 505 x 451 x 830 mm | 6cu. Ft. or 171 Ltr. | Aluminium |
| 505 x 451 x 830 mm | 6cu. Ft. or 171 Ltr. | S.S. |
| 565 x 565 x 865 mm | 10cu. Ft. or 280 Ltr. | Aluminium |
| 565 x 565 x 865 mm | 10cu. Ft. or 280 Ltr. | S.S. |
Optional
Timer 0-24 hours day night cycle. Internal illumination with 3 fluorescent tubes. Digital temp. Indicator-cum-Controller.
Music Tuning Fork Set
Bar & Gauge
XTEMOS ELEMENT
AJAX PRODUCTS TABS WITH ICONS
TDM-PAM Modulation and Demodulation
FEATURES:
• Crystal based clock generator • On-board synchronized sine wave generator (250Hz, 500 Hz,1KHz, 2KHz) • On-board DC voltage for receiver synchronization • Four channel Time Division Multiplexing &Demultiplexing • Three wire, Two wire and single wire transmission system • On-board PLL for clock Recovery • Comparator for receiver channel synchronization • Fourth order butter worth Low pass filterTECHNICAL SPECIFICATION:
• Crystal Frequency : 6.4MHz • SinewaveType : On-board synchronized • SinewaveFrequency : 250KHz, 500Hz, 1KHz, 2KHz • DC Level : 0 to 5V (Variable) • Number of Channel : Four • Multiplexer Type : Switch Based • DemultiplexerType : Switch Based • Channel Synchronization : Comparator • Clock Recovery : Phase Locked Loop • Filter Type : Butter worth, Low Pass Filter • Filter Cut off Frequency : 3.4 KHz
Mosquito Breeder
Human Ear, 6 Parts
Description
Four times enlarged, dissectible into 6 parts. Shows outer, middle and inner ear. Removable tymponic membrane with malleus and incus as well as labyrinth with stapes, cochlea and vestibulocochlear nerve (2 part) with two removable bone sections to close the middle and inner ear. On board with key card.XTEMOS ELEMENT
AJAX PRODUCTS TABS LOAD MORE PAGINATION
SILICA CRUCIBLE WITHOUT LID
PRODUCT DESCRIPTION
- Crucible is glazed inside and outside.
- Highly resistant to alkalis and hot temperatures
- 50ml capacity
- Outside diameter 55mm, 42mm height
- No lid includedSilica crucible is glazed inside and outside. Highly resistant to alkalis and hot temperature SIZES ARE: 15ML 25ML 50ML 80ML 100ML 150ML
SILICA CRUCIBLE TALL FORM Without Lid, Translucent
XTEMOS ELEMENT
AJAX PRODUCTS TABS CAROUSEL
Dicot Stem Anatomy T. S. & L. S.
Description
This model shows the transverse and longitudinal section of a dicotyledonous stem in which case the cambium ring has been formed but no secondary growth has yet taken place. Useful model for study of epidermis, lentice , cork layer, cork cambium, cortical parenchyma ,starch sheath, medullary rays, phloem, sieve plate, sieve tube, phloem parenchyma and inter fasicular cambium ,xylem, pitted vessels, bordered pitted vessels, annular vessels, spiral vessels, pith etc. Mounted on base, with key card.
Microwave Integrated Circuit Trainer
This trainer is used to study Microstrip components and its characteristics. A useful trainer to get hands on experience on Microstrip components and instrument. We offer Three solutions.
1GHz RF Source with Detector
• Frequency Range : 0.05 to 1GHz. • Resolution : 100KHz. • Automatic Level Control (ALC) RF Detecter& Directional coupler provided for many RF measurements. • Output Impedance : 50 Ohm.1GHz Micro Strip Component
• Ring Resonator. • 3dB Power divider. • Direction of Coupler.
Expansion of Liquids Apparatus
Description
Comprising five removable glass tubes in a sliding frame and supported in a water trough. For demonstrating the different thermal expansions of various liquids. Comprising five glass tubes in a frame and supported in a water trough. The frame has a special sliding arrangement with clips to hold glass bulbs with tubes. The bulbs can be easily removed and fixed and have funnel formation on top for easy filling.
Cytology Mitotic Cell Division
Educational Equipments Manufacturer, Exporters & Suppliers - School Educational Equipments Manufacturers & Exporters of Educational Equipments for Lab.
Science Lab Products, Teaching Aids, Classroom Instruments, Educational Laboratory
Interphase Stage
Prophase Stage
Metaphase Stage
Anaphase Stage
Anaphase Stage
Telophase Stage
Set of 5 Slides, as above
Micro Cover Glass
Made from clear optical glass, the cover glasses are uniform in size and free from scratches and striations. Packed in plastic box for easy handling.
Pack of 10 gms
Size
Square Size
18x18mm.
19x19mm.
22x22mm.
Rectangular Size
22x30mm.
22x40mm.
22x50mm.
22x60mm.
24x50mm.
24x60mm.
Circular Size
18mm.
19mm.
22mm.
24mm.
