XTEMOS ELEMENT
AJAX PRODUCTS TABS
Photo Gates & Leads
These pair of photo gates is housed in tough moulded cases giving them excellent durability.
The lamps operate on 6 Volts with a special built in circuitry which prevents lamps from damage in case higher voltage is applied accidently.
The photo gates can be connected by 4 mm. sockets to a timer and power supplies.
Transmission Line Trainer
This trainer is designed for study of co-oxial cable characteristics like Impedance measurement, VSWR measurement etc., It is based, i) The latest technology of DDS Based RF source. ii) Directional coupler for VSWR Measurement. iii) TDR to measure the cable fault.
Specification
• DDS RF Source - Frequency: 10 to 400MHz. - Step Size: 1KHz. - Direct Digital Synthesis (DDS) Method Based. - Since DDS Device is primarily digital, it offers. • Display: Graphics LCD display of 240x128 pixels with backlight to plot VSWR, TDR characteristics etc., • One directional coupler provided for VSWR, Return loss measurement. • In-Built RF Detector for 10-400MHz Frequency range. • In-Built TDR (Time Domain Reflectometer) to measure and study nature of discontinuation in the co-axial cable. • Output Impedance: 50 ohms. • Co-axial cable: Various lengths of 50 ohm, 75 ohm cables supplied. • All relevant waveforms are displayed graphically in the Graphics LCDSynchromesh Gear Box 4 Forward 1reverse With Clutch Plate
Synchromesh Gear Box – 4 Forward & 1Reverse Actual Cut Section With Single Plate Clutch
The working of gear box is shown with the help of actual parts assembled on square iron pipe frame. All the necessary parts of gear box are shown in actual working form. This model helps the student to understand the working of the gear box very easily. It is specially made dissectible for demonstration purposes.
XTEMOS ELEMENT
AJAX PRODUCTS TABS SIMPLE
Magnetic Stirrer with Hot Plate
Maximum speed 1200 RPM.
Suitable for stirring all volumes, supplied with a teflon coated magnetic stirring bar.
Particulars
Magnetic Stirrer with Hot Plate, Volume 2 litre Magnetic Stirrer with Hot Plate, Volume 5 litreFeatures
Automation Type : Automatic Material (Body) : Mild Steel Material (Top Plate) : Stainless Steel Phase : Single Phase Power : 220 V Frequency : 50 HzConical Bottom Centrifuge Tube
Centrifuge tubes with conical bottom are available in two sizes i.e 15 ml. & 50 ml.
Moulded in Polypropylene, these tubes are clear, strong & safe.
These autoclavable tubes are provided with printed graduations on the outer surface.
The built in seal ring in the cap makes these tubes absolutely leakproof.
These tubes can withstand forces upto 7500xG & 12000xG for 15 ml. & 50 ml. tubes respectively.
| Particulars | Pack (Pcs) | |
|---|---|---|
| Centrifuge Tube Conical Bottom - 15 ml | 100 | |
| Centrifuge Tube Conical Bottom - 50 ml | 100 | |
| Centrifuge Tube Box for 15 ml tube | 4 | |
| Centrifuge Tube Box for 50 ml tube | 4 |
Digit Counter Micrometer (DCM)
Description
Micrometer is used to measure short lengths accurately Technical Details : Printed Marking on the Vernier Scale Carbide Tipped Measuring Faces Blue Metallic Finish Frame With Locking Clamp and ratchet stop Least Count : 0.01mm With Digit Counter to withstand abuse at work Sizes : 0-2 25-5 50-7 75-100 Specifications: Guarantee ; 6 Months without abuse Packing ; Plastic Box Calibration ; In house.XTEMOS ELEMENT
AJAX PRODUCTS TABS ALTERNATIVE
Fashion
Ohm’s Law Appartus
Description
To demonstrate Ohms Law. Consisting of a wooden enclosure with milliammeter, voltmeter, rheostat, push key and terminal posts. Requires an external battery (not supplied) and a suitable resistance (not supplied). Resistance can be calculated using Ohm’s Law by noting current and voltage. A rheostat is provided to control current flow. Circuit diagram is provided on the panel with instructions.Balance Spring
Millikan’s Oil Drop Apparatus
XTEMOS ELEMENT
AJAX PRODUCTS TABS ARROWS PAGINATION
Friction In Pile Lines Apparatus
DESCRIPTION:-
The Set-up consists of 2 pipes of different diameters, which are connected in parallel. Pressure tapings are provided on each pipe to measure the pressure losses with the help of a Differential Manometer. Control valves are fitted on each pipe, which enables to use one pipe at a time for experiment. Present set-up is self-contained water re-circulating unit, provided with a sump tank and a centrifugal pump etc. Flow control valve and by-pass valve are fitted in water line to conduct the experiment on different flow rates. Flow rate of water is measured with the help of measuring tank and stop watch.EXPERIMENTS:-
Ø To determine the losses due to fiction in pipes Ø To determine the friction factor for Darcy Weis back equationUTILITIES REQUIRED: –
Ø Water Supply & Drain Ø Electricity Supply: Single Phase, 220 VAC, 0.5 kWTECHNICAL SPECIFICATION: –
Ø Pipes (2 Nos.) : Material GI of ½ “ & 1” Diameter Ø Pipe Test Section : Length 1 m Ø Water Circulation : FHP Pump, Crompton / Sharp make Ø Flow Measurement : Using Measuring Tank with Piezometer,Capacity 25 Ltrs. Ø Sump Tank : Stainless Steel, Capacity 50 Ltrs. Ø Stop Watch : Mechanical / Electronic Ø Control Panel : On / Off Switch, Mains Indicator etc. The whole Set-up is well designed and arranged in a good quality painted StructureHuman Kidney With Adrenal Gland
Refrigeration Trainer Domestic Type
The unit enables students to study the various parameters affecting the performance of a domestic refrigerator. It consists of refrigeration cycle of domestic refrigerator, it consists a hermetically sealed compressor, air-cooled condenser, capillary tube and a natural convection type evaporator. The evaporator is fitted with a small heater to simulate different load conditions various measurements are provided so that power consumption, COP, theoretical and actual refrigerating effects refrigerant flow rate and effect of door opening on power consumption can be studied and also students can visualize automatic operation of unit using a thermostat.
SPECIFICATIONS:
1.Compressor – Hermetically sealed, Kirioskar make having capacity of approx. 1/25 ton of refrigeration. 2.Air – cooled condenser with natural convection airflow. 3.Capillary tube of matched length as expansion device. 4.Evaporator coil with an electric heater inside and adequate glass wool insulation on all side. 5.Measurement a)Energymeter Tore compressor input power measurement. b)Pressure gauge for condensing and evaporating pressure. c)Flow meter for liquid refrigerant flow d)Digital Temperature indicator for measurement of temperature 6.safety & Controls a)High & low pressure cutout. b)Thermostat. c)Necessary Switches. A technical manual accompanies the unit. Also, the unit is provided with an attractive and rust proof powder coating.SERVICES REQUIRED:
1.Floor space of 2m x 1m. 2.230V AC stabilized supply with earthing connectionXTEMOS ELEMENT
AJAX PRODUCTS TABS WITH ICONS
Emissivity Measurement Apparatus
The apparatus consists of a test plate and a comparator. A black plate is used as a comparator for test plate. When all the physical, dimensions and the temperatures are equal, heat losses from both plates will also be the same, except radiation losses. Hence the input difference will be due to difference in emissive. Both the plates are kept in a panel enclose with perplex front and are given inputs through separate dimmerstats so that temperatures of both can be kept equal. Thus emissivity can determine over a wide range of temperatures.
SPECIFICATIONS:
1.Test plate and Black plates — 160mm. Dia. Aluminum plates, mounted in Panel with mica heater inside. 2.Instrumental panel consisting of- a)Voltmeter and ammeter for input measurement to both heaters through a selector switch. b)Separate dimmers for both the plates. c)Multichannel digital temperature indicator. A technical manual accompanies the unit.SERVICES REQUIRED:
1.Space area of 1.5m x 1 m. at working height. 2.230v, 15A, AC supply with earthing connectionPorcelain Crucible
Description
Porcelain Bottom Crucible with porous disc permanently formed into walls. Porcelain Crucible, which we offer, is featured by stable porosity and rate of flow. These Porcelain Crucibles are made available with very fine (1.2 micron), fine (5 micron) and medium (15 micron) pore diameters discs. Maximum operating temperatures for Porcelain Bottom Crucible range from 900Â °C to 1200Â °C depending upon ceramic composition selected. Further, variation in temperature will not affect characteristics within their working temperature range.Capacity
15 ml 25 ml 30 ml 50 mlResistance Demonstration Set
Set of Springs
XTEMOS ELEMENT
AJAX PRODUCTS TABS LOAD MORE PAGINATION
SILICA CRUCIBLE WITHOUT LID
PRODUCT DESCRIPTION
- Crucible is glazed inside and outside.
- Highly resistant to alkalis and hot temperatures
- 50ml capacity
- Outside diameter 55mm, 42mm height
- No lid includedSilica crucible is glazed inside and outside. Highly resistant to alkalis and hot temperature SIZES ARE: 15ML 25ML 50ML 80ML 100ML 150ML
SILICA CRUCIBLE TALL FORM Without Lid, Translucent
XTEMOS ELEMENT
















