XTEMOS ELEMENT
AJAX PRODUCTS TABS
Table Counter Suitable for 100 tablet
VHDL/VERILOG Learning Kit
Features
• Based on 64 Macro cell Xilinx CPLD device : XC2C64A • 20 SPDT Slide switches • 16 output LEDs and One 7 segment LED display • 4x4 Matrix keys using Micro switches (4 multiplexed with 4Nos of Slide switch) • One NC/NO switch for giving manual clock • Square wave Oscillator • Onboard USB to JTAG and External JTAG Connector for programming the CPLD • 16 I/O Lines terminated at 20 pin connecter. • External 5 volt 2Amp power supply • Compatible with Xilinx ISE Design Suite Web Pack Software. • USB Cable • Onboard USB to JTAG is Compatible only with Vi JTAG 5.0 Software.
Concentric Tube Heat Exchanger
(A)Plain Tube ( Water To Water ):
The apparatus consists of two concentric tubes. Inner tube consists of copper tube through which hot water flows. While the outer tube consists of GI pipe through which cold water flows. The arrangement enables the parallel and counter flow of the cold water. The inlet and outlet temperatures and the flow measurement enable to find out the heat exchanged LMTD, and effectiveness of the equipment.
Specifications:
1.Inner copper tube I.D, 12.7mm. and outer G. I. Pipe I. D. 15mm. approx. and 1.5m. length. 2.Thermometers – 4 nos. 3.Measuring flask – 1 Lit. capacity. 4.Geyser-3 kW. Single phase.Services required
1.220v, 15A, stabilized single-phase AC supply. 2.Floor area – 3m x I m x 1 m height. (B) Finned Tube ( Water To Air ): The apparatus consists of two concentric tubes. Inner tube consists of copper tube through which hot water flows. It is finned at its outer diameter to increase the heat transfer surface. While the outer tube consists of GI pipe through which cold air flows. The arrangement enables the parallel and counter flow of the air. The inlet and outlet temperatures and the flow measurement enable to find out the heat exchanged LMTD, and effectiveness of the equipment.Specifications:
1.Inner copper tube I.D. 12.7mm. and outer G. I. Pipe I. D. 25mm. approx. and 1m. length. 2.Thermometers – 4 nos. 3.Orifice meter along with manometer. 4.Measuring flask – 1 Lit. Capacity. 5.Geyser-3 kW. Single phase.Services Required
1.220v, 15A, stabilized single-phase AC supply. 2.Floor area – 3m x 1m x 1m height.XTEMOS ELEMENT
AJAX PRODUCTS TABS SIMPLE
Ice Plant Trainer
The Plant uses ice can system. The cans filled with fresh wafer are kept in a tank in which brine is circulated. The brine is cooled by the refrigerant, which in turn cools the water in can and ice formation takes place.
SPECIFICATIONS:
1.Compressor : Kirioskar make hermetically sealed compressor using R 12 Refrigerant. 2.Condenser : 4 row type air cooled. 3.Expansion Valve : 0.5 TR capacity. 4.Evaporator : 1/2″ O.D. copper tube – 75 feet long. 5.Filter – Drier : Silica gel filled – 3/8″ flare connections. 6.Main Tank : 600 mm X 375 mm 7.Total Ice Cane Capacity : 7 Kg 8.Ice Making Capacity : 7 Kg / 4 Hours. 9.Thermocol insulation : 6.5″ 10.Brine Stirrer : Motor driven fan, 1 phase, 1/10 HP, 1440.INSTRUMENTATION:
1.Temperature Indicator : Digital Type O300°c, with 1 °c least count, using Cr/Al thermocouples. Accuracy 1 % of full reading. 2.Compressor Energy Meter : Single Phase, 10 – 20 Amp. Capacity. 3.Pressure Gauge: a)0-21 Kg/cm2 b) -1 to 10.6 Kg/cm2 c) Both of 65 mm dial. 4.Digital Thermometer CONTROLS : 1.HP/LP Cutout : Auto reset type. 2.Thermostat : Auto reset type. A technical manual accompanies the unit.SERVICES REQUIRED:
1.Floor Area – 2m. X 1.5m. X 1.5m. Height. 2.220 V., 15 Amp.Single Phase Stabilized power supply
Insect Cage
Description
Aluminium angle framework supported on wooden batons. Fine mesh provided on slide and top. Hinged door provided on side or top. Hinged door provided with clips for tight closing. Wooden bottom covered with sunmica from inside. Size 15x15x15cm. Size 20x15x15cm. Size 25x20x20cm. Size 20x20x20cm.Folding Type
Size 30x30x45cm.
Water Tap, Swan Neck, Heavy
XTEMOS ELEMENT
AJAX PRODUCTS TABS ALTERNATIVE
Fashion
Micro Cover Glass
Made from clear optical glass, the cover glasses are uniform in size and free from scratches and striations. Packed in plastic box for easy handling.
Pack of 10 gms
Size
Square Size
18x18mm.
19x19mm.
22x22mm.
Rectangular Size
22x30mm.
22x40mm.
22x50mm.
22x60mm.
24x50mm.
24x60mm.
Circular Size
18mm.
19mm.
22mm.
24mm.
Artery model showing plaque building
Burner Bunsen – Simple, LPG
Model of Dentition development
XTEMOS ELEMENT
AJAX PRODUCTS TABS ARROWS PAGINATION
Aves Histology
Educational Equipments Manufacturer, Exporters & Suppliers - School Educational Equipments Manufacturers & Exporters of Educational Equipments for Lab.
Science Lab Products, Teaching Aids, Classroom Instruments, Educational Laboratory
| Skin VS | Skin VS with Feather |
| Bird Filoplume Feather WM | Bird Down Feather WM |
| Epiglottis TS | Oesophagus TS |
| Proventriculus TS | Duodenum TS |
| Small Intestine TS | Large Intestine TS |
| Gizzard TS | Spleen TS |
| Spleen TS | Liver TS |
| Pancreas TS | Trachea TS Lung TS |
| Kidney TS | Ovary TS |
| Testis TS | Heart TS Ventricle |
| Heart TS Auricle | Heart LS |
| Artery TS | Vein TS |
| Bone TS | Spinal Cord TS |
| Nerve TS | Choaca TS |
| Eye Pectin | Brain TS through different Regions |
Balance
Thin Cylinder Apparatus
A heavy bench top unit for studying the stress and strain in a thin walled cylinder under internal pressure. A thin walled cylinder is mounted between two support blocks. Internal pistons and seals create oil sealing. A handwheel at one end of the apparatus enables the cylinder end conditions to be adjusted to either open or closed. The internal pressure is adjusted by means of a hydraulic hand pump on the apparatus. An analogue pressure gauge displays the internal pressure whilst a pressure transducer gives feedback to the Data Acquisition Interface and Software supplied. Strain gauges are arranged on the external surface of the cylinder to measure the radial and circumferential surface strain. The strain gauges are at various angles.
Laboratory Stirrer
Laboratory Stirrer (Mechanical Stirrer)
Fitted with speed regulator, height and space adjustable 1/20 H.P.
AC/DC Motor.
Features
Stir power: 150 W. Stirring and heating volume: up to 80L (H2O). Stir speed: 60- 1500rpm. rotate speed display, time accurate, acceleration precise structure, bidirectional mixing.XTEMOS ELEMENT
AJAX PRODUCTS TABS WITH ICONS
Wooden Pipette Stand, Holds 24 pipettes Vertically
Spirometer
Meker Burner, with Stopcock
XTEMOS ELEMENT
AJAX PRODUCTS TABS LOAD MORE PAGINATION
SILICA CRUCIBLE WITHOUT LID
PRODUCT DESCRIPTION
- Crucible is glazed inside and outside.
- Highly resistant to alkalis and hot temperatures
- 50ml capacity
- Outside diameter 55mm, 42mm height
- No lid includedSilica crucible is glazed inside and outside. Highly resistant to alkalis and hot temperature SIZES ARE: 15ML 25ML 50ML 80ML 100ML 150ML
SILICA CRUCIBLE TALL FORM Without Lid, Translucent
XTEMOS ELEMENT
AJAX PRODUCTS TABS CAROUSEL
Aids Virus
Description
HIV virus model is enlarged millions of times, shows the outer lipid membrane with protein structures and the internal nucleus which contains the viral hereditary matter [RNA]. The nucleus is removable and condoms can be put underneath to provide a message regarding measures to be taken for protecting against HIV infections. Supplied without condoms on stand with key card.
Air Conditioning Trainer General Cycle Type
The unit consists of ducting fitted with various air conditioning components. Airflow is generated by an axial flow fan and in the airflow, heaters, cooling coil and steam humidifier connection is provided. Cooling circuit consists of a hermetic compressor; air cooled condenser, thermostatic expansion valve and evaporator (i.e. cooling coil). Measurements of various parameters Torn cooling cycle and heating cycle are provided and students can easily visualize and understand the basic principles of air conditioning.
SPECIFICATIONS:
1.Cooling circuits – It consists of: a) Hermetic compressor, having the capacity of 2/3 ton of refrigeration (approx.) using R-22 refrigerant. b) Rotameter for liquid refrigerant flow measurement. c) Pressure gauges for high and low pressure. d) Prescott (i.e. high and low pressure cut-out). e) Thermometers for temperature measurement at various points In the cycle. f) Energymeter for compressor input measurement. g) Condensate measuring arrangement. 2.Heating Circuit – Air heaters with input control provided with energymeter for input measurement. Maximum heating capacity 1 Kw. 3.Steam generator and injector for humidification of air. All above components are connected to a duct of size 200mm. X 200mm. in which airflow is generated by axial flow fan. 4.Anemometer for measurement of air velocity, (range 0-15 m/sec. Following experiments can be conducted on the unit a) Cooling of atmospheric air. b) Heating of atmospheric air. c) Humidification of atmospheric air. d) Dehumidification and heating of atmospheric air. (Cooling coil acts as dehumidifier at reduced airflow.)SERVICES REQUIRED:
1.440 V, 15 A, 3 Phase supply with earthing connection. 2.Floor space area about 3 m. X 2 m.
Sterility Test Apparatus (S.S Manifold)
It consists of Stainless steel holders in the manifold of 3 of 6 to hold 47 mm dia membrane filters, the tops of the holders are connected to the outlets of flushing tube with silicone tubing and glass top cock.
A vacuum resistant flask or wolf bottle must be placed between the manifold and vacuum pump.
(Supplied without wolf bottle and vacuum/pressure pump).
These units are used for sterility testing when the membranes filter is to be removed from the holder for incubation in culture media.
Filtration area is 12.5 cm and has a holding capacity of 250ml.
Though the only vacuum is required for filtration, some pressure is required for flushing liquids.
SPECIFICATIONS
| Material: | Stainless Steel | |
| Branch Test: | 3 Dia. 47mm | |
| Filtration Area: | 12.5 cm | |
| Holding Capacity: | 250 ml |
FEATURES
Robust design. Easy to use. Rustproof.APPLICATION
For microbiology, biochemistry, hydrobiology (DNA/RNA). Beverage analysis & food testing. Protein binding, gravimetric analysis, coliform, yeast, mould total bacteria & sterility testing. Ideal for water & wastewater analysis. Residue precipitate analysis and contamination tests. General Liquid Filtration.Single Test (Filter Holder S.S) Three Test
Fisher Clamp
We bring to you, Fisher Clamp.
The Fisher Clamps are moulded in Polypropylene making it completely corrosion-proof.
The spring-loaded jack in the middle provides a vice like grip to the Burette and prevents it from slipping.
Two tapered wedges are provided to ensure firm grip on rods having diameter ½" or 3/8".
Material : Polypropylene
| Particulars | Pack (Pcs) | |
|---|---|---|
| Fisher Clamp- Single | 12 | |
| Fisher Clamp- Double | 6 |
