XTEMOS ELEMENT
AJAX PRODUCTS TABS
Ring & Ball
Masses Aluminium
Induction Coil
Description
This box form Induction Coil has a 50 mm spark gap and can produce pulses of high voltage spark from a low voltage direct current source such as a battery. It is suitable for use with gas-filled discharge tubes, vacuum tubes, eudiometers and for general laboratory work. It is comprised of two coils fully enclosed in a polished wooden case with binding posts. Spark gap at the discharge points can be adjusted by sliding rods back and forthXTEMOS ELEMENT
AJAX PRODUCTS TABS SIMPLE
Advanced Universal FPGA Trainer
The universal FPGA trainer consist of a main board with many peripheral like USB Device, Ethernet, Serial ports, Parallel Port, VGA port, Graphics LCD, Switches, LED, ADC etc. This motherboard has 4Nos of high speed connectors for plugging the daughter boards, which contains the FPGA of any manufacturers. Separately 2Nos of 100 pin high speed connectors provided for hardware expansion as plug in boards.
• Industry standard interconnection
- 10 MBPS Ethernet
- USB 2.0 Interface
- Two RS232 ports
- 9 pin D connector
• Memory Sub system
- 8 MB x 16 Bit SDRAM
- 4MB x 16 bit flash EEPROM
- 256KB I2C EEPROM
• Additional Features
- One 240 x 128 graphics LCD
- 16 Nos of dip switches
- 16 discrete LEDs
- 4 digit multiplexed 7 segment LED display
- 4 x 4 matrix keyboard
- One VGA Port at 15 pin D connector
- One PS2 connector for keyboard and mouse
- Reset Switch
- I2C Real time Clock
• Analog Input & Output
- 2MSPS SPI ADC (12 Channel)
- Temperature sensor interface
- One 16 bit Stereo CODEC
• 2 Nos. of 100 pin high speed connectors provided to hardware expansion can be used as hardware bus.
• Multilayer board for superior signal integrity.
• 54 I/O pins terminated at 3Nos of 20 pin connector for external interfacing.
10KW IGBT Based Power Module
FEATURES:
• 1200V/ 75A, Peak Semikron based IGBT module • 8 Nos of IGBT’s provided with independent eight driver (inbuilt opto isolator) • All the collector and emitter terminals are brought out of proper connectors for power circuit connection • All the gate and emitter terminals are brought out and terminated on front panel to view driver output fault output • Indicator LED provided for PWM input and power supply input • Proper heat sink provided for all the IGBTs with cooling fan provision • All are enclosed by viewable acrylic cabinet • Temperature sensor provided for over temperature Protection • PWM inputs are brought out on Front Panel, you may connect any controller for interface • One common +15V Power supply for all the driver circuit, Inbuilt isolated power supply provided. • Over current protection and short circuit protection provided for all individual IGBT module • Reset circuit provided and terminated to clear the fault • Snubber capacitor provided for dv/dt protection for all IGBT module • 60A 3 phase bridge rectifier and filter circuit available for power circuit input.
Gynecological Examination Model
Description
Gynecological Simulator is ideal for all aspects of gynecological education, training and competency evaluation, including the bimanual exam, speculum exam, and cytology sampling. Students will appreciate the unprecedented realism of its internal and external features, while instructors will love the interchangeable components that make up its unique modular system. This simulator allows you the flexibility of customizing your scenarios with use of included makeup, blood, and thickener. Additional specialized modules are also available (STD, post-menopause, S.A.N.E., and pre-puberty). Starter unit includes torso, normal genital pad, normal pelvic organ block with vagina and rectum, abdominal gel pad, fabric abdominal pad, abdominal overlay skin, seven uterus/cervix pieces (normal/normal with discharge option, retroverted/cervicitis, cancer/cancer, transparent IUD trainer, post-menopause/herpes, fibroids/polyp, early pregnancy), five detachable ovaries (normal, polycystic, small cyst, large adnexal mass), bladder insert, pelvic organ prolapse insert, baby powder, Injury Shades Makeup Wheel, Primary Colors Makeup Wheel blood mix, hydroxyethyl cellulose thickener, syringe, lubricant, instruction manual, and hard carry case.XTEMOS ELEMENT
AJAX PRODUCTS TABS ALTERNATIVE
Fashion
Carrier Tray
We offer high quality Carrier Tray to our valuable clients.
This autoclavable Polypropylene Tray has a handle which proves really helpful in carrying reagents or laboratory apparatus from one place to another, single handedly.
These attributes have led to an increase in demand of our Carrier Trays.
Material : Polypropylene
| Particulars | Pack (Pcs) | |
|---|---|---|
| Carrier Tray 380 x 240 x 115 mm | 6 |
Thermistor Unit
XTEMOS ELEMENT
AJAX PRODUCTS TABS ARROWS PAGINATION
Open Pit Mine Model
Description
Open pit mining often results in a large hole or pit being formed in the process of extracting a mineral. Deposits mined by open pit techniques are generally divided into horizontal layers called benches. The thickness of the benches depends on the type of deposit & the mineral being mined. Mining is generally conducted on a number of levels at any one time.
Coriollis Component Of Acceleration
This set up is designed to study coriollis component of Acceleration of a slider crank Mechanism. The apparatus uses hydraulic analogy to represent the rotating slider. It consists of a rotating block with two arms in opposite direction. These tubes can be rotated at various speeds by using a swinging field motor, which also acts as a dynamometer to measure torque applied to rotating tubes. A Perspex window on top cover helps to visualize the process. Rotameter is used to measure water flow rate through tubes. Water is circulated by small monoblaock pump.
Specifications:
1.Main Tank with fiberglass lining. 2.Rotating Arms 9/6 mm dia, 300 mm long. 3.Motor – Swinging field, D.C., 0.5 HP. 4.Rotameter 5.Monoblock Pump 6.Control Panel comprising of – (i) Speed Control Unit. (ii) Speed Indicator. (iii) Necessary switches. 7.Rigid support frame.Range of Experiment:
Coriollis Component of Acceleration can be determined at various speeds of rotation and water flow rates.Service Required:
1.A.C. Single Phase .230 V. stabilized supply. 2.Floor Space -1.5 m X 1.5 m.
Emissivity Measurement Apparatus
The apparatus consists of a test plate and a comparator. A black plate is used as a comparator for test plate. When all the physical, dimensions and the temperatures are equal, heat losses from both plates will also be the same, except radiation losses. Hence the input difference will be due to difference in emissive. Both the plates are kept in a panel enclose with perplex front and are given inputs through separate dimmerstats so that temperatures of both can be kept equal. Thus emissivity can determine over a wide range of temperatures.
SPECIFICATIONS:
1.Test plate and Black plates — 160mm. Dia. Aluminum plates, mounted in Panel with mica heater inside. 2.Instrumental panel consisting of- a)Voltmeter and ammeter for input measurement to both heaters through a selector switch. b)Separate dimmers for both the plates. c)Multichannel digital temperature indicator. A technical manual accompanies the unit.SERVICES REQUIRED:
1.Space area of 1.5m x 1 m. at working height. 2.230v, 15A, AC supply with earthing connection
SILICA BASIN (Round Bottom) with spout
PRODUCT DESCRIPTION
Round Bottom Basin With Spout is high purity material that enables products to resist corrosion and withstand the sharp change in temperature. Both of them meet requirements acquired by chemical and physical analysis and have 200ml Capacity.
Available in Different Dimensions:
20ml, Dia. 55mm x Ht. 23mm
45ml, Dia. 75mm x Ht. 27mm
70ml, Dia. 87mm x Ht. 33mm
85ml, Dia. 94mm x Ht. 36mm
100ml, Dia. 100mm x Ht. 45mm
200ml, Dia. 113mm x Ht. 47mm
XTEMOS ELEMENT
AJAX PRODUCTS TABS WITH ICONS
TI MSP430 Development Board
ON Chip Features
• CPU - MSP430F1611 • Core - 16 bit RISC Architecture. • Speed - Up to 8 MHZ. • Flash - 48 KB + 256B. • SRAM (on-chip) - 10KB. • 48 GPIO Lines. Two UARTs. • One I2C Module. One SPI Module. • Two 16 bit Timers. • Five Power Saving Mode. • 12 bit ADC with single channel. • 12 bit DAC with two channel.ON Board Features
• Eight Digital Output - LED Interface. • Two Digital Input. • 16 x 2 Character LCD Interface. • 7 Segment Display via I2C Interface. • 10 Base T Ethernet Connectivity. • SD Card Interface Support. • Audio Interface. • Jtag connector is provided for Debugger. • USB to serial interface provided.
Logic Gates Trainer
Logic Gates Trainer has been designed to study logic gates and applications. This trainer board is designed to verify the truth table of various logic functions, to prove De-Morgan’s theorem, Half adder and Full adder by using logic gates. The board is absolutely self-contained and requires no additional apparatus. 12 V / 1 A DC adaptor is required to operate it.
Humidifier
Description
Humidifier based on the rotating disc-splash plate principal. It produces only super fine particles of micron size, which are part of the atmosphere, thereby reaching every corner of the room, causing and resulting in uniform humidity in the room. Due to the upward thrust imparted to the micron sized water droplets, by high speed motorized unit, they remain suspended in the atmosphere for longer duration of time. The unit is capable of atomizing up to 3 liters of water in an hour at full evaporation in the driest possible ambient conditions. The unit has body made up of S.S. A single unit is effective for an enclosed space of volume up to 40 cubic meters. The unit is provided with high speed 2800 RPM motor to run longer period, and the blades are aerodynamically balanced to ensure drop less fumigation. To work on 220/230 volts A.C. supplyXTEMOS ELEMENT
AJAX PRODUCTS TABS LOAD MORE PAGINATION
SILICA CRUCIBLE WITHOUT LID
PRODUCT DESCRIPTION
- Crucible is glazed inside and outside.
- Highly resistant to alkalis and hot temperatures
- 50ml capacity
- Outside diameter 55mm, 42mm height
- No lid includedSilica crucible is glazed inside and outside. Highly resistant to alkalis and hot temperature SIZES ARE: 15ML 25ML 50ML 80ML 100ML 150ML
SILICA CRUCIBLE TALL FORM Without Lid, Translucent
XTEMOS ELEMENT
AJAX PRODUCTS TABS CAROUSEL
Artery models
Empowered with the perfect combination of trained men and modern machines, we are able to manufacture, supply and export a wide range of Artery models.
These products are used in different hospitals and medical centers for teaching students and physicians about the structure of arteries.
With the help of our diligent team of skilled personnel, we are able to provide a unmatched range of these products. Owing to our team of trained logistics professionals, we are able to provide the clients with the on time delivery of Artery models.
Dissolution Rate Test Apparatus
Specification
Consist of thermostatic control water bath which maintains temp. at 37DegC with + 0.5 Deg C variations. Provided with borosilicate vessel 1000 ml, variable speed motor, cylindrical wire mesh basket & shaft with blades of stainess steel. Single Basket, (Analog) Single Basket, (Digital R.P.M) Single Basket, (Digital) Temp. & R.P.M
Electro Mechanical Type Over Voltage Relay Study Trainer
This test set-up consists of a. Electromechanical over voltage-relay. b. Relay test setup with meter.
Electromechanical over voltage-relay
• One electromechanical type over voltage relay - Make: Megawin - Voltage setting multiplier (121V, 132, 143, 154, 165, 176, 187V) - Time setting multiplier. - One “NO” contact @ 220V, 10Amp rating. - One “NC” contact @ 220V, 10Amp rating. b. Relay test setup with meter • One 0-300V, 1AMP variable AC source provided for relay coil. • One auto transformer provided for AC voltage adjustment. • One illuminated rocker switch provided for power ON/OFF. • One digital voltmeter used to indicate applied voltage. • One digital timer provided for relay tripping time measurement. • One automatic relay tripping time measurement circuit. • One start/stop push-to on switch provided for time measurement circuit. • One reset switch provided for timer reset.
Plant Structure Microslide Sets, Plant Structure I – Angiosperms
Set of 19 slides, comprising
Allium, LS root tip for mitosis
Buxus, Lower epidermis
Capsella, LS ovule
Cucurbita, TS LS stem
Helianthus, TS stem old secondary
Ligustrum, TS leaf
Lilium TS Mature anthers pollen
Pollen grains
Ranunculus, LS flower Ranunculus, TS mature root
Ranunculus, TS stem
Stigma with pollen tube
Thickening
Tilia annual ringed
Triticum germinating seed
Vicia, young root hairs
Zea mays, TS root
Zea, TS LS stem
Zea, TS leaf
