XTEMOS ELEMENT
AJAX PRODUCTS TABS
Citical Radius Of Insulating Material
Citical Radius of Insulating Material:
At particular radius of insulation over a cylinder, loss of heat is maximum. The unit consists of a G.I. pipe provided with plaster of Paris insulation on out side surface. Four pipes are provided with heater inside having input control. Input to heaters is measured by common voltmeter and ammeter, by controlling input to heaters, it is shown that critical radius of insulation is ratio of thermal conductivity and outside heat transfer co-efficient.
SPECIFICATIONS:
1.G. I. Pipes with electrical heater inside – 4 Nos. 2.Insulation over the pipes of different thickness. 3.Controls and Measurements – a) Dimmerstat to control heater input – 4 Nos. b) A voltmeter and ammeter to measure inputs to heater. c) Digital temperature indicator to measure temperatures across insulation. d) Necessary switches and controls. A technical manual accompanies the unit.SERVICES REQUIRED:
230 V, 5 Amp., A.C., Supply with earthing connection. Floor Area of 1 m. X 1 m X 1.5m. height.
Dial Interchangeable
Test Tube Caps
The Test Tube Caps offered by us, come with a transparent polypropylene cap for test tubes, which proves to be an excellent protection to the contents of the tubes.
The grooves inside the cap tighten the fitting on the tube while the outer set in the tube making the combination a leak proof one.
Material : Polypropylene
| Particulars | Pack (Pcs) | |
|---|---|---|
| Test Tube With Screw Cap 16 x 100 mm | 500 | |
| Cap For Test Tube Ø 25 mm | 500 |
XTEMOS ELEMENT
AJAX PRODUCTS TABS SIMPLE
Hydraulic Brake Actual Working Front Disc Rear
XTEMOS ELEMENT
AJAX PRODUCTS TABS ALTERNATIVE
Fashion
Disintegrator
Description
Highly polished hooper dia 2". 16x25mm Completed with suitable motor to work on 220V AC 50Hz single phase. Fitted with 4 steel hammers fixed to a disc of dia. 1½" through which passes a shaft being revolved at the speed of approximately 3000 RPM. Hammers are enclosed in a drum. The lower portion can be fitted with different mesh screens (sieves)-coarse, medium or fine supplied with the equipment.
89V51 Development Board
Specification:
• High Performance P89V51RD2 device • On board ON/OFF switch and programmer / execution switch • 4x4 Matrix Keypad interface • 8-way DIP switch for digital logical input selection • 8 LEDs for digital output • One 16x2 Alphanumeric LCD display • 4x4 Matrix Keypad, On board 16x2 LCD • Real Time Clock (RTC) interface with four Functional keys • RS232 – UART interface with two status LEDs • All the 32 I/O lines are terminated via 4 FRC connectors • On board 0.5Kg Stepper motor with driver circuit • 2 nos of 12V relay for DC Motor • Software compatible for both C and Assembly language • 8 channel ADC with built in analog signals, internal & external data i/p, Temperature sensor, 2 nos of potentiometer for signal separation • On board DAC with buzzer
Fiber Optics Communication Set
Objective:
To construct an optical transmitter and transmission of signal through Fiber Optics Cable. To construct an Optical Receiver and study the Attenuation of Signal when transmitted from Transmitter to Receiver end. Analog and Digital link can also be studied as this unit is complete with Sine and Square Waves. Bending losses can also be studied.
Features:
Instrument comprises of Microphone Preamplifier stages consists of MIC (Microphone), Preamplifier and Amplifier (Voice is converted to electrical signal and then amplified) and fed to LED (Transmitter) and then through fibre cable, signal is sent to Photodetector (Transistor) and again amplifier and output is sent to Speaker Unit. Power Supply of +6 VDC is used in Amplifier ckt. 2 No. Fiber Optics cables are provided (one of them is 50 cm long and the other is 100 cm long). One more fiber cable of 50mm length having connector at one end is also provided. Connectors a both end of fiber cable are provided for insertion in sockets provided on the front panel. Bending losses can also be studied in long wire.
Standard: MIC with 2 meter long lead and a Speaker 4”, 4 ohm are mounted in a vertical box.
Accuracy: with 1 meter long connecting leads. 2 No. Fiber optic cable having length of 50 cm and 100 cm are provided.
Optional : Digital multimeter (3 1/2 Digit, Big size Display) This model also include Digital Multimeter and wooden frame for measurement of Numerical aperture i.e. complete in all respect including facility for measurement of numerical aperture.
XTEMOS ELEMENT
AJAX PRODUCTS TABS ARROWS PAGINATION
Human Heart ,4 parts
Cylinderical Magnet
Oxygen And Carbon Cycle In Nature
XTEMOS ELEMENT
AJAX PRODUCTS TABS WITH ICONS
Dental Care Model (32 Teeth), PVC
Constant Volume Air Thermometer
Description
A metal stand fitted with 0-100 cm x 1 mm vertical wooden scale and supporting a mercury reservoir sliding on a metal rod. An air thermometer bulb fitted to a bracket can be attached to the other rod at either of two positions. With U-shaped base. Complete with 1 meter rubber tubing to connect reservoir to the bulb. Supplied without mercury.XTEMOS ELEMENT
AJAX PRODUCTS TABS LOAD MORE PAGINATION
SILICA CRUCIBLE WITHOUT LID
PRODUCT DESCRIPTION
- Crucible is glazed inside and outside.
- Highly resistant to alkalis and hot temperatures
- 50ml capacity
- Outside diameter 55mm, 42mm height
- No lid includedSilica crucible is glazed inside and outside. Highly resistant to alkalis and hot temperature SIZES ARE: 15ML 25ML 50ML 80ML 100ML 150ML
SILICA CRUCIBLE TALL FORM Without Lid, Translucent
XTEMOS ELEMENT
AJAX PRODUCTS TABS CAROUSEL
Curved Member Apparatus
Apparatus consists of a steel bar which is used to make the different curved members Viz. circle, semicircle with straight arm, a quadrant of a circle and quadrant of a circle with straight arm. The bottom ends of the members are fixed to the base. Under the application of load at free end, its horizontal and vertical deflection can be measured with the help of dial gauges. A dial gauge with 25mm travel (with a magnetic base) is supplied with the apparatus. Apparatus to be supplied should be complete with a supporting stand and a set of weights.
Experimental Capabilities: Apparatus is supplied complete with a supporting stand and a set of weights.
Physical Optics Kit
Description
Consists of: 1. Eight Plano-convex lens fl 500 mm, 1 Plano convex lens of fl 150 mm. 2. Twelve lens holders. 3. Four plates of different apertures, 32, 22, 11 and 5.5 mm diameter resp. 4.Three plates with small holes in circles of 29, 22, 10 mm diameter 5. One plate with circular aperture of 5.5 mm diameter 6. Four multi-aperture plates. 7. Four stop plates. 8. Two slide holders. 9. Six translucent screens. 10. Ten white cards. 11. Four Eye-pieces. 12. Fifteen each Red, Green and Blue filters. 13. Forty Black cards with holes. 14. Forty razor blades. 15. 120 Rubber bands. 16. One piece black chiffon for diffraction effects
