XTEMOS ELEMENT
AJAX PRODUCTS TABS
Critical Heat Flux Apparatus
The apparatus demonstrates the regimes of pool boiling. The test section consists of a test wire surrounded by water of constant temperature. The surface temperature of the test wire is heated by passing current through it. Due to the temperature difference between the wire surface and surroundings, the difference regimes are observed till the burnout point.
Specifications:
1.Test wire -35 gauge or 40 gauges. Length = 10cm. 2.Nichrome heater- 1 kw capacity – 1 nos. 3.Glass trough of sufficient capacity. 4.Table light to observe the test wire. 5.Voltmeter and ammeter to measure the input to the test wire. 6.Dimmerstat to adjust the voltage. A technical manual accompanies the unit.SERVICES REQUIRED:
1.220v, ISA, stabilized single-phase supply. 2.Floor surface- 1m x 1m at working height.Horse shoe Magnet
Lens, Biconvex, Acrylic
XTEMOS ELEMENT
AJAX PRODUCTS TABS SIMPLE
Demonstraton Electric Bell
Digital Colorimeter
Description
The basic set-up of the colorimeter is: LED light source: Produces polychromatic light over the entire visible region, 45 Broad spectrum filter: The colorwheel has nine different filters. The filter employed is selected by wavelength. Each filter will produce monochromatic light at a specified peak wavelength with a bandpass of 20 mm. The filters enable the user to perform tests from 400 to 680 nm. Cuvette Holder: It holds the inserted cuvette during testing. It is imperative the cuvette be consistently oriented in the holder. Round cells usually have orientation markings to correctly position the cuvette. Detector: A silicon photo diode is used as the detector. The photo detector current will change as a function of light energy. Display:The current signal from the detector is converted to a numerical value, absorbance and is shown on led displayBall & Ring with stand
XTEMOS ELEMENT
AJAX PRODUCTS TABS ALTERNATIVE
Fashion
Disintegrator
Description
Highly polished hooper dia 2". 16x25mm Completed with suitable motor to work on 220V AC 50Hz single phase. Fitted with 4 steel hammers fixed to a disc of dia. 1½" through which passes a shaft being revolved at the speed of approximately 3000 RPM. Hammers are enclosed in a drum. The lower portion can be fitted with different mesh screens (sieves)-coarse, medium or fine supplied with the equipment.Physical Optics Kit
Description
Consists of: 1. Eight Plano-convex lens fl 500 mm, 1 Plano convex lens of fl 150 mm. 2. Twelve lens holders. 3. Four plates of different apertures, 32, 22, 11 and 5.5 mm diameter resp. 4.Three plates with small holes in circles of 29, 22, 10 mm diameter 5. One plate with circular aperture of 5.5 mm diameter 6. Four multi-aperture plates. 7. Four stop plates. 8. Two slide holders. 9. Six translucent screens. 10. Ten white cards. 11. Four Eye-pieces. 12. Fifteen each Red, Green and Blue filters. 13. Forty Black cards with holes. 14. Forty razor blades. 15. 120 Rubber bands. 16. One piece black chiffon for diffraction effectsAutomatic Level
Description
a) Manufactured meticulously using International Standard. b) Tightly sealed construction for use in any weather. c) Fast accurate two-speed focusing. d) Friction-braked rotation and endless horizontal drive. e) Optical sight for quick pointing. f) Metal circular bubble. g) Fit all tripod with G5/8" or M16 screw.Optional accessories :
Metal or wooden tripod, metal or wooden staff range pole, measuring rope, plumb etc
Transducer Trainer
Specification
• RTD acts as a temperature sensor • Strain gauge based load cell • Linear variable resistive transducer • LDR, Photo diode, photo transistor • Precision servo potentiometer • Inductive type proximity sensor • Heat source, Filament lamp, Buzzer • 3½ digit LED display • Analog type 10V Center-Zero meter • Inverting and Non-inverting amplifier • Amplifier with Gain and offset control • Instrumentation and summing amplifier • Low pass filter • Precision Rectifier • Timer and buzzer oscillator • Electric switchXTEMOS ELEMENT
AJAX PRODUCTS TABS ARROWS PAGINATION
Screw Gauge Micrometers
Frequency Modulation And Demodulation
This Instrument is design to demonstrate the method to transmit signals via. Electromagnetic transmission and to study the Frequency Modulation and Demodulation. Whole instrument is placed in plastic moulded box and 2 mm banana plug leads are provided for modulation and demodulation connections.
Technical Specification:-
1. Fixed Output DC Regulated Power Supply of ±12 V.
2. Built in Modulating signal Generator of 2 KHz and 4 KHz selectable with a toggle switch with Amplitude to 3V peak to peak approximately.
3. Circuit diagrams for Modulator and Demodulator are printed on the milky white top panel
BEEHIVE SHELVE
XTEMOS ELEMENT
AJAX PRODUCTS TABS WITH ICONS
pH, Conductivity and Temperature Meter, Digital, Table Model
Highly stable and accurate.
Cell Constant Adjustment Facility
3.5 Digit Red LED Display
Technical Specification
General Power: 220 V AC ± 10%, 50Hz Dimensions: 75 x 175 x 275 mm (App.) Weight: 2.5 Kg. (App.) Temp. Compensation: 0 to 50°C adjustable from temperature. Parameters pH Range: 0 - 14 pH Resolution: 0.01 pH Accuracy: ± 0.01 pH ± 1 Digit Temp. Compensation Manual: 0 to 100°C Temperature Range: 0 - 100°C Resolution: 0.1°C Accuracy: ± 0.2% ± 1 Digit Sensor RTD: (PT - 100) Conductivity Range: 0 to 20 mS/cm in two Ranges Accuracy: ± 0.5% ± 1 Digit Resolution: 1µS/cmAccessories
pH combination electrode Cond. Cell Temperature probe Operation manual Dust cover pH stand 7 & 4 pH bottles BeakerPlane Table
Description
The Plane Table Surveying Instruments include standard accessories like Trough Compass, Spirit level, Canvas cover, Plumbing Fork etc., and is also with a fitted tripod. Uses of Plane Table in Engineering Surveys: • Maps preparation • Recording topography Accessories included in Plane Table Surveying Instruments: • Plane Table Board 750 x 600 mm, thickness 22mm & 16mm • Carrying Bag for Board • Teak wood Polished Stand • Stand Rigid Brass Head & Plate, • Magnet Trough compass brass • Spirit Level brass • Sight van 24" • Plumbing Fork • Plumb BobANALYTICAL BALANCE
DESCRIPTION
- Student Physical Balances with flat beam.
- Chemical Balances with Flat beam and rider using facility.
- Chainomatic Analytical Balances with external alteration of weights up to 100 mg.
- Analytical Balances with Triangular beam with rider using facility / Flat beam with vernier scale.
- Capacity 1mg to 100gms
- Capacity 1mg to 200gms
- IDDC Certified & Tested, 100gm
- Capacity 1mg to 500gm
- 1gm
- 2gm
- 5gm
- 10gm
- 20gm
- 50gm
- 100gm
- 200gm
Human Upper And Lower Jaw without internal wall
XTEMOS ELEMENT
AJAX PRODUCTS TABS LOAD MORE PAGINATION
SILICA CRUCIBLE WITHOUT LID
PRODUCT DESCRIPTION
- Crucible is glazed inside and outside.
- Highly resistant to alkalis and hot temperatures
- 50ml capacity
- Outside diameter 55mm, 42mm height
- No lid includedSilica crucible is glazed inside and outside. Highly resistant to alkalis and hot temperature SIZES ARE: 15ML 25ML 50ML 80ML 100ML 150ML
SILICA CRUCIBLE TALL FORM Without Lid, Translucent
XTEMOS ELEMENT
















