XTEMOS ELEMENT
AJAX PRODUCTS TABS
Electronic Balance
Parallelogram of Forces Apparatus
Straight Joint
Brush, Cylinder
XTEMOS ELEMENT
AJAX PRODUCTS TABS SIMPLE
Adjustable Tuning Fork
Alumina Crucibles
Resistance Box
Description
Resistance Box kit is an excellent device, which provides a very good learning technique in making different combinations of resistances, either in series or in parallel or in both ways to obtain the desired value of resistance for any circuit application. It consists of 10 resistors of equal values, i.e., 10Ω , 2 watts. These resistances are of ± 1% tolerance
XTEMOS ELEMENT
AJAX PRODUCTS TABS ALTERNATIVE
Fashion
Skeleton Model, Miniature
Plant Mitosis
Behaviour Of Column Struts Apparatus
Apparatus consist of four spring steel columns which are put along a vertical wooden board. These four columns have different end conditions as below:
1. Both ends pinned
2. Both ends fixed
3. One end pinned and other fixed
4. One end fixed and other end free
Apparatus to be supplied should be complete with a supporting stand and a set of weights.
XTEMOS ELEMENT
AJAX PRODUCTS TABS ARROWS PAGINATION
Decade Inductance Box – 3 Dial
Insect Cage, Round Shape (Acrylic)
Bernoulli S Theorem Apparatus
DESCRIPTION:-
The Set-up is designed to verify Bernoulli’s Theorem experimentally. Set up consists of a one piece clear acrylic test section with convergent and divergent part section, supply tank, measuring tank, inlet water tank and pump for closed loop water circulation. The test section is connected to Piezometer tubes through pressure tapping at different locations on the section to demonstrate the Bernoulli’s Theorem. The flow rate of water is measured using measuring tank and stop watch provided.EXPERIMENTS:-
Ø To verify Bernoulli’s Theorem experimentally.FEATURES:-
Ø Clear test section Ø Closed loop water circulation Ø Compact & stand alone setup Ø Stainless Steel tanks and wetted parts Ø Superb Painted structure Ø Simple to operate & maintainUTILITIES REQUIRED: –
Ø Electricity Supply: Provide 230 +/- 10 VAC, 50 Hz, Single Phase electric supply with proper earthing (Neutral – Earth voltage less than 5 VAC) 5 A, three pin socket with switch for pump Ø Water Supply : Tap water connection ½ “ BSP, Distilled water @ 60 Ltrs. (Optional)TECHNICAL SPECIFICATION: –
Ø Test Section : Material Acrylic, Size Ø Inlet Tank : Capacity 20 Liters., Stainless Steel Ø Supply Tank : Capacity 70 Liters., Stainless Steel Ø Measuring Tank : Capacity 20 Ltrs. Fitted with Piezometer Tube & Scale Ø Piezometer Tubes : Material P.U. Tubes (9 Nos.) Ø Pump : FHP Capacity make Tullu/Crompton Graves Ø Piping : GI / PVC Size BSP Ø Stop Watch : Electronic Ø The whole Set-up is well designed and arranged in a good quality painted Structure.
MCT Box
MCT Boxes are moulded in polycarbonate and are therefore strong as well as autoclavable.
One size can hold 64 MCTs of 1.5 ml. & the other can hold 100 MXT's of 0.5 ml.
These MCT Boxes are designed to work at temperatures ranging from -190'C to + 121" C.
The transparent cover provides a good view of the contents inside & is numbered for better inventory control.
| Particulars | Pack (Pcs) | |
|---|---|---|
| MCT Box (Rack for 100 MCTs of 0.5 ml) | 4 | |
| MCT Box (Rack for 64 MCTs of 1.5 ml) | 4 |
XTEMOS ELEMENT
AJAX PRODUCTS TABS WITH ICONS
Mini Vertical Electrophoresis
AED Trainer
Description
The Laerdal AED Trainer 2 offers an affordable alternative for educating the layperson and healthcare provider in the effective use of an automated external defibrillator.Product benefits:
Educationally effective, offers all the essential features necessary for learning appropriate AED use and techniques. Affordable training through the simulation of the HeartStart FR2 AED in appearance and operation. Added instructor flexibility through unique control of the scenario selection by use of the remote control device. Flexible configuration of the device through a scenario builder program that allows the additional creation of custom training scenarios. Cost-effective operation through use of six C-cell batteries.Product features:
Ten pre-configured sudden cardiac arrest scenarios compatible with training programs developed by internationally recognized responder programs. Remote control (optional) for manual scenario selection pause/resume function, AED Trainer 2 volume control, motion artefact, low battery or replace battery, loose electrodes connection, shock able or non-shock able rhythms and error conditions that simulate the red X in the Heart Start FR2’s status display window. Designed for use with the AED Little Anne® and AED Resusci Anne® manikins with Laerdal LINK Technology by providing student feedback as to proper pad placement on the manikins. It can also be used with any other manikin where Laerdal Link Technology is not available. Proper pad placement required in order for the trainer to advance in the scenarios when used with the AED Little Anne or AED Resusci Anne manikins.
Electronic Ignition System Of An Automobile
Constant Pressure Air Thermometer
Description
Jolly's thermometer bulb connected via a 3-way stopcock to mercury tube. Sliding indicator on right hand limb with reservoir sliding on vertical clamping rod. Metal vessel to surround the bulb. Mounted on wooden stand, height 740 mm. All glass parts except reservoir are made of borosilicate glass.XTEMOS ELEMENT
AJAX PRODUCTS TABS LOAD MORE PAGINATION
SILICA CRUCIBLE WITHOUT LID
PRODUCT DESCRIPTION
- Crucible is glazed inside and outside.
- Highly resistant to alkalis and hot temperatures
- 50ml capacity
- Outside diameter 55mm, 42mm height
- No lid includedSilica crucible is glazed inside and outside. Highly resistant to alkalis and hot temperature SIZES ARE: 15ML 25ML 50ML 80ML 100ML 150ML
SILICA CRUCIBLE TALL FORM Without Lid, Translucent
XTEMOS ELEMENT
AJAX PRODUCTS TABS CAROUSEL
Expansion Apparatus
Description
Two cast metal uprights, height 18 cm, fitted with two nickel plated rods supporting expansion bar of length 38 cm. Expansion bar is fixed to one upright and moves a pointer on the other, when heated With scale reading 0 to 90°, supplied with one each, aluminium, brass and iron expansion bars. Comprising two castmetal uprights linked by a pair of parallel plated metal support rods and supporting an expansion bar at the top. Supplied with expansion bars. Comprising two cast-iron uprights, height 18 cm linked by two nickel plated rods supporting on expansion bar, length 38 cm fixed to one upright and resting on a friction pointer placed at the other. Supplied with scale reading 0 to 90 deg and one each of aluminium, brass and iron expansion bars.
Pipette Pump
fast release Pipette Pump for precise pipetting & zip quick emptying.
The Knurled thumb wheel can be rotated to draw up or dispense liquids while the releaser may be pushed in for zip-quick emptying.
The moulded chuck has silicon rubber coller inside to hold various pipettes of standard sizes.
The Pipette Pump resists acids & alkalis and can be easily disassembled for thorough cleaning.
Material : Acrylonitrile Butadiene Styrene
| Particulars | Pack (Pcs) | |
|---|---|---|
| Pipette Pump 2 ml | 12 | |
| Pipette Pump 10 ml | 12 | |
| Pipette Pump 25 ml | 12 |
Digital / Analog Training System
Solderless Breadboard has 1680 tie points. Provided with 2 Terminal strips and 4 Distribution strips. Built in DC Regulated Power Supply. DC Supply ± 5V/ 1 Amp. 0 to ± 15V DC (Variable), 1 Amp. Built-in Function Generator. . Waveform : Sine, Square and Triangle (with selector switch),
Frequency : 1 – 100 Hz Variable
Amplitude : Variable up to 10 V, TTL 5V p-p
Data Switches (Bounceless) – 8 No.
LED Display (buffered) – 10 No.
Clock Pulsar – 2 No.
Seven Segment Display with Decoder IC 7447 – 2 No.
Speaker 2.5 Dia. with sockets – 1 No.
BNC Plug with 2 mm Sockets – 2 No.
4 mm socket connected with 2 mm sockets – 2 No.
Interconnection leads having 2 mm plugs at one end – 10 No.
Interconnection leads having 4 mm plugs at both end – 10 No.
22 SWG Hook Up Wire of 20 cm length – 100 No.
Comprehensive User’s Manual – 1 No.
Input 220 V, 50 Hz. AC with On/Off indicator.
Slide Wire Wheatstone Bridge
Description
Consists of a resistance wire with a sliding contact and a strip of aluminum to provide two “arms” of the bridge for known and unknown resistance. Strips of heavy aluminum are provided with a single gap in each of two arms for the resistance. All components are mounted on a heavy sheet metal base with Instructions.
