XTEMOS ELEMENT
AJAX PRODUCTS TABS
Kidney With Bladder
Model Telescope
Transfer Case Assembly Actual Cut Section
Transfer Case Assembly – Actual Cut Section
The working of transfer case is shown with the help of actual parts assembled on square iron pipe frame. All the necessary parts of transfer case are shown in actual working form. This model helps the student to understand the working of the transfer case very easily. It is specially made dissectible for demonstration purposes.
XTEMOS ELEMENT
AJAX PRODUCTS TABS SIMPLE

Ruhmkorff Coil
Description
Ruhmkorff Coil produces pulses of high voltage spark from low voltage DC source (6 – 12 V DC). It is suitable for use with gas-filled discharge tubes, vacuum tubes, eudiometers and for general laboratory work. Includes an adjustable vibrator system, primary current polarity reversal, on-off switch, a capacitor enclosed in the box and special alloy contacts. Spark gap at the discharge points can be adjusted by sliding rods back and forth. Spark Length 15 mm.Thermistor Unit
Critical Heat Flux Apparatus
The apparatus demonstrates the regimes of pool boiling. The test section consists of a test wire surrounded by water of constant temperature. The surface temperature of the test wire is heated by passing current through it. Due to the temperature difference between the wire surface and surroundings, the difference regimes are observed till the burnout point.
Specifications:
1.Test wire -35 gauge or 40 gauges. Length = 10cm. 2.Nichrome heater- 1 kw capacity – 1 nos. 3.Glass trough of sufficient capacity. 4.Table light to observe the test wire. 5.Voltmeter and ammeter to measure the input to the test wire. 6.Dimmerstat to adjust the voltage. A technical manual accompanies the unit.SERVICES REQUIRED:
1.220v, ISA, stabilized single-phase supply. 2.Floor surface- 1m x 1m at working height.Hot Air Oven
Specification | : | Hot air oven, 2 shelves |
---|---|---|
Technical Specifications | : | |
Inside Body | : | Stainless Steel |
Out Side Body | : | MS Powder coated with stove enamel paint. (SS body also available) |
Number of Selves | : | 2 Adjustable Perforated Selves. |
Body Structure | : | Double Walled structure filled with glass wool insulation |
Number of Heaters | : | 2 x 1000 Watts |
Heater Quality | : | High Quality Chrome Heater insulated with ceramic beads |
Air Circulation | : | By Air Circulating Fan to ensure even temperature distribution. |
Ventilation | : | Ventilation port with adjustable Opening. |
Temperature Control | : | By Digital Temperature indicator and Controller |
Temperature Display | : | Digital Temp. display |
Range of Temperature | : | Ambient to 250ºC |
Accuracy | : | 0.10C |
Least Count | : | 1.0C |
Power | : | 220 Volt AC 50 Hz. Single Phase |
Sizes available are | : | 12" x 12" x 12" (28 Ltr.)14" x 14" x 14" (45 Ltr.)18" x 18" x 18" (95 Ltr.)24" x 24" x 24" (224 Ltr.) |
XTEMOS ELEMENT
AJAX PRODUCTS TABS ALTERNATIVE
Fashion
Brush, Cylinder
XTEMOS ELEMENT
AJAX PRODUCTS TABS ARROWS PAGINATION

Pressure Process Station
Panel Features
• Digital Panel Meters. • Mimic diagrams. • Pressure gauges are provided, wherever necessary.Softwares
• MATLAB • LabVIEW • PLC • C/VB CompatibilityFeatures
• The Pressure process station is an attractive module comparing to the Analyzer and Laboratory trainer. • All are the industrial standard (4-20)mA interfacing signals. • It provides a real industrial feeling of the process to the students. • A Piezo Resistive Pressure Transmitter (0-7)Bar is used to sense the pressure. • An Electronic Regulated Power supply is fixed for voltage Regulation. • An electro pneumatic converter is mounted to control the pneumatic control valve. • A globe Pneumatic Control Valve for controlling flow of air. • An air regulator cum filter is provided for Air regulation. • A two separate pressure tank is provided as process tank with pressure gauges and relief valves. • All the air flow lines are fitted by flexible hoses/fittings for better reliability. • Hand valve provisions are given for series, parallel connection of pressure tanks. • USB/Serial port data acquisition is provided.Critical Heat Flux Apparatus
The apparatus demonstrates the regimes of pool boiling. The test section consists of a test wire surrounded by water of constant temperature. The surface temperature of the test wire is heated by passing current through it. Due to the temperature difference between the wire surface and surroundings, the difference regimes are observed till the burnout point.
Specifications:
1.Test wire -35 gauge or 40 gauges. Length = 10cm. 2.Nichrome heater- 1 kw capacity – 1 nos. 3.Glass trough of sufficient capacity. 4.Table light to observe the test wire. 5.Voltmeter and ammeter to measure the input to the test wire. 6.Dimmerstat to adjust the voltage. A technical manual accompanies the unit.SERVICES REQUIRED:
1.220v, ISA, stabilized single-phase supply. 2.Floor surface- 1m x 1m at working height.XTEMOS ELEMENT
AJAX PRODUCTS TABS WITH ICONS
Wooden Levelling Staff Telescopic type
Description
We bring forth an impeccable array of Wooden Leveling Staff to eminent customers. Products that we come up are ideally used to cater to the various needs and preferences of customers of various construction industry along with others. Therefore, this range is quality tested as per industry laid parameterst.Hypsometer, Regnault’s
Description
Double walled copper cylinder, 340 x 60 mm, mounted on steam boiler, with thermometer tubule at top and side outlets for manometer and draining. Double walled copper cylinder 34 x 6 cm mounted on steam boiler. Fitted with thermometer, draining tube and glass manometer with rubber bungs. For the determination of the upper fixed points of thermometers andboiling points at barometric pressures other than atmospheric. Double walled copper cylinder 34 x 6 cm height x outer dia. mounted on steam boiler. Fitted with thermometer tubulure at the top, side outlet draining tube and glass manometer mounted in tubulure with rubber bungs.Digital / Analog Training System
Solderless Breadboard has 1680 tie points. Provided with 2 Terminal strips and 4 Distribution strips. Built in DC Regulated Power Supply. DC Supply ± 5V/ 1 Amp. 0 to ± 15V DC (Variable), 1 Amp. Built-in Function Generator. . Waveform : Sine, Square and Triangle (with selector switch),
Frequency : 1 – 100 Hz Variable
Amplitude : Variable up to 10 V, TTL 5V p-p
Data Switches (Bounceless) – 8 No.
LED Display (buffered) – 10 No.
Clock Pulsar – 2 No.
Seven Segment Display with Decoder IC 7447 – 2 No.
Speaker 2.5 Dia. with sockets – 1 No.
BNC Plug with 2 mm Sockets – 2 No.
4 mm socket connected with 2 mm sockets – 2 No.
Interconnection leads having 2 mm plugs at one end – 10 No.
Interconnection leads having 4 mm plugs at both end – 10 No.
22 SWG Hook Up Wire of 20 cm length – 100 No.
Comprehensive User’s Manual – 1 No.
Input 220 V, 50 Hz. AC with On/Off indicator.
XTEMOS ELEMENT
AJAX PRODUCTS TABS LOAD MORE PAGINATION
SILICA CRUCIBLE WITHOUT LID
PRODUCT DESCRIPTION
- Crucible is glazed inside and outside.
- Highly resistant to alkalis and hot temperatures
- 50ml capacity
- Outside diameter 55mm, 42mm height
- No lid includedSilica crucible is glazed inside and outside. Highly resistant to alkalis and hot temperature SIZES ARE: 15ML 25ML 50ML 80ML 100ML 150ML
SILICA CRUCIBLE TALL FORM Without Lid, Translucent
XTEMOS ELEMENT