XTEMOS ELEMENT

AJAX PRODUCTS TABS

Featured
  • Featured
  • Accessories
  • Furniture

Xilinx Spartan 3E FPGA Trainer Kit

Specification

• XC3S250E - 4PQ208C / XC3S500E-4PQ208C • 16 Nos. of digital input using slide switches with LED indication • 16Nos. Of digital outputs using discrete LEDs • 16 x 2 LCD is provided for display the text message. • One Reset Switch • One switch is provided for giving manual clock • FPGA configuration through - JTAG Port - On board Flash Prom XCF02S • Total 158 I/O pins : 124 pins used for integrating peripherals like LED, Switches etc., balance pins available to user in 20 pin • header (3.3V compatible) • 1No of 26pin header to interface VLIM cards like Traffic Light Controller (5V compatible) • On board programmable PLL oscillator from 1 MHz to 100 MHz using jumpers • 4 Nos of 7 segment LED display • One relay and Buzzer provided. • Stepper & DC motor Driver provided. • 4 * 4 matrix key provided • Housed in a sleek plastic cabinet with built in SMPS 5V/2A. • Compatible with Xilinx ISE Design Suite WebPACK Software. • On board USB to JTAG is available for configure FPGA (Supports only with Vi JTAG 5.0 Software)

Refrigerant Charging Unit

This charging unit is fitted with motorised vacuum pump and other safety devices like pressure gauge. With the help of this charging unit students can charge the refrigerant gases into compressor or store the gas of a refrigerator or air conditioner inside the cylinder fitted inside the charging unit that can be used later.

Pulleys Differential Triple

One-piece aluminium of 38, 50 and 62 mm. mounted in metal frame with hook
XTEMOS ELEMENT

AJAX PRODUCTS TABS SIMPLE

shirt-tab
Fashion
Featured
  • Featured
  • Man
  • Woman

Crucible with Lid Low Form

Description

Chemical porcelain crucibles are glazed inside and out, except outside bottom and rim. Crucible covers are completely glazed except for rim. For use in temperatures up to 1150 C (2102 F). Not recommended for minerals or metals.

Capacity :

250ml

Height :

2.36 inch (60mm)

Top Outside Diameter :

4.02 inch (102mm)

BURETTE CLAMP

PRODUCT DESCRIPTION

Single metal burette clamp made from die-pressed sheet metal and includes a built in boss head.  It can accommodate 1 burette (20 mm max. dia.) and can be mounted on a rod up to 10 mm in diameter with the screw adjustment. 4 vinyl covered fingers provide a strong and steady grip.

Arteries With Heart Models

We offer arteries with heart models that are widely used to explain the function of artery and hearts to the students. Our models provide the best way of understanding the functions of these parts, which are explained with the help of different colour combination. These models are mostly used in school and colleges so that students are able to understand the function of these parts in the effective manner.

Mollusca

Unio Shell Ground Thin Unio Gill TS Unio Foot TS Unio Behind Foot Region TS Unio Body and Gill TS Glochidium Larva WM Ospheridium of Pila CS Redula of Pila CS Redula of Pila WM Sepia TS Through Eye Region Sepia Arm CS
XTEMOS ELEMENT

AJAX PRODUCTS TABS ALTERNATIVE

Fashion
Featured
  • Featured
  • Man
  • Woman

SPIRIT LAMP

Product description: Spirit Glass, with cap, wick and metal wick holder. Available in Hexagonal and round type Size:
60ml, Round Shape
125ml, Round Shape
125ml, Hexagonal Shape

Special Human Physiology Charts

Description

Poly art Charts are multi colored, accurate in details, printed on plastic, laminated on both sides, washable, non-tearable and long lasting, with plastic rollers, size 75 x 100 cm.

The Lymphatic System

Excretory System – Kidney, L.S. Excretory System – Ureters Excretory System – Urinary bladder Excretory System – Malpighian Corpuscle T.S. Skin Reproductive System Brain External Features L. S. Eye – Eye Muscle L. S. Eye – Tear glands L. S. Eye – Physiological diseases of eye Ear and its parts Skeletal System Endocrine glands Digestive System Circulatory System – Types of blood cells Circulatory System – L. S. in heart & T. S. in blood vessel Circulatory System – Vein valves Circulatory System – Systematic & pulmonary circulation Respiratory System – Larynx Respiratory System – Trachea Respiratory System – Alveolus L. S. in Central Nervous System (CNS) Region in which the nerves impulses transport to central nervous system through the synapse Human Reflection Arch

Flow Over Weir Or Open Channel Apparatus

Flow Over Weir Or Open Channel Apparatus: A ‘WEIR’ is the name given to concrete or masonry structure built across a river (or stream) in order to raise the level of water on the upstream side and to allow the excess water to flow over its entire length to the downstream side. Weirs may also be used for measuring the rate of flow of water in river or streams. Different shapes of “WEIRS” generally used are sharp-crested weir, broad­casted weir and ogee shaped weir. In the unit a centrifugal pump sucks the water from the sump tank, and discharges it to a small flow channel. The weir is fitted at the end of channel. All the weirs are interchangeable. The water-flowing over the weir falls in the collector. Water coming at from the collector can be directed to the sump or can be directed in to the measuring tank for measurement of flow.

SPECIFICATIONS:

[1] The unit is provided with following weirs: (a) Sharp-crested weir. (b) Broad-crested weir. (c) Ogee shaped weir. [2] Pump 1/2 H.P. monoblock. [3] Flow measurement – Measuring tank calibrated water flow meter is used. A technical manual accompanies the unit.

SERVICES REQUIRED:

[1] Floor surface – 2.5 m x 1.5 m. [2] 230 v, 5 amp supply with earthing connection

Set of Springs

Closely wounded Steel extension springs with loops at both sides, dia 6 mm approx. Closely wound with loops at both sides, dia. 6 mm approx. wire of 19 swg. Length 150 mm, Extension 230 mm average for 200g load
XTEMOS ELEMENT

AJAX PRODUCTS TABS ARROWS PAGINATION

shirt-tab
Electronics
Featured
  • Featured
  • Mobile
  • Smartwatches

Tubing, Rubber

Soft, Red in colour. For low pressure laboratory work. Resistant to dilute acid, alkalis, ammonia etc. Roll of 10 Metres

Bore Approx. (mm)Wall Thickness (mm)
4.01 
5.01.5 
6.01.5 
7.01.5 
8.01.5 
9.02 
10.02 
12.02.5 

Spectrometer, Advanced

Description

Vernier reading to 30 seconds of arc. The 175 mm diameter scale is fixed. The table and telescope movements are completely independent of each other and read to 30 seconds of arc by means of double ended verniers and magnifiers. Both rotations have fine adjustment screws. Coarse adjustments can also be made by release of clamping screw. Collimator is mounted on a fixed pillar and is fitted with 175 mm fl. achromatic objective with 32 mm clear aperture and a laterally adjustable slit 6 mm long. Telescope is mounted on a movable pillar fitted with 175 mm fl. achromatic objective of 32 mm clear aperture and x 10 Ramsden eye-piece with a glass cross line graticule. Both the telescope and collimator have rack and pinion focusing and can be adjusted for leveling the axes of both units as well as for adjusting to the axis of rotation. Prism table is marked with lines to assist prism placement and has three table leveling screws. It also has an interchangeable clamping unit for the prism and diffraction grating. Complete with prism clamp, diffraction grating holder and a Tommy bar for adjusting optical axis, In case.

Typical Plant Cell

Description

A highly enlarged model, as seen under electron microscope, a portion of wall is removed to show ectoplast, endoplast, tonoplast, vacuoles, nuclear structure, plastids, mitochondria etc. mounted on base with key card.
XTEMOS ELEMENT

AJAX PRODUCTS TABS WITH ICONS

Furniture
  • Furniture
  • Lighting
  • Accessories
  • Clocks
  • Cooking

Light Reflection and Refraction Set

Description

This optical kit helps students easily study these two important wave properties: Reflection and Refraction. Set made up of a wooden and rotating platform. base triangular stand made up of a disc and a rotating arm. The rotating platform provides a high degree of accuracy when making measurements as well as provides an easy way to change angles without disturbing the light source.

Carburetors Actual Cut Section

This model helps the student to understand the working of carburetor very easily. It is specially made dissectible for demonstration purposes. (A) Mikuni Car Type (B) Solex Type (C) Scooter Type (D) Motor Cycle Type

Animal Cage

Description

Made of iron S.S frame provided with thick iron mesh on sides. Hinged door on front. Provided with water bottle and feeding tray. Extra drawer provided in the base for collection of excreta. Well painted for elegant looking Feeding arrangement allows removal of bin from outside of cage with automatic drop closure. Size 30x23x30cm Size 45x45x38cm

Specimen Jar

We have come up with a quality range of Specimen Jars. These transparent Specimen Jars are used for preserving different specimens in the lab and are provided with a cap that fits in tight. These jars provided excellent protection to the species preserved in it. Material : Polystyrene
ParticularsPack (Pcs) 
Specimen Jar (Gas Jar)12 
XTEMOS ELEMENT

AJAX PRODUCTS TABS LOAD MORE PAGINATION

Featured
  • Featured
  • Lighting
  • Accessories

SILICA CRUCIBLE WITHOUT LID

PRODUCT DESCRIPTION
  • Crucible is glazed inside and outside.
  • Highly resistant to alkalis and hot temperatures
  • 50ml capacity
  • Outside diameter 55mm, 42mm height
  • No lid includedSilica crucible is glazed inside and outside. Highly resistant to alkalis and hot temperature SIZES ARE: 15ML 25ML 50ML 80ML 100ML 150ML

SILICA CRUCIBLE TALL FORM Without Lid, Translucent

PRODUCT DESCRIPTION -Without lid, translucent, glazed - Ordinary type lids to be purchased separately Size/ dimension:
  • 20ml,  Dia. 35mm x Ht. 38mm
  • 30ml, Dia. 43mm x Ht. 38mm
  • 50ml, Dia. 51mm x Ht. 51mm

SILICA MUFFLE TRAYS (For VM Crucible)

PRODUCT DESCRIPTION:   Available in 2types:  Two Hole, 39mm Length Four Hole, 76mm Length
XTEMOS ELEMENT

AJAX PRODUCTS TABS CAROUSEL

Featured
  • Featured
  • Cooking
  • Furniture