XTEMOS ELEMENT
AJAX PRODUCTS TABS
Three Hinged Arch Apparatus
The mild steel model has a span of 100cm and rise 25cm, with hinges at supports and crown. One of the ends should rests on rollers. Along the horizontal span of the arch various points are marked at equidistant for the application of load. This being a statically determinate structure, the horizontal thrust developed under the action of any load system can be theoretically calculated and will also be measured directly by neutralizing the outward movement of the roller end. A dial gauge with 25mm travel (with magnetic base) may be supplied with the apparatus. Apparatus to be supplied should be complete with a supporting stand and a set of weights.
Elastically Coupled Beam Apparatus
Apparatus consists of a three parallel bar suspension system with elastic beam at their upper and lower ends. The upper ends of the two outer suspension rods are tied to a vertical wooden board while central suspension rod may be tied to the centre of another elastic beam supported at two outer ends only. Mild steel Apparatus to be supplied should be complete with a supporting stand and a set of weights.
Electronic Balance
XTEMOS ELEMENT
AJAX PRODUCTS TABS SIMPLE
Simple Circuits Kit
Description
To explain working of electricity by simple circuits. Students can create simple circuits and learn about electricity, currents, voltages, series circuits and much more. Kit includes: D cell battery holder, knife switch, 2 light bulb holders, 2 light bulbs, 5 alligator connector cords and instructional manual.
Rear Axial Assembly With Differential Gear
Rear Axial Assembly With Differential Gear Fully Floating Type – Actual Cut Section
The working of differential gear is shown with the help of actual parts assembled on square iron pipe frame. All the necessary parts of differential gear are shown in actual working form. This model helps the student to understand the working of the differential gear very easily. It is specially made dissectible for demonstration purposes.
Abney Level
Description
The Hand Level is a small, economical level for use with preliminary surveys to determine traveller way or cable way steel work elevations and other feasibility type site reconnaissance work. The Abney Level is very similar to a clinometer in that it is used to measure the value of a slope by means of arc measure and grade percentage.Specification of Abney Level
• Used to determine slope angle, tree heights etc • Graduated 0-+/-90 degrees, 0-+/-100% on a stationary arc • Vernier reads to 10 • Scale pointer incorporates friction thumb lock • Includes carry caseXTEMOS ELEMENT
AJAX PRODUCTS TABS ALTERNATIVE
Fashion
Pipette Stand, Wooden – Horizontal
Electric Motor Model
Solar System Model
2 Stroke Diesel Engine Sectional Working Model
XTEMOS ELEMENT
AJAX PRODUCTS TABS ARROWS PAGINATION
Linear Expansion Apparatus, Micrometer Screw Form
Description
A 500 mm long metal rod is supported in a plated brass tube with three tubules for steam inlet, outlet and thermometer. The tube is mounted on a stand with an adjusting screw at one end and a micrometer screw reading to 0.01 mm on the other, with terminals for connecting a bell or galvanometer to indicate contact. With copper, brass and iron test rods but without thermometer.
Smart Grid Simulator
Smart Grid Simulator (VPST - SGS - 01) is a convenient solution for studying the basic Architecture and the Real-Time Operation of Smart Grid, Which consists of i) 8 types of Generation ii) Transmission Line iii) Six types of loads iv) Communication through LCD and PC.
Specification
• Six different generating station (Up to 10 MW) - Wind, Solar, Diesel, Bio-Gas, Fuel-Cell &UtilityGrid. • Two separate Transmission Lines (5MW Each) – TL-1, TL-2. • Six different power consumers (Up to 10 MW)– Gen.Industry, Emergency, Urban Area, Rural Area, Cement, Chemical Industry. • Six analog pot-meters for the power consumption control. • Graphics LCD & Keypad based configuration & monitoring of smart grid. • On board LCD & PC based GUI for easy understanding of the smart grid operation. • Automatic Smart Grid Control algorithm implemented for transmission line control, over current relay & automatic load sharing/adjustment in case of over loading.
Hook’s Law Apparatus
Spectrometer, Advanced
Description
Vernier reading to 30 seconds of arc. The 175 mm diameter scale is fixed. The table and telescope movements are completely independent of each other and read to 30 seconds of arc by means of double ended verniers and magnifiers. Both rotations have fine adjustment screws. Coarse adjustments can also be made by release of clamping screw. Collimator is mounted on a fixed pillar and is fitted with 175 mm fl. achromatic objective with 32 mm clear aperture and a laterally adjustable slit 6 mm long. Telescope is mounted on a movable pillar fitted with 175 mm fl. achromatic objective of 32 mm clear aperture and x 10 Ramsden eye-piece with a glass cross line graticule. Both the telescope and collimator have rack and pinion focusing and can be adjusted for leveling the axes of both units as well as for adjusting to the axis of rotation. Prism table is marked with lines to assist prism placement and has three table leveling screws. It also has an interchangeable clamping unit for the prism and diffraction grating. Complete with prism clamp, diffraction grating holder and a Tommy bar for adjusting optical axis, In case.XTEMOS ELEMENT
AJAX PRODUCTS TABS WITH ICONS
Dissecting Microscope with Bull Lens
Specifications
Heavy stable round base, Focusing done by Rack & Pinion system, with stopper to limit the downward movement of the Eye piece towards stage. A adjustable holder is provided for moving magnifying lens over full area of the stage. It is easily replacable with Bull Eye Lens 80mm in dia. A plano concave mirror in fork mount for light reflection, sturdy removable hand rests and arrangement for inserting Black & white plate. Duly packed in wooden cabinet with the following optics:| Eye piece: | 10x & 15X and Bull Eye Lens 80mm dia. | |
| Stage size: | 100mm x 100mm |
Model AC DC Generator
XTEMOS ELEMENT
AJAX PRODUCTS TABS LOAD MORE PAGINATION
SILICA CRUCIBLE WITHOUT LID
PRODUCT DESCRIPTION
- Crucible is glazed inside and outside.
- Highly resistant to alkalis and hot temperatures
- 50ml capacity
- Outside diameter 55mm, 42mm height
- No lid includedSilica crucible is glazed inside and outside. Highly resistant to alkalis and hot temperature SIZES ARE: 15ML 25ML 50ML 80ML 100ML 150ML
SILICA CRUCIBLE TALL FORM Without Lid, Translucent
XTEMOS ELEMENT
AJAX PRODUCTS TABS CAROUSEL
Sliding Mesh Gear Box
Sliding Mesh Gear Box – Actual Cut Section
The working of gear box is shown with the help of actual parts assembled on square iron pipe frame. All the necessary parts of gear box are shown in actual working form. This model helps the student to understand the working of the gear box very easily. It is specially made dissectible for demonstration purposes.
