XTEMOS ELEMENT
AJAX PRODUCTS TABS
Ballistic Galvano Meters
Description
Used for measurement of small quantities of electrical charge. Levelling Screws for balancing the coil. Coil with mirror suspended between long suspension at the upper end and a spring at lower end. Clamping arrangement for transportation. Consistent sensitivity over a large period. Strip provided for making it a periodic. Res. in Ohm Crit. Damp. Res. in Ohms Sensitivity mm per m Coul. Sensitivity mm per m Amp. Time period in Seconds.| 100 | 300 | 1000 | 12 | 2000 |
| 500 | 600 | 1400 | 12 | 3500 |
Smart Grid Simulator
Smart Grid Simulator (VPST - SGS - 01) is a convenient solution for studying the basic Architecture and the Real-Time Operation of Smart Grid, Which consists of i) 8 types of Generation ii) Transmission Line iii) Six types of loads iv) Communication through LCD and PC.
Specification
• Six different generating station (Up to 10 MW) - Wind, Solar, Diesel, Bio-Gas, Fuel-Cell &UtilityGrid. • Two separate Transmission Lines (5MW Each) – TL-1, TL-2. • Six different power consumers (Up to 10 MW)– Gen.Industry, Emergency, Urban Area, Rural Area, Cement, Chemical Industry. • Six analog pot-meters for the power consumption control. • Graphics LCD & Keypad based configuration & monitoring of smart grid. • On board LCD & PC based GUI for easy understanding of the smart grid operation. • Automatic Smart Grid Control algorithm implemented for transmission line control, over current relay & automatic load sharing/adjustment in case of over loading.Hope’s Apparatus
XTEMOS ELEMENT
AJAX PRODUCTS TABS SIMPLE
Tablet Coating Pan
Product Description
We offer coating pan that is designed to perfection and fabricated from best grades of raw material procured from reliable sources. These coating pan are suitable for coating tablets and is checked by our quality controllers for high performance and uniform coating all over the tablet. The different parts of our coating pan machines are listed as under:PAN
The coating pan is SS semi ellipsoidal size pan with a circular mouth for charging & discharging of tablets, Pan mounted at an inclination of 45 degrees to the horizontal.DRIVE ASSEMBLYPAN
The tablet coating pan consists of a suitable HP 3 Phase, 440 V, 1440 RPM TEFC motor with suitable worm reduction gear box and cone pulley arrangement to give three speed output.HOT AIR BLOWERPAN
The tablet coating pan unit is provided with a hot air blower consisting of suitable HP 3 Phase 440 V, 2880 RPM TEFC electric motor & centrifugal blower with damper delivering required CFM. The air is heated by means of suitable electric heater to give air at 30 to 90 degrees Heater with thermostat control and flexible hose pipe.Open Wind Tunnel Apparatus
Technical Description
A wind tunnel is the classic experiment system for aerodynamic flow experiments. The model being studied remains at rest while the flow medium is set in motion, and thus the desired flow around the model is generated. Open wind tunnel used to demonstrate and measure the aerodynamic properties of various models. For this purpose, air is drawn in from the environment and accelerated. The air flows around a model, such as an aerofoil, in a measuring section. The air is then decelerated in a diffuser and pumped back into the open by a fan. The carefully designed nozzle contour and a flow straightener ensure a uniform velocity distribution with little turbulence in the closed measuring section. The flow cross section of the measuring section is square. The built-in axial fan with guide vane and a variable-speed drive is characterised by an energy-efficient operation at high efficiency. Air velocities of up to 28m/s can be reached in this open wind tunnel. The trainer is equipped with an electronic two-component force sensor.Lift and drag are detected and displayed digitally. The air velocity in the measuring section is displayed on the inclined tube manometer. The tube manometers is recommended for measuring the pressure curves in drag bodies. Extensive accessories allow a variety of experiments, for example lift measurements, pressure distributions, boundary layer analysis or visualisation of streamlines. The well-structured instructional material sets out the fundamentals and provides a step-by-step guide through the experiments.Learning Objectives & Experiments
– Determine drag and lift coefficients for different models – Pressure distribution when flowing around drag bodies – Boundary layer analysis – Investigation of flutter – Wake measurementFeatures
* Open wind tunnel for a variety of aerodynamic experiments * Homogeneous flow through the flow straightener and special nozzle contour * Transparent measuring sectionLens, Double Convex, Spherical
Description
Clear glass, ground edges
| Focal length | Power | Add To Enquiry |
|---|---|---|
| 25 mm | 100 mm | +10D |
| 25 mm | 150 mm | +6.6D |
| 38 mm | 50 mm | +20D |
| 38 mm | 100 mm | +10D |
| 38 mm | 150 mm | +6.6D |
| 38 mm | 200 mm | +5D |
| 38 mm | 250 mm | +4D |
| 38 mm | 300 mm | +3.3D |
| 38 mm | 500 mm | +2D |
| 38 mm | 1000 mm | +1D |
| 50 mm | 50 mm | +20D |
| 50 mm | 100 mm | +10D |
| 50 mm | 150 mm | +6.6D |
| 50 mm | 200 mm | +5D |
| 50 mm | 250 mm | +4D |
| 50 mm | 300 mm | +3.3D |
| 50 mm | 500 mm | +2D |
| 50 mm | 1000 mm | +1D |
| 60 mm | 100 mm | +10D |
| 60 mm | 200 mm | +5D |
| 60 mm | 300 mm | +3.3D |
XTEMOS ELEMENT
AJAX PRODUCTS TABS ALTERNATIVE
Fashion
Unsymmetrical Bending Apparatus
DESCRIPTION:
Apparatus consist of an angle of size 1” x 1” x 1/8” or in equivalent metric units of length 80cm is tied as a cantilever beam. The beam is fixed at one end such that the rotation of 450 intervals can be given and clamped such that the principal axis of its cross-section may be inclined at any angle with the horizontal and vertical planes. Also arrangement is provided to apply vertical load at the free end of the cantilever and to measure horizontal and vertical deflection of the free end. A dial gauge with magnetic base is supplied with the apparatus.EXPERIMENT MANUAL:
• To study the behavior of a cantilever beam under symmetrical and unsymmetrical bending. • Using a Dial gauge shown a increasing and decreasing of heights.Hand Microtome
Description
A handy and simple model with wide flat top, suitable for sectioning of fresh tissues. Screw drum is graduated in 100 close divisions and will cut the specimen in steps of 10 microns each. Complete with a single edged razor blade. But with differential screw, screw drum is graduated in 50 wide divisions.Micro Convavity Slides
Flasks, Volumetric, with Interchangeable Glass Stopper
XTEMOS ELEMENT
AJAX PRODUCTS TABS ARROWS PAGINATION
Bar & Gauge
Tripple Prism Set
Animal Cage Stainless Steel
Description
MAde of S.S. frame provided with thick S.S.mesh o sides. Hinged door on front,Provided with water bottle and feeding tray. Extra drawer provided in the base for collection of excreta. Feeding arrangement allows removal of bin from outside of cage with automatic drop closure. 60x45x60cm. 45x38x45cm.XTEMOS ELEMENT
AJAX PRODUCTS TABS WITH ICONS
Restless Earth
Polarimeter, Senior
Description
Designed to accept observation tube upto 220 mm length. Its improved rotating half shadow system at the front ensures perfect focus and clear definition. With angular glass scale 0-360º, divided into degrees and reading upto 0.05º with micrometer. A sugar scale from 30º to 120º read upto 0.1 sugar degree. Supplied complete with two polarimeter tubes, 100 mm and 200 mm with dust cover.XTEMOS ELEMENT
AJAX PRODUCTS TABS LOAD MORE PAGINATION
SILICA CRUCIBLE WITHOUT LID
PRODUCT DESCRIPTION
- Crucible is glazed inside and outside.
- Highly resistant to alkalis and hot temperatures
- 50ml capacity
- Outside diameter 55mm, 42mm height
- No lid includedSilica crucible is glazed inside and outside. Highly resistant to alkalis and hot temperature SIZES ARE: 15ML 25ML 50ML 80ML 100ML 150ML
SILICA CRUCIBLE TALL FORM Without Lid, Translucent
XTEMOS ELEMENT
















