XTEMOS ELEMENT
AJAX PRODUCTS TABS
Spherometer Laboratory
Newton’s Rings Apparatus
Test Tube Support 12 place -( Superior,Wooden )
XTEMOS ELEMENT
AJAX PRODUCTS TABS SIMPLE
Coriollis Component Of Acceleration
This set up is designed to study coriollis component of Acceleration of a slider crank Mechanism. The apparatus uses hydraulic analogy to represent the rotating slider. It consists of a rotating block with two arms in opposite direction. These tubes can be rotated at various speeds by using a swinging field motor, which also acts as a dynamometer to measure torque applied to rotating tubes. A Perspex window on top cover helps to visualize the process. Rotameter is used to measure water flow rate through tubes. Water is circulated by small monoblaock pump.
Specifications:
1.Main Tank with fiberglass lining. 2.Rotating Arms 9/6 mm dia, 300 mm long. 3.Motor – Swinging field, D.C., 0.5 HP. 4.Rotameter 5.Monoblock Pump 6.Control Panel comprising of – (i) Speed Control Unit. (ii) Speed Indicator. (iii) Necessary switches. 7.Rigid support frame.Range of Experiment:
Coriollis Component of Acceleration can be determined at various speeds of rotation and water flow rates.Service Required:
1.A.C. Single Phase .230 V. stabilized supply. 2.Floor Space -1.5 m X 1.5 m.
Ohm’s Law Appartus
Description
To demonstrate Ohms Law. Consisting of a wooden enclosure with milliammeter, voltmeter, rheostat, push key and terminal posts. Requires an external battery (not supplied) and a suitable resistance (not supplied). Resistance can be calculated using Ohm’s Law by noting current and voltage. A rheostat is provided to control current flow. Circuit diagram is provided on the panel with instructions.
XTEMOS ELEMENT
AJAX PRODUCTS TABS ALTERNATIVE
Fashion
Dental Care Model (28 Teeth), PVC
Refrigeration Trainer General Cycle Type
The unit consists of vapor compression refrigeration cycle provided with components normally used in refrigeration system so that student can get familiar with the components. Various measurement provided enable students to estimate the performance of the system.
SPECIFICATIONS:
1.Compressor- Hermetically sealed compressor, having capacity of 0.3 T. 2.Expansion Devices a) Thermostatic Expansion Valve b) Capillary tube. 3.Evaporator coil. 4.Controls: a) Services Valve b) Solenoid Valve c) Filter-Drier for refrigerant d) High/Low pressure cutout e) Thermostat. 5.Measurements: a) Thermometers (mercury in glass) – 4 Nos. b) Pressure gauges for condensing and evaporating pressure. c) Energymeter for compressor d) Voltmeter and Ammeter for compressor. e) Rotameter for liquid refrigerant flow measurement. A technical manual is accompanies the unit.SERVICES REQUIRED:
1.Floor surface area – 1m x 2m x 2m height. 2.220V, I5Amp, Single Phase Stabilized power supply
Tuning Forks
XTEMOS ELEMENT
AJAX PRODUCTS TABS ARROWS PAGINATION
Separatory Funnel
We bring forth the finest range of Separatory Funnel.
Our Separatory Funnel are designed in such a way that they make filling of carboys, drums and barrels very convenient.
The handles of these funnels make their handling very easy.
We offer these Separatory Funnel at market leading prices.
Material : Polypropylene
| Particulars | Pack (Pcs) | |
|---|---|---|
| Separatory Funnel 100 ml | 2 | |
| Separatory Funnel 250 ml | 2 | |
| Separatory Funnel 500 ml | 2 |
Induction Coil
Description
This box form Induction Coil has a 50 mm spark gap and can produce pulses of high voltage spark from a low voltage direct current source such as a battery. It is suitable for use with gas-filled discharge tubes, vacuum tubes, eudiometers and for general laboratory work. It is comprised of two coils fully enclosed in a polished wooden case with binding posts. Spark gap at the discharge points can be adjusted by sliding rods back and forth
Ball & Ring GRAVESANDE
XTEMOS ELEMENT
AJAX PRODUCTS TABS WITH ICONS
Carburetors Actual Cut Section
Pulse Width Modulation and Demodulation
This Instrument is design to demonstrate the method to transmit signals via. Electromagnetic transmission and to study the Pulse Width Modulation and Demodulation. Whole instrument is placed in plastic moulded box and 2 mm banana plug leads are provided for modulation and demodulation connections.
Technical Specification:-
1. Built in IC based DC Regulated Power supply ±12 V, +5 V.
2. Four level Built in carrier pulse Output.
3. Frequency Range: 8 KHz, 16 KHz, 32 KHz, 64 KHz Amplitude : 5 Vpp approx.
4. Built in sine wave Audio Frequency Function Generator for modulating signal. Frequency Range: 1 KHz and 2 KHz selectable with a toggle switch Amplitude : 0-10 Vpp and 0-4 Vpp approx.
5. Circuit Diagram for Modulation and Demodulation is printed on the milky white top panel.
Pteridophyta
| Azolla Sporocarp VS | Adiantum Rhizome TS |
| Adiantum Root TS | Adiantum Sorus VS |
| Equisetum Prothallus WM | Equisetum Root TS |
| Equisetum Rhizome TS | Equisetum Stem TS |
| Equisetum Cone TS | Equisetum Cone LS |
| Fern Rhizome TS | Fern (Pteris) Prothallus Young |
| Fern Prothallus with Antheridia | Fern Prothallus with Archegonia |
| Fern Prothallus with Sporophyte | Fern Leaf with Sori TS |
| Fern Sori WM | Fern Prothallus TS |
| Fern Rachis TS | Fern Root TS |
| Lycopodium Root TS Lycopodium Stem TS | Lycopodium Apex LS |
| Lycopodium Cone LS | Lycopodium Cernum Stem TS |
| Lycopodium Wightiatum Stem TS | Lycopodium Phlegmaria Stem TS |
| Marsilea Leaf TS | Marsilea Root TS |
| Marsilea Rhizome TS | Marsilea Petiole TS |
| Marsilea Sporocarp LS | Marsilea Sporocarp TS |
| Selagineela Root TS | Selaginella Rhizophore TS |
| Selaginella Leaf TS | Selaginella Stem TS |
| Selagineela Strobilus WM | Selaginella Strobillus LS |
| Selaginella Microsporangia WM | Selaginella Mega and Microsporangia WM, TS |
XTEMOS ELEMENT
AJAX PRODUCTS TABS LOAD MORE PAGINATION
SILICA CRUCIBLE WITHOUT LID
PRODUCT DESCRIPTION
- Crucible is glazed inside and outside.
- Highly resistant to alkalis and hot temperatures
- 50ml capacity
- Outside diameter 55mm, 42mm height
- No lid includedSilica crucible is glazed inside and outside. Highly resistant to alkalis and hot temperature SIZES ARE: 15ML 25ML 50ML 80ML 100ML 150ML
SILICA CRUCIBLE TALL FORM Without Lid, Translucent
XTEMOS ELEMENT
AJAX PRODUCTS TABS CAROUSEL
Sterling Engine Working Model
The Stirling engine was invented by Robert Stirling, a Scottish minister, in 1816. A Stirling engine is a heat engine that operates by cyclic compression and expansion of air or other gas, the working fluid, at different temperature levels such that there is a net conversion of heat energy to mechanical work.
Amplitude Shift Keying Modulation And Demodulation
This Instrument is design to demonstrate the method to transmit signals via. Electromagnetic transmission and to study the Amplitude shift keying Modulation and Demodulation. Whole instrument is placed in plastic moulded box and 2 mm banana plug leads are provided for modulation and demodulation connections.
Technical Specification:-
1. Fixed Output DC Regulated Power Supply of ±12 V, +5 V.
2. 100KHz with 5 Vpp amplitude (Approx.) for carrier frequency.
3. In built square wave data generator.
4. Circuit diagrams for Modulator and Demodulator are printed on the milky white top panel.
Color Gauge Meter
Description
Color Gauge Meter Non-corrosive mounting hardware with weather resistant sealed lenses Superior quality internal components UV fade resistant race pointers Come with White Lights with Red removable cover Feature aluminum or plastic non-corrosive cases (automotive versions are steel) The AutoMeter Marine White Five Gauge Combination Kit is available in Standard or Monster Varieties and includes: 6000 RPM Tachometer Voltmeter Fuel Level Oil Pressure Water Temperature.
Theramal Conductivity Of Insulating Slabs
The apparatus consists of a slab assembly. The main Heater and a radial guard heater are sandwiched between copper plates. The specimen in the form of slabs of equal thickness are placed on either sides of heaters and cooling plates through which water is circulated are on the other Sides of the specimen. The radial guard heater ensures all heat of the main heater to pass axially through the specimens which is collected by cooling plates. By knowing the temperatures and Heat input, thermal conductivity of specimen can be calculated. The test set up is enclosed in an enclosure with insulation inside to provide undisturbed Surroundings. The design style of the apparatus is similar to as recommended in INDIAN standard. The difference is in sizes.
