XTEMOS ELEMENT
AJAX PRODUCTS TABS
Water Bath Incubator Shaker
Specifications
Similar to other water bath but fitted with inbuilt shaker for differrent experiments demanding shaking at constant speed under controlled temerature conditions. The temprature is controlled by capillary type thermostat from ambient to 100°C. RPM range :- 40-140 with variable electronic speed regulattor workable on 220V AC 50 Hz Single Phase.| Chamber Size In mms (dia x depth) | Capacity (L) | |
|---|---|---|
| 275x275x150 | 12 L | |
| 405x300x150 | 18 L |
Optional (Extra Cost)
Microprocessor PID digital temp. indicator cum contrroller. Digital RPM meter. Auto cut off device when water level is low.
Demonstration Meter
Pin Fin Appatatus
The apparatus consists of a channel in which the pin fin is tested in both natural as well as forced convection. The channel is connected to the suction of blower. The blower is operated to touch the pin fin in forced convection only. In natural convection, the window above the pin fin is kept open to the atmosphere. Five thermocouple tapings are given along the length of the fin. Thus the temperature distribution along the length can be distinguished. Also natural and forced heat transfer co-efficient, effectiveness, etc. can be found out.
Specifications:
1.Three pin fins- a) M. S. b) Brass c) Al 2.Channel- 150mm x 100mm x 1000mm 3.Blower – run by f.h.p. motor. 4.Orifice meter along with water manometer to measure airflow. 5.Voltmeter and ammeter to measure power input. 6.Cr- Al thermocouple with 6 tapings along with temperature indicator. 7.Dimmerstat to control power input. 8.A band heater to heat the pin fin. A technical manual accompanies the unit.Services required:
1.220v, stabilized single phase supply along with earthing Connection. 2.Floor area 2m x 1m x 1m height.XTEMOS ELEMENT
AJAX PRODUCTS TABS SIMPLE
Single Phase Cyclo Converter
Specification
• Consists of firing circuit, SCR power circuit and load. • Line synchronized IC based linear firing circuit. • Line synchronization achieved by step - down transformer. • Four nos. firing pulse with pulse transformer isolation to trigger four SCR. • One no. potentiometer used to vary the firing angle (180° - 0°). • Carrier logic implemented with carrier frequency of 4KHz. • One no. toggle switch with debounceogic for pulse ON/OFF. • EPROM Based firing pulse frequency variation. • Two nos. toggle switch to select different frequency (Hz, 50/2Hz, 50/3Hz, 50/4Hz). • Power circuit consists of Four nos. SCR with fuse protection. • Anode, Cathode, Gate terminals are terminated in the front panel for user connection. • 24V AC, 1Amp Provided for power circuit input with ON/OFF switch. • One no. fixed R, load provided Center tapped inductor for power circuit. • 230V, 50Hz AC input with ON/OFF rocker switch, fuse for over load.
Straight Joint
Small Dental Care Model (28teeth), PVC
XTEMOS ELEMENT
AJAX PRODUCTS TABS ALTERNATIVE
Fashion
Large Rectangular Transparent Tank
Surber Stream Bottom Sampler
Cryovial
Cryovial are normally used for storage of Biological material, human & animal cells.
These sterilized tubes are provided with white prominent graduation and a long marking area for sample identification.
The cap of these Cryovial is provided with a seal ring inside to make it completely leak proof.
The longitudinal grooves in the base give a non-twisting feature to these vials when paced in a cryo rack.
Material : Polypropylene
| Particulars | Pack (Pcs) | |
|---|---|---|
| Cryo Vail - Internal Thread 2.0 ml | 500 | |
| Cryo Vail 1.8 ml | 1000 | |
| Cryo Vail 4.5 ml | 500 |
XTEMOS ELEMENT
AJAX PRODUCTS TABS ARROWS PAGINATION
Rack Pinion Type Steering System
Rack & Pinion Type Steering System – Actual Working
The working of steering system is shown with the help of actual parts assembled on square iron pipe frame. All the necessary parts of steering system are shown in actual working form. This model helps the student to understand the working of the steering system very easily. It is specially made dissectible for demonstration purposes.
Precision Rotary Microtome
Description
A fully dependable sectioning equipment designed for precise sectioning of tissues up to 1 micron thickness. It has a front located feed indicator with cam drive system for accurate feed setting from 1 to 50 microns in steps of 1 micron. Prominent features include independent feed mechanism with automatic safety device, universal knife holder with lateral movement to permit use of entire knife edge, ball and flange type object holder for accurate centering of the specimen and full swing protective cover for easy cleaning and lubrication. The equipment assures smooth operation throughout the long life of the instrument as individual components are manufactured with modern techniques. The microtome razor is fabricated from fine grain steel alloy tested for microstructure and is heat treated to maintain its sharpness and strength. Supplied complete with one razor 120 mm with back and handle, a set of three object holders, one honing plate, oil can, dust cover, in wooden cabinet.
Aquatic Net
XTEMOS ELEMENT
AJAX PRODUCTS TABS WITH ICONS
Cortex M4 Development Board
Cortex M4 is an ideal replacement solution for the traditional Microcontroller & DSP Processors. Vi-S32 based on ST Microelectronics cortex M4 processor offers many features for Embedded Real Time world. The full range of hardware features on the board is provided to help you to evaluate and develop many applications. STM32 Embedded target enables systems and software Engineers to quickly deploy their application models in Matlab& Simulink to Cortex M4 ARM.
Specification
• STM32F407VGT6 microcontroller high performance 32bit ARM Cortex M4. • Operating upto 168MHz • 196Kbytes of SRAM • 2.4 MSPS Analog to Digital Converter • Two Nos. of Potentiometer interface for ADC input. • Two Nos. of DAC with simultaneous conversion • 1MB On-Chip Flash. • 4 Nos. of User LEDs, Relay Interface. • 8 way dipswitch for user input • I2C Based 2 digit 7 Segment display interface. • 4 keys keypad, Stepper Motor driver interface. • USB OTG FS with micro AB connector interface. • RTC with battery backup • I2C EEPROM device interface • SPI based temperature sensor interface • 1 Gbyte Micro SD Card interface • RS232 UART interface at a pin D connector/USB connector • CAN 2.0 lines are terminated at 9 pin D female connector • 3.2inch 240 x 320 TFT color LCD with Touch Screen • 10/100Mbps Ethernet interface • Extension header for I2C, SPI & CAN • Camera Interface
Fisher Clamp
We bring to you, Fisher Clamp.
The Fisher Clamps are moulded in Polypropylene making it completely corrosion-proof.
The spring-loaded jack in the middle provides a vice like grip to the Burette and prevents it from slipping.
Two tapered wedges are provided to ensure firm grip on rods having diameter ½" or 3/8".
Material : Polypropylene
| Particulars | Pack (Pcs) | |
|---|---|---|
| Fisher Clamp- Single | 12 | |
| Fisher Clamp- Double | 6 |
Ballistic Galvano Meters
Description
Used for measurement of small quantities of electrical charge. Levelling Screws for balancing the coil. Coil with mirror suspended between long suspension at the upper end and a spring at lower end. Clamping arrangement for transportation. Consistent sensitivity over a large period. Strip provided for making it a periodic. Res. in Ohm Crit. Damp. Res. in Ohms Sensitivity mm per m Coul. Sensitivity mm per m Amp. Time period in Seconds.| 100 | 300 | 1000 | 12 | 2000 |
| 500 | 600 | 1400 | 12 | 3500 |
XTEMOS ELEMENT
AJAX PRODUCTS TABS LOAD MORE PAGINATION
SILICA CRUCIBLE WITHOUT LID
PRODUCT DESCRIPTION
- Crucible is glazed inside and outside.
- Highly resistant to alkalis and hot temperatures
- 50ml capacity
- Outside diameter 55mm, 42mm height
- No lid includedSilica crucible is glazed inside and outside. Highly resistant to alkalis and hot temperature SIZES ARE: 15ML 25ML 50ML 80ML 100ML 150ML
SILICA CRUCIBLE TALL FORM Without Lid, Translucent
XTEMOS ELEMENT
AJAX PRODUCTS TABS CAROUSEL
Hydraulic Trainer Electrohydraulic
Silent Features:
1. software for simulation of Hydraulic circuits. 2. We are manufacturing cylinders for industrial applications. Our cylinders can withstand pressure up to 160 Bar. 3. Mobile and self-contained unit, only electrical connections are required. 4. Simplicity of operation and designed for amateur use. 5. Two pressure relief valves are provided in the system. One is provided inside the tank to increase the safety. 6. Hoses can withstand pressure of 188 Bar. 7. Test Pressure : 80 Bar ; Operating Pressure : 40 Bar. 8. Realistic Industrial circuits are demonstrated. 9. Special Bell housing is provided to maintain the Run out between Pump and Motor below 0.020mm. 10. Special fixtures used for pipe bending and ferrule fitting arrangement. 11. Specially designed front mounting plate. 12. System is flushed with very high velocity (4 times the working pressure) by separate oil which maintains class A cleanliness of system. 13. Lowest pressure drop in the system to avoid overheating. 14. Cylinder are manufactured from precision honed tubes, hardened ground, hard chrome plated piston rods and imported quality seals
Numerical System
This panel is used to demonstrate the number systems such as binary, decimal and hexadecimal numbers. Toggle switches used to activate the displays showing the particular number entered. Input may be entered either as decimal or binary numbers with a toggle switch for mode selection. Decimal numbers are shown on a three digit seven segment LED display. 12 V / 2 A DC adaptor is required to operate it.
Binocular Microscope
The future of class room microscopy with crisp sharp image, very much convenient in working, easy to move, light weight, durability, ergonomic design and affordable prices.
It became an ideal instrument for school labs, medical institutes, colleges and universities.
Specifications
| Viewing head | : | Inclined sliding type Binocular Head | |
| Eyepiece | : | Paired Wide Field Eyepiece WF 10x/18 | |
| : | Paired Eye-piece 5x Huygenian | ||
| Objectives | : | Semi-Plan 4x,10x,40x(SL) & | |
| : | 100 x (SL) Oil Immersion. | ||
| Nose-piece | : | Quadruple Nosepiece | |
| Mechanical Stage | : | Double plate stage size 140mm x 140mm, X/Y travel range 90mmx65mm.Low drive right side movement controls. Ceramic surface for scratch resistance. Double specimen holder clip | |
| Condenser | : | Abbe N.A 1.25 with Iris Diaphragm | |
| Filter | : | Frosted White Filter | |
| Illumination | : | LED Illumination, Brightness Adjustable | |
| Light Source | : | Plano-concave Mirror | |
| Carrying Case | : | Styrofoam Packing with standard accessories. |
Thermal Conductivity Of Insulating Powder
The apparatus consists of an insulating powder, which is enclosed in a cavity of two concentric spheres. The inner space of the inner sphere contains the mica heater. Input to the heater can be adjusted by the dimmerstat. The tappings on the surfaces of the inner sphere and outer sphere are used to find out the temperature difference between the spheres. This enables to find out the conductivity of powder.
Specifications:
1.Inner sphere dia. 100mm and outer sphere dia. 200mm. 2.Mica heater two heat the inner sphere surface. 3.Ten thermocouple tappings in the test section. 4.Plaster of Paris / asbestos powder in the test section. 5.Panel comprises of a)Voltmeter and ammeter b)Dimmerstat c)Temperature indicatorServices required:
1.220v stabilized single-phase supply. 2.Floor surface 1m x 0.5m at working height.
Powder Funnel
We are the major Exporter and Trader of premium quality Powder Funnel.
These polypropylene Powder Funnel are best suited for transferring powdered reagents.
The unique features of these funnels include its parallel stem that minimizes bridging of powder.
These funnels are steam autoclavable at 121 C.
Material : Polypropylene
| Particulars | Pack (Pcs) | |
|---|---|---|
| Powder Funnel 65 mm | 36 | |
| Powder Funnel 80 mm | 36 | |
| Powder Funnel 100 mm | 36 | |
| Powder Funnel 150 mm | 12 |
