XTEMOS ELEMENT
AJAX PRODUCTS TABS
Bulk Density Apparatus
Crucible with Lid High Form
Description
Chemical porcelain crucibles are glazed inside and out, except outside bottom and rim. Crucible covers are completely glazed except for rim. For use in temperatures up to 1150 C (2102 F). Not recommended for minerals or metals.Capacity :
100mlHeight :
2.13 inch (54mm)Top Outside Diameter :
2.56 inch (65mm)
Test Tube PEG Rack
We bring forth supreme Test Tube PEG Rack for our clients.
Our range of Test Tube PEG Rack has been highly appreciated for its quality.
These can conveniently hold inverted tubes for drying purpose and minimizes collections of airborne contaminants inside the tube.
This rack can also be used to hold and dry electrophoresis and chromatography plates.
Material : Polypropylene
| Particulars | Pack (Pcs) | |
|---|---|---|
| Test Tube Peg Rack-96 Places for 13mm Tubes | 6 | |
| Test Tube Peg Rack-50 Places for 16mm Tubes | 6 |
XTEMOS ELEMENT
AJAX PRODUCTS TABS SIMPLE
Ball & Ring GRAVESANDE
Verification Clarke S Maxwell Reciprocal Theorem
Apparatus for Verification of Clarke’s Maxwell Reciprocal Theorem
Apparatus consist of a mild steel beam 100cm long and 1.25cm x 4mm in cross section with graduations at every 10cm along the length. It should be supported on two knife edge supports 70cm apart with a 30cm overhang on one side. Reciprocal theorem can be verified by direct measurements of the deflections of various points with the help of a dial gauge due to a load placed at the reciprocal points. A dial gauge with 25mm travel (with a magnetic base) should be supplied with the apparatus. Apparatus to be supplied should be complete with a supporting stand and a set of weights.
Experimental Capabilities: To verify Clerk’s Maxwell reciprocal theorem by means of a mild steel be
Plantation Pots
Plantation Pots, moulded in polypropylene, are available in four different sizes.
The Plantation Pots have a downward extended rim, which provide convenient lifting even if the pot is filled.
The bottom of the pot is provided with holes for drain purpose.
Material : Polypropylene
| Particulars | Pack (Pcs) | |
|---|---|---|
| Plantation Pots 100 mm | 20 | |
| Plantation Pots 150 mm | 20 | |
| Plantation Pots 200 mm | 20 | |
| Plantation Pots 250 mm | 20 |
XTEMOS ELEMENT
AJAX PRODUCTS TABS ALTERNATIVE
Fashion
Steam Power Plant Trainer
Introduction:
Steam Power Plant Working Unit – This Unit Helps The Students To Understand The Complete System Of A Thermal Power Plat. 1.Heat Energy Converts Water Into Steam 2.Steam Pressure When Moves A Engine Or Turbine Produces Mechanical Energy 3.Finally Mechanical Energy Is Converted Into Electricity Through AlternatorParts Details Of Boiler:
1.Boiler — For The Generation Of Steam We Have Provided Electrically Heated Boiler. 2.Diameter Of Boiler – 400 mm 3.Length Of Boiler – 600 mm 4.Heater 2 Pcs. – 3 KW (Each)
Specific Gravity Specimen Cylinders with Hooks
Arteries With Heart Models
We offer arteries with heart models that are widely used to explain the function of artery and hearts to the students.
Our models provide the best way of understanding the functions of these parts, which are explained with the help of different colour combination.
These models are mostly used in school and colleges so that students are able to understand the function of these parts in the effective manner.
XTEMOS ELEMENT
AJAX PRODUCTS TABS ARROWS PAGINATION
Multiple Input/Output Process Trainer
Panel Features
• Power ON/OFF switch • Heater selection switch • Heater and pump indicators • High current fuse carrier for • Heater protection • Provision to run the stirrer • Digital panel meters • Two numbers of industrial PID Controller • Electrical test points are provided to measure the current signal • Mimic DiagramFeatures
• Two numbers of flow Transmitter (DPT) are provided to sense the flow of the liquid. • Three numbers of temperature transmitter (RTD) are provided at various stages to measure the temperature. • Five numbers of level sensor (RF capacitance) are provided to sense the level of each tank. • Industrial type Conductivity sensor is provided to analyze the conductivity of given Solution. • RTD sensor (or) Thermocouple acts as a temperature sensor. • Digital panel meters are provided to indicate the output of each sensor. • Provision to measure the conductivity. • Two numbers of motorized control valve or pneumatic control valve are provided to control the flow of the pipe line. • A powerful thyristor based power driver is provided to drive the heater power. • An industrial type water heater is used as a heat Source. • Storage tank of 50 litre capacity (SS). • Process tank of 15 litre capacity (SS). • Four numbers of acrylic tank are provided to study the response of four tank systems. • In necessary location Ball valve, globe valve and needle valves are provided. • Two numbers of stirrer are provided in the temperature process and alkaline process. • Three numbers of centrifugal pump (FHP) is used to circulate the water from storage tank. • Six numbers of rotameter are provided in the process inlet to visualize the real flow. • Regulated power supply is mounted in the panel. • All the flow lines are fitted by (SS) pipe fitting. • An over head tank is provided to give constant flow. • All the equipments are mounted in a rugged and mobile type metallic work station.
VM CRUCIBLE with Lid 25mm Dia x 38mm ht.
Resistance Substitution Box
Description
Resistance Substitution Box is a convenient instrument for determining the desired resistance values in circuits under design or test. This resistance substitution box has 12 different values 100Ω , 220 Ω , 470 Ω , 1 kΩ , 2 kΩ, 4 kΩ , 10 kΩ , 22 kΩ , 47 kΩ, 100 kΩ , 220 kΩ and 470 kΩ . All resistors are precision 1% resistors and are of 1 watt rating Selected resistor can be attached in any circuit with 4 mm two red safety sockets.
XTEMOS ELEMENT
AJAX PRODUCTS TABS WITH ICONS
Magnetic Kit
Description
A kit of magnets and accessories in a storage tray.Contents :
1. One Horseshoe magnet, 100 mm, with keepers.Two ceramic bar magnets, 75 mm long. 2. Three ceramic ring magnets, 38 mm diameter 3. Two plotting compasses clear both sides, 19 mm diameter 4. One lodestone specimen. 5. One pack Iron Filing. 6. One each strip of Iron, Aluminium, Zinc and Copper metal.XTEMOS ELEMENT
AJAX PRODUCTS TABS LOAD MORE PAGINATION
SILICA CRUCIBLE WITHOUT LID
PRODUCT DESCRIPTION
- Crucible is glazed inside and outside.
- Highly resistant to alkalis and hot temperatures
- 50ml capacity
- Outside diameter 55mm, 42mm height
- No lid includedSilica crucible is glazed inside and outside. Highly resistant to alkalis and hot temperature SIZES ARE: 15ML 25ML 50ML 80ML 100ML 150ML
SILICA CRUCIBLE TALL FORM Without Lid, Translucent
XTEMOS ELEMENT
AJAX PRODUCTS TABS CAROUSEL
Manual Steering System
Steering System – Actual Working
Manual Steering System
The working of steering system is shown with the help of actual parts assembled on square iron pipe frame. All the necessary parts of steering system are shown in actual working form. This model helps the student to understand the working of the steering system very easily. It is specially made dissectible for demonstration purposes.
4 Stroke 1 Cylinder Diesel Engine Manual Driven
The engine will be sectioned to show the internal constructional details. The working of individual part and accessories like Valves, Pistons, pumps, Crank and Camshaft, etc. will be demonstrated. It is provided with Flywheel and it is mounted on a sturdy iron frame. This actual cut section engine helps the student to understand about the parts and the working of the engine very easily. It is specially made dissectible for demonstration purposes. The actual cut section engine will be supplied with key card & very interesting literature regarding working.
Distillation Plant (Manasty Type), Wall Hanging
The unit is recommended for making pyrogen fee distilled water of a very high degree of purity, Made out of S.S. special kettle element is fitted with Ejection Device / Auto cut for safety of the element is provided water supply is stopped.
The cork fitted to the unit is of brass C.P.A. wall Mounting clamp is provided with the unit.
Supplied with cord and plug to work on 220/240 volts A.C. Stainless Steel, Output approx. 3/4 Ltr./Hr.
Stainless Steel, Output approx. 5/6 Ltr./Hr.
Aluminium Dicasted, Output approx. 3/4 Ltr./Hr.
Aluminium Dicasted, Output approx. 5/6 Ltr./Hr.
Mini Rotary Shaker
Body made out of thick mild steel finished with powder coating.
PMDC motor used for shaking.
Platform size 300x300 mm. S.S. platform consists of 9x250ml conical flask lotus type clamps.
RPM range 50-250 RPM, Electronic variable control, with 0-60 min mechanical timer.
Mini Rotary Shaker
Workable on 220 V AC 50Hz single phase.
