XTEMOS ELEMENT
AJAX PRODUCTS TABS
Atomic Model Set
We present to you, Atomic Model Set.
The Atomic Model Set consists of moulded balls of different colors & sizes along with connectors of different sizes.
The sizes & shapes of the balls & connecting lugs have been designed in accordance with internationally acceptable standards.
Material : Polystyrene
| Particulars | Pack (Pcs) | |
|---|---|---|
| Atomic Model Set - Senior Set | 1 | |
| Atomic Model Set - Junior Set | 1 | |
| Atomic Model Set (Euro Design) - Student Set | 1 | |
| Atomic Model Set (Euro Design) - Teacher Set | 1 |
Ticker Tape Timer
For the measurement of velocity and acceleration, using timing marks made on a moving paper tape by a vibrating striker.
Designed to operate on a 12V A.C. supply and uses the mains frequency as its timing standard.
The unit is housed in a moulded case including mounting flanges.
The top of the case caries a tape guide which incorporates a carbon paper disc support and an adjustable anvil for the striker point.
All moving parts are fully enclosed and a pair of 4mm sockets are provided on the side of the case for connection of the electrical supply.
Supplied with a roll of self marking paper tape.
Paper tape : 100m of paper tape, 9.5mm wide.
Carbon Paper Discs : 40mm diameter, with 3mm hole, cut from long life plastic film type carbon paper.
Ballistic Galvano Meters
Description
Used for measurement of small quantities of electrical charge. Levelling Screws for balancing the coil. Coil with mirror suspended between long suspension at the upper end and a spring at lower end. Clamping arrangement for transportation. Consistent sensitivity over a large period. Strip provided for making it a periodic. Res. in Ohm Crit. Damp. Res. in Ohms Sensitivity mm per m Coul. Sensitivity mm per m Amp. Time period in Seconds.| 100 | 300 | 1000 | 12 | 2000 |
| 500 | 600 | 1400 | 12 | 3500 |
Clay Pipe Triangles porcelain
XTEMOS ELEMENT
AJAX PRODUCTS TABS SIMPLE
Metal Rivets, Brass
Description
Supplied as rivets. Pk of 500gms. Brass,lead,aluminium,iron, For specific heat capacity experiments. Supplied as rivets. Packets of 500 grams.300 mm long x 3 mm dia. Supplied in packets of ten rods. Copper,iron,lead,aluminium,brass 300 mm long x 3 mm dia. Supplied in packets of ten rods.
Artery models
Empowered with the perfect combination of trained men and modern machines, we are able to manufacture, supply and export a wide range of Artery models.
These products are used in different hospitals and medical centers for teaching students and physicians about the structure of arteries.
With the help of our diligent team of skilled personnel, we are able to provide a unmatched range of these products. Owing to our team of trained logistics professionals, we are able to provide the clients with the on time delivery of Artery models.
Model of Terrestrial Telescope
Synchromesh Gear Box 4 Forward 1reverse
Synchromesh Gear Box – 4 Forward & 1Reverse Actual Cut Section
The working of gear box is shown with the help of actual parts assembled on square iron pipe frame. All the necessary parts of gear box are shown in actual working form. This model helps the student to understand the working of the gear box very easily. It is specially made dissectible for demonstration purposes.
XTEMOS ELEMENT
AJAX PRODUCTS TABS ALTERNATIVE
Fashion
Emitting Diode (LED’s)
Bridge rectifier is designed with four LED’s internally arranged in bridge pattern fitted inside a plastic moulded case. Two LED’s are red and two LED’s are green. This device is used to demonstrate the functioning of a bridge rectifier, i.e., to convert alternating current (AC) into direct current (DC). Two yellow sockets are used for AC input. Two sockets, one red and one black, are used for DC output. For the easy understanding of the internal circuitry, the circuit diagram is printed on the box.
Advance Surgical Structure Leg
Description
This model of Advanced Surgical Suturing Leg allows the students to practice cut, suturing, stitches release, enswathing, etc. The elasticity and flexibility of skin can make it for practice hundreds of times. There are some initial wounds on the arm and if all the initial wounds have been sutured, people can cut the arm in other place for new training of suturing.
Tubing, Rubber, High Pressure
Animal Cage Polypropylene with S.S.Grill & with Water Bottle
Description
Animal Cage Polypropylene With S.S.Grill & Water Bottle. Mice / Rat breeding cage, Easy clean cage made of high grade polypropylene. Sufficient ventilation in the cage through Stainless steel wire top securely fixed to the cage with tight closing clips. Space in the grill for placing water bottle and food items. Size : 430 x 270 x 150 mm Size : 435 x 290 x 150 mm Size : 290 x 220 x 140 mmXTEMOS ELEMENT
AJAX PRODUCTS TABS ARROWS PAGINATION
Funnel Holder
The Funnel Holder offered by us is made of Polypropylene.
The corrosion free Funnel Holders can hold funnels with diameter 3" to 6".
The extra plate provided can be placed to hold funnels bearing diameter 1" to 3".
Two tapered wedges are provided to ensure firm grip on Rods having diameter ½" or 3/8".
Material : Polypropylene
| Particulars | Pack (Pcs) | |
|---|---|---|
| Funnel Holder - Single | 12 | |
| Funnel Holder - Double | 6 | |
| Seperatory Funnel Holder | 12 |
Crucible with Lid High Form
Description
Chemical porcelain crucibles are glazed inside and out, except outside bottom and rim. Crucible covers are completely glazed except for rim. For use in temperatures up to 1150 C (2102 F). Not recommended for minerals or metals.Capacity :
100mlHeight :
2.13 inch (54mm)Top Outside Diameter :
2.56 inch (65mm)
Meker Burner, with Stopcock
XTEMOS ELEMENT
AJAX PRODUCTS TABS WITH ICONS
General Science Charts
Description
Poly art Charts are multi colored, accurate in details, printed on plastic, laminated on both sides, washable, non-tearable and long lasting with plastic rollers, size 75 x 100 cm. Insects Reproduction of Plants (Part 1) Seed parts, Germination & Pollination Reproduction of Plants (Part II) Mendel’s Law, supply of Oxygen, Carbon Dioxide and Nitrogen. The Bird, Food, Beaks and Jaws Plants and their parts (Part I) Flower Plants and their parts (Part II) Root & Stem Types of Animals (Part-1) Paramecium, Amoeba, Hydra, Worm, Crayfish, Spider Types of Animals (Part -II) Fish, Amphibians, Reptiles, Birds and Mammals Foods and their uses Part-I Foods and their uses Part -II Plant Diseases and their control Animal Diseases and their control Human Body – all parts Germination of Seeds Classification of Plants Classification of Animals Oxygen Cycle Carbon Cycle Nitrogen Cycle
Car Chassis All Wheel Drive Actual Cut Section
Car Chassis Rear Wheel Drive Actual Cut Section – Motorised
4 Stroke 4 Cylinder Petrol Engine With Clutch, Gear Box, Propeller Shaft, & Rear Axle Assembly With Differential Gear
The chassis of the four stroke four cylinder engine cut section model. The cut section model is constructed such that all the following systems can be demonstrated in working conditions.
ENGINE:
Maximum parts and accessories of an engine like cylinders, cylinder head, inlet and Exhaust manifolds, FIP, injectors, self-starter, alternator, water pump, radiator, etc., are sectioned to show the internal constructional details. The complete sectioned model is coupled with FHP 220/230V A.C single phase motor through a Reduction drive unit.TRANSMISSION SYSTEM:
This system consists of a Clutch and four speed gearbox assembly, the casing of which is suitably cut to demonstrate its operation. The gearbox is coupled to Differential gear box with propeller shaft and the different coupling used for this transmission can be demonstrated. The Differential gear box is also cut so as to clearly to demonstrate its complete operating principle. The gear shifting including the forward and reverse gear operation can be clearly shown. The speed variation and the rotation of the Differential gear box can be seen while gear shifting. By running the motor connected to the engine assembly the entire system with gear box, rear axle etc. can be demonstrated in running. FUEL SYSTEM: The Fuel tank is cut to expose the mounting of the level sensor and the position of Fuel section. The system is complete with mechanical Fuel pump. EXHAUST SYSTEM: It consists of Exhaust Manifold and silencer in cut section to explain internal construction. LUBRICATION SYSTEM: It consists of the engine Lubrication system along with the Lubrication oil pump is suitably sectioned. SUSPENSION SYSTEM: This will explain both the Hydraulic Suspension systems at the front and the leaf spring Suspension at the Rear. One of the hydraulic arrangements of Suspension mechanism is highlighted (with shock absorbers) and explained cut sectionally.BRAKING SYSTEM:
The Hydraulic or Air circuit Brakes. The movement of the Brake Shoes on operating the brake pedals can be seen in the area where the Brake drum is cut. The front and rear brakes will be operational. STEERING MECHANISM: The can be seen and included in the Steering wheel. Steering gear box and coupling of the same to the wheels will be shown by rotating the steering wheel, the operation of the steering system can be demonstrated. The entire system will be mounted on the chassis, and suitable mounting option with caster wheels will be provided for easy movability.
IoT Gateways
Round Bottom Centrifuge Tube
Avail from us, a flawless variety of Round Bottom Centrifuge Tube , which is popular for its better quality and precise engineering.
Being one of the chief Exporter and Trader in this industry, the company provides Round Bottom Centrifuge Tube at the most competitive prices.
| Particulars | Pack (Pcs) | |
|---|---|---|
| Centrifuge Tube Round Bottom 16 ml (P.P) | 50 | |
| Centrifuge Tube Round Bottom 50 ml (P.P) | 50 | |
| Centrifuge Tube Round Bottom 16 ml (P.C) | 50 | |
| Centrifuge Tube Round Bottom 50 ml (P.C) | 50 | |
| Cap for 16 ml Centrifuge Tube Round Bottom | 100 | |
| Cap for 50 ml Centrifuge Tube Round Bottom | 100 | |
| Oak Ridge Centrifuge Tubes 30 ml | 12 | |
| Oak Ridge Centrifuge Tubes 50 ml | 12 | |
| Oak Ridge Centrifuge Tubes 100 ml | 12 |
XTEMOS ELEMENT
AJAX PRODUCTS TABS LOAD MORE PAGINATION
SILICA CRUCIBLE WITHOUT LID
PRODUCT DESCRIPTION
- Crucible is glazed inside and outside.
- Highly resistant to alkalis and hot temperatures
- 50ml capacity
- Outside diameter 55mm, 42mm height
- No lid includedSilica crucible is glazed inside and outside. Highly resistant to alkalis and hot temperature SIZES ARE: 15ML 25ML 50ML 80ML 100ML 150ML
SILICA CRUCIBLE TALL FORM Without Lid, Translucent
XTEMOS ELEMENT
AJAX PRODUCTS TABS CAROUSEL
Test Tube Caps
The Test Tube Caps offered by us, come with a transparent polypropylene cap for test tubes, which proves to be an excellent protection to the contents of the tubes.
The grooves inside the cap tighten the fitting on the tube while the outer set in the tube making the combination a leak proof one.
Material : Polypropylene
| Particulars | Pack (Pcs) | |
|---|---|---|
| Test Tube With Screw Cap 16 x 100 mm | 500 | |
| Cap For Test Tube Ø 25 mm | 500 |
Newton’s Color Disc
Description
To demonstrate the discovery made by Newton that white light is composed of seven colors. Consisting of a pulley mounted on a metal stand, the seven colored disc is driven by gears connected to a hand driven wheel. When the colored disc rotates, the eye can’t distinguish between individual colors and perceive it as white color.
Analgesiometer Tail Flick
Analgesiometer Tail Flick (Radiant Heat or Tail Flick Type): It provides pain stimulus by heated nichrome wire in a Rat's tail to determine analgesic effect of drugs.
Complete with one spare element to work on 220 A.C.
Features
Shutter operated lamp illumination system. Automatic or manual mode for detecting tail flick. Precise and reproducible results. PC Connectivity with software. Software with calibration and report generation feature. Software with auto experiment number and serial number feature. Software with provision to convert data in excel or pdf. Cut off timer to avoid damage to animal. Calibration mode using Heat Flux meter (optional device).
Petri Dish
These Petri Dish offered by us is clear, unbreakable, & autoclavable.
The PS Petri Dish with fitting proves excellent for culture exp.
Made in polystyrene, this transparent Petri Dish provides an excellent inside view.
Material : Polypropylene
| Particulars | Pack (Pcs) | |
|---|---|---|
| Petri Dish 50 mm | 36 | |
| Petri Dish 75 mm | 36 | |
| Petri Dish 100 mm | 36 | |
| Petri Dish 125 mm | 12 | |
| Petri Dish 150 mm | 12 | |
| Petri Dish (Culture) | 12 |
Pinned Joint Model
SPECIFICATION:
Model consists of hinged. Model will be able to demonstrate the qualitative behavior of the truss under load. As are very flexible, a compression members will easily it`s bucking i.e. It will curve of plain. The tension member however remains straight and tight. The student will therefore have a visual picture of the type of stresses i.e. Compressive or tensile that member of truss will carry under various positive of the load. In case of pinned joint truss, the student will be able to observe that angle between members at each joint undergo a small change.
