XTEMOS ELEMENT
AJAX PRODUCTS TABS
Botany Algae
Educational Equipments Manufacturer, Exporters & Suppliers - School Educational Equipments Manufacturers & Exporters of Educational Equipments for Lab.
Science Lab Products, Teaching Aids, Classroom Instruments, Educational Laboratory
| Nostoc WM | Nostoc Heterocyst | Oscillatoria WM |
| Chlamydomonas WM | Chara Veg. WM | Chara Reproductive |
| Chara Sexuals LS | Chlorella WM | Cladophora WM |
| Diatoms Mixed WM | Oedogonium Vegatative WM | Oedogonium Capcells WM |
| Oedogonium Nannandious WM | Spirogyra Vegetative WM | Ulothrix Vegetative WM |
| Ulothrix Reproductive WM | Volvox Colony WM | Volvox Daughter Colony WM |
| Ectocarpus Unilocular WM | Ectocarpus Unilocular WM | Ectocarpus Plurilocular WM |
| Focus Thallus TS | Fucus Male Conceptacle VS | Fucus Female Conceptacle VS |
| Sargassum Thallus (Leaf) TS | Sargassum Male Conceptacle TS | |
| Sargassum Female Conceptacle TS | Sargassum Bladder TS | Batrachospermum WM |
| Batrachospermum Fruiting WM | Polysiphonia Antheridial WM | Polysiphonia Cystocarp WM |
| Polysiphonia Tetrasporic WM | Polysiphonia Vegetative WM | Oedogonium Macrandrous WM |
| Vaucheria Vegetative WM | Vaucheria Reproductive WM | Spirogyra Scalariform Conj. WM |
| Spirogyra Lateral Conj. WM |
Test Tube Caps
The Test Tube Caps offered by us, come with a transparent polypropylene cap for test tubes, which proves to be an excellent protection to the contents of the tubes.
The grooves inside the cap tighten the fitting on the tube while the outer set in the tube making the combination a leak proof one.
Material : Polypropylene
| Particulars | Pack (Pcs) | |
|---|---|---|
| Test Tube With Screw Cap 16 x 100 mm | 500 | |
| Cap For Test Tube Ø 25 mm | 500 |
RF Signal Source with Detector
Specification
• 25 to 6000MHz RF synthesized signal generator. • Programmable attenuator 5, 10, 20, 30dBm up to 1.5GHz. • 40 x 2 LCD Display to display the frequency of the RF signal and RF signal level. • Output level : 0dBm +/2dB upto 1GHz, -5dBm, +/-2dB upto 3GHz, -10dBm, +/-3dB upto 6GHz. • Output impedance : 50 ohm. • One RF Power detector provided for 50 to 1000MHz frequency range and this output is measured • by an ADC and display on the LCD display. • 6 Keys keypad provided to select the desired frequency, attenuation level, Sweep mode. • Step size : 1MHz. • Connectors: - 2 Nos. of 'N' type connector for RF out and RF in. - One "BNC" type connector for RF detector output.XTEMOS ELEMENT
AJAX PRODUCTS TABS SIMPLE
Optical Bench, wooden
Description
A wooden base board with one meter scale divided into mm with following accessories: One each White face object and receiving screens each 150 x 100 mm with aperture mounted on wooden base with an index mark. Two plane mirrors 150 x 100 mm mounted as above. One lens holder V shaped, wooden. One needle vertically mounted in a short wooden rod on base. One candle holder on base. The components have the same optical center height.
Histology Set I
Set of 24 slides comprising
| Adipose tissue | Compact bone |
| Striated muscle, teased | Nerve cells isolated |
| Spinal cord | Aorta, artery and vein |
| Human blood smear | Liver |
| Pancreas | Pseudostratified caliated columnar epithelium of trachea |
| Stomach | Simple columnar epithelium |
| Squamous epithelium | Lleum |
| Duodenum | Human Scalp |
| Smooth muscle | Kidney |
| Ovary | Rat Testis |
| Lung | Injected small intestine |
| Effector nerve ending | Cardiac muscle |
Aluminum Calorimeter, with wooden box
Tubing, Silicon
XTEMOS ELEMENT
AJAX PRODUCTS TABS ALTERNATIVE
Fashion
Refractive Index of Water Apparatus
Level Process Controller
Features
• It is a miniature version and occupies less space. • A RF capacitance Level Transmitter is used to sense the tank level. • An Industrial standard electro pneumatic converter is used to control the control valve. • A Pneumatic control valve is used to control the Level of the tank. • A Process tank of 3 liter capacity with graduated level scale. • A Rust proof reservoir tank (SS) capacity of 8 liters. • A centrifugal pump is provided for water circulation. • An air Regulator cum filter of capacity (0-2.1) Bar is provided to regulate the Air pressure. • Bypass line provision is provided to avoid pump over loading. • Hand valve provision is provided to make the disturbance study. • All the water flow lines are fitted by SS pipes. • USB/Serial port data acquisition is provided.XTEMOS ELEMENT
AJAX PRODUCTS TABS ARROWS PAGINATION
Spectrometer, Standard
Description
Reads to 6 minutes of arc (0.1°) 170 mm diameter metal scale graduated 360° x 1°, independently rotatable, with locking screw, vernier attached to the telescope reads to 0.1° (6 minutes of arc). Collimator is mounted on a fixed pillar, with an achromatic objective of 150 mm focal length and 21 mm aperture, and has an adjustable slit 6 mm long. The telescope is on a movable pillar, with a fine adjustment screw, an achromatic objective of 170 mm focal length, 21 mm aperture, Ramsden eye-piece and glass crosswire graticule. Both collimator and telescope have spiral focusing system and have axis adjusting arrangement. The table has 3 leveling screws, with lines marked to assist prism placement. With prism and grating holders, one small screw driver and one Tommy bar for axis adjustment Without prism.
Dicot Root T.S.
XTEMOS ELEMENT
AJAX PRODUCTS TABS WITH ICONS
Pipes, Resonance Demonstration
XTEMOS ELEMENT
AJAX PRODUCTS TABS LOAD MORE PAGINATION
SILICA CRUCIBLE WITHOUT LID
PRODUCT DESCRIPTION
- Crucible is glazed inside and outside.
- Highly resistant to alkalis and hot temperatures
- 50ml capacity
- Outside diameter 55mm, 42mm height
- No lid includedSilica crucible is glazed inside and outside. Highly resistant to alkalis and hot temperature SIZES ARE: 15ML 25ML 50ML 80ML 100ML 150ML
SILICA CRUCIBLE TALL FORM Without Lid, Translucent
XTEMOS ELEMENT
AJAX PRODUCTS TABS CAROUSEL
Corcyra Egg Laying Cage
Description
Frame made of MDF sheet planks. Fine wire mesh provided on top and bottom fitted with 3mm dia hole wire mesh on one top, a rounded opening 3cm dia is provided which can be closed with wooden plug. On one side a rounded opening 11cm with an arrangement for drop clouser with the help of MDF sheet cover is provided for manually putting in/taking out the material. Size 35x25x18cm
Westminister Electromagnetic Kit
Description
A very effective and motivating learning aid in elementary electromagnetism. Consists of 8 anisotropic alloy magnets, 8 ceramic ferrite magnets, 4 steel magnet yokes, 6 plotting compasses, 4 hardboard formers to take compasses, 1 bottle iron filings 250 gm, 4 dispensers for iron filings , 4 double C-cores, 4 clips for C cores, 4 Aluminium rings, 4 Aluminium split rings, 4 armatures with axle tubes, 4 Aluminium axle rods, 8 split pins, 16 rivets, 4 formers for coils, 4 reels cello tape, 4 reels copper wire, 4 sheets white pasteboard, 4 plain postcards, 4 reels white cotton thread, 1 length latex rubber tubing, 4 each resistors 100 ohms and 10 ohms, 4 support bases, 10 MES bulbs, 8 MES bulb holders,1 wood clamp and 1 wooden block. With instructions.
Beaker (Polypropylene)
We are the renowned Exporter and Trader of high quality Beaker (Polypropylene).
These Polylab Beakers, molded in Polypropylene, have excellent clarity and very good chemical resistance.
These autoclavable Beaker (Polypropylene) have prominently raised graduations on the outer surface.
Pouring a solution becomes very convenient because of its tapered spout.
| Particulars | Pack (Pcs) | |
|---|---|---|
| Beaker 50 ml | 12 | |
| Beaker 100 ml | 12 | |
| Beaker 250 ml | 12 | |
| Beaker 500 ml | 12 | |
| Beaker 1000 ml | 6 | |
| Beaker 2000 ml | 6 | |
| Beaker (Euro Design) 25 ml | 12 | |
| Beaker (Euro Design) 50 ml | 12 | |
| Beaker (Euro Design) 100 ml | 12 | |
| Beaker (Euro Design) 250 ml | 12 | |
| Beaker (Euro Design) 500 ml | 12 | |
| Beaker (Euro Design) 1000 ml | 6 | |
| Beaker (Euro Design) 2000 ml | 6 | |
| Beaker (Euro Design) 5000 ml | 2 | |
| Beaker (Printed Graduation) 50 ml | 12 | |
| Beaker (Printed Graduation) 100 ml | 12 | |
| Beaker (Printed Graduation) 250 ml | 12 | |
| Beaker (Printed Graduation) 500 ml | 12 | |
| Beaker (Printed Graduation) 1000 ml | 6 | |
| Beaker (Printed Graduation) 2000 ml | 6 | |
| Beaker (Printed Graduation) 5000 ml | 2 | |
| Beaker (Printed Graduation) 10000 ml | 2 |
Multi-Functional Nursing Simulator (Male)
Description
Designed according to the demand of the clinical principles and the guidelines of nursing training. This multifunctional simulator could simulate an actual circumstance for practice. Multiple functions, rural practice, easy assembly, well shaped appearance and correct anatomical landmarks provides a very good training for practice.Features :
Head Care. Body care. Patient moving. Different lying pose. Bilateral and Unilateral oxygen inhalation. Atomization inhalation therapy. Nasal Feeding. Gastric lavage training. Intravenous Injection. Intramuscular Injection. Hypodermic Injection. Various fistula orifice washing practice. Male Catheterization. Male Bladder Washing. Enema Treatment. Simulator Assembly.
Refrigeration Trainer Electrolux Type
This type of refrigeration is usually used for domestic purposes only as it is complex in the construction and working. This type of refrigerator was developed in 1925 by Munters and Battzervan when they were studying at Royal Institute of Technology At Stockholm for their undergraduate course. This type of refrigerator was known as three fluid refrigeration system. The elimination of aqua pump from the absorption system with the complete absence of moving parts and work input. The main purpose of removing the pump was to make the machine noiseless. It uses refrigerant as a solvent s and an inlet gas for inlet of the system. The inert gas is continued to the lower side of system only by its system. It is possible to maintain the uniform pressure throughout the system and after sometime permitting the refrigerant to evaporator at low temperature corresponding to its partial pressure. In the high pressure side system (generator and condenser), there exists only the refrigerant which is subjected to total pressure of the system so that it is condensed by using normal cooling water as air as it is done in other system.
The strong aqua ammonia solution is heated in generator by the application of external heat source. The water vapor carried with ammonia vapor is removed in separate form as shown in figure. Then the dry ammonia vapor is passed into the condenser and it is condensed by using external cooling source. The liquid ammonia flows under gravity in the evaporator and it evaporates. The mixture of hydrogen and ammonia vapor is passed into the absorber and the weak solution from aqua ammonia from the separator is allowed to follow into the absorber, through tray this weak aqua ammonia solution comes into contact with hydrogen separated. This strong solution is further passed to the generator and it completes the cycle.
Pinned Joint Model
SPECIFICATION:
Model consists of hinged. Model will be able to demonstrate the qualitative behavior of the truss under load. As are very flexible, a compression members will easily it`s bucking i.e. It will curve of plain. The tension member however remains straight and tight. The student will therefore have a visual picture of the type of stresses i.e. Compressive or tensile that member of truss will carry under various positive of the load. In case of pinned joint truss, the student will be able to observe that angle between members at each joint undergo a small change.
