XTEMOS ELEMENT
AJAX PRODUCTS TABS
Human Kidney With Adrenal Gland
Separating Throttling Calorimeter
AIM
To find out dryness fraction of steam by combined separating and throttling calorimeter.
PRODUCT DETAILS
The steam passing out from separating calorimeter may still contain some water vapour , in it . in other words it may not be absolutely dry . again , in a throttling calorimeter steam after passing through the throttle valve must be superheated or at least dry saturated . this limits the extent of dryness fraction that can be reliably measured , depend up on the pressure of steam in the main steam pipe . if a sample of steam, which may be still wet after passing through the throttle valve i.e it will not be superheated . thus under this condition the throttling calorimeter fails to enable us in determining the value of dryness fraction of steam . to overcome this difficulties we make use of separating and throttling calorimeter . first the steam is passed through separating calorimeter where itlosses most of it’s moisture and becomes comparatively drier, it is than passed through the throttling calorimeter where super heating takes place with out changr of total heat . the temperature and pressure of steam after throttling are measured by using a thermometer and manometer respectively.DESCRIPTION
The set up consist of a separating and throttling calorimeter . a steam generator is provided at the base of the apparatus . a thermostat knob is provided at the front of apparatus to control the temperature inside the steam generator . steam from steam generator is passed from separating calorimeter where most of the water partical get separated from steam and then passed to throttling calorimeter where steam get superheated . after that superheated steam passed through heat exchanger to condense the steam.SAPARATING CALORIMETER
It consist of two concentric chamber , the inner chamber ,and the outer chamber . which communicates with each other through an opening at the top. As the steam discharge through the metal baskets ,which has a large number of holes , the water partical due to there heavier momentum get separated from the steam and collected in the chamber. The comparatively dry steam in the inner chamber moves up and than down aging through the annular space between the two chambers and enters the throttling calorimeter .THROTTLING CALORIMETER
It consist a narrow throat . pressure and temperature are measured by manometer and thermometer . the steam after throttling process passed through the heat exchanger and condensate is collected .UTILITIES REQURIED
1.WATER SUPPLY 3 lit/min (approx) 2.Drain 3.Electric supply : 1phase , 220 V A.C , 2Amp. 4.Steam table for calculation 5.Space required : 1.0 m X 1.0 m
Spectrometer, Advanced
Description
Vernier reading to 30 seconds of arc. The 175 mm diameter scale is fixed. The table and telescope movements are completely independent of each other and read to 30 seconds of arc by means of double ended verniers and magnifiers. Both rotations have fine adjustment screws. Coarse adjustments can also be made by release of clamping screw. Collimator is mounted on a fixed pillar and is fitted with 175 mm fl. achromatic objective with 32 mm clear aperture and a laterally adjustable slit 6 mm long. Telescope is mounted on a movable pillar fitted with 175 mm fl. achromatic objective of 32 mm clear aperture and x 10 Ramsden eye-piece with a glass cross line graticule. Both the telescope and collimator have rack and pinion focusing and can be adjusted for leveling the axes of both units as well as for adjusting to the axis of rotation. Prism table is marked with lines to assist prism placement and has three table leveling screws. It also has an interchangeable clamping unit for the prism and diffraction grating. Complete with prism clamp, diffraction grating holder and a Tommy bar for adjusting optical axis, In case.XTEMOS ELEMENT
AJAX PRODUCTS TABS SIMPLE
Metal Rivets, Brass
Description
Supplied as rivets. Pk of 500gms. Brass,lead,aluminium,iron, For specific heat capacity experiments. Supplied as rivets. Packets of 500 grams.300 mm long x 3 mm dia. Supplied in packets of ten rods. Copper,iron,lead,aluminium,brass 300 mm long x 3 mm dia. Supplied in packets of ten rods.
Orsted’s Apparatus
Suppository Mould
Animal Cage
Description
Made of iron S.S frame provided with thick iron mesh on sides. Hinged door on front. Provided with water bottle and feeding tray. Extra drawer provided in the base for collection of excreta. Well painted for elegant looking Feeding arrangement allows removal of bin from outside of cage with automatic drop closure. Size 30x23x30cm Size 45x45x38cmXTEMOS ELEMENT
AJAX PRODUCTS TABS ALTERNATIVE
Fashion
Stacking Counters
Porous Pot
Health
XTEMOS ELEMENT
AJAX PRODUCTS TABS ARROWS PAGINATION
francis turbine test setup
DESCRIPTION:
Francis Turbine is a reaction Turbine, which was developed by English born American Engineer Sir J.B. Francis. The water enters the turbine through the outer periphery of the runner in the radial direction and leaves the runner in axial direction and hence it is called a mixed flow turbine. As the water flows to the runner, a part of pressure energy goes on changing into kinetic energy. Thus the water through the runner is under pressure. The runner is completely enclosed in an air tight casing and the casing & runner is always full of water. The present Set-up consists of a runner. The water is fed to the turbine by Means of centrifugal Pump, radially to the runner. The runner is directly mounted on one end of a central SS shaft and other end is connected to a brake arrangement. The circular window of the turbine casing is provided with a transparent. The circular window of the turbine casing is provided with a transparent acrylic sheet for observation of flow on to the runner. The runner assembly is supported by thick cast iron pedestal. Load is applied to the turbine with the help of brake arrangement so that the efficiency of the turbine can be calculated. A draught tube is fitted on the outlet of the turbine. The Set-up is complete with guide mechanism. Pressure and vacuum Gauge are fitted at the Inlet and Outlet of the turbine to measure the total supply head on the turbine.UTILITIES REQUIRED:
● Water Supply and Drain.● Electricity 15 kW, 440V Ac, Three Phase
TECHNICAL SPECIFICATIONS:
| MODEL | HM 101 (1.33 HP) | HM 101 (2 HP) | HM 101 (5 HP) |
| Output Power | 1.33 HP / 1 Kw | 2 HP / 1 Kw | 5 HP / 3.75 Kw |
| Discharge | 1000 LPM (Approx.) | 1000 LPM (Approx.) | 2000 LPM (Approx.) |
| Supply Head | 10 m | 10 m | 15 m |
| Rope Brake Dynamometer | Dia 200 mm | Dia 200 mm | Dia 300 mm |
| Sump Tank | Capacity 300 Ltrs. | Capacity 300 Ltrs. | Capacity 600 Ltrs. |
| Water Circulation Centrifugal Pump | Capacity 5 HP, Three Phase | Capacity 5 HP, Three Phase | Capacity 15 HP, Three Phase |
| Speed | 1500 RPM (approx.) | ||
| Runner | Having Curved Vanes | ||
| Discharge Measurement | Pitot Tube with Manometer | ||
| Control Panel | Star/Delta Starter, Mains Indicator, MCB for overload protection | ||
| The whole set-up is well designed and arranged in a good quality painted structure. | |||
XTEMOS ELEMENT
AJAX PRODUCTS TABS WITH ICONS
BURETTE STAND
Horse Shoe Magnifier
Dental Care Model(With Cheek), PVC
Cell & Tissues
Description
All Charts are made on PVC rexine , hand drawn, waterproof, in fast multi colors with a black background. Each chart is provided with rollers to hang on wall. Size 75×100 cm.Typical Animal cell ultra structure
Animal Mitosis Animal Meiosis Animal Tissues I – Connected tissues Animal Tissues II – Epithelial and muscular tissues Animal Tissues III – Blood and nerve tissues Gamatogenesis Fertilization in Animals Ogenesis SpermatogenisisXTEMOS ELEMENT
AJAX PRODUCTS TABS LOAD MORE PAGINATION
SILICA CRUCIBLE WITHOUT LID
PRODUCT DESCRIPTION
- Crucible is glazed inside and outside.
- Highly resistant to alkalis and hot temperatures
- 50ml capacity
- Outside diameter 55mm, 42mm height
- No lid includedSilica crucible is glazed inside and outside. Highly resistant to alkalis and hot temperature SIZES ARE: 15ML 25ML 50ML 80ML 100ML 150ML
SILICA CRUCIBLE TALL FORM Without Lid, Translucent
XTEMOS ELEMENT
AJAX PRODUCTS TABS CAROUSEL
Chrysopa Breeding Nest
Description
Teakwood frame with silk screen net on sides and collapsible cover on side. Cover can be fixed in position with help of lever. Top sliding plank of MDF covered with black cloth from inside and spirit polished from outside. A sapre plank supplied for replacement. Combs for removal of insect from plank. Beautiful spirit polish finish. Size 60x60x30cm
HVDC Transmission Line Simulator
The HVDC Transmission due to its advantages, like long distance transmission, interconnect different power systems (like 50Hz and 60Hz), more energy transmits than AC, less losses, make it essential for the students to study & understand the operation of HVDC. Vi Micro have introduced a trainer for this purpose “HVDC Transmission Line Simulator”
HVDC Transmission Line System consists of
• Generating Station Module • Rectifier Station Module (SCR or IGBT Based) • Simulated HVDC Transmission Line Module • Inverter Station Module • Loading ModuleGenerating Station Module
• It consists of a 3Φ, 415V Variable AC source, 1.5 KVA step up transformer, a Multifunction Meter (To measure various electrical parameters of • Generating side or sending end) & a Miniature Circuit Breaker. • Earth Fault Relay is provided for protection against Earth Fault. • The module is covered with metallic enclosure and sticker represents the prime operation of the module. Safety power plug-sockets are provided.Rectifier Station
• Two no’s of fully controlled SCR based bridge rectifiers provided to convert 3Φ AC to DC for HVDC transmission. • Two 6 Pulse SCR bridges connected in series • Can be configured as 12 Pulse Rectifier • A 3Φ, 1.5KVA transformer with (Y) primary and dual (Δ, Y) secondary are provided to reduce harmonics • The module is covered with metallic enclosure and sticker represents the prime operation of the module.
CLOUD AND POUR POINT APPARATUS
PRODUCT DESCRIPTION
The pour point is the lowest temperature at which the oil will just fail to flow. The apparatus consists of main cooling bath made of SS Sheet, stand unit with drain plug & cover with provision for fitting thermometer & for adding freezing mixture. A glass jar for holding oil is provided with metallic Jar. The instrument is supplied with insulated body. These are available in three sizes: - Single Test, Four Test, and Six Test Model with insulated outer body. The refrigeration Model also available to test the oil sample up to -30°Crange.
Polarimeter
Description
Suitable for determining specific rotation of optically active substances. It has Laurents quartz half shade device which make the system sufficiently accurate and at the same time simple, suitable for use with sodium light. The circular head is attached to the analyzer. Vernier movable over the scale enables reading 0-360° or 0-180°. A 200 mm tube is provided with the instrument. Mounted on a sturdy tripod stand.
Beaker (TPX)
The company is primarily engaged in the exporting and trading of the latest Beaker (TPX) all across the globe.
The demand for our Beaker (TPX) has gradually increased over the time span, for their various attributes, and premium quality.
Our Beaker (TPX) are available in different specification and at affordable prices.
