XTEMOS ELEMENT
AJAX PRODUCTS TABS
TMS320VC5416 Based DSP Trainer
This Kit provides new performance enhancing Features such as USB Communications. This is Suitable for applications that require optimized Combination of Power Performance & area. Suitable for the range of Signal processing applications, including speech Compression / decompression Speech recogniation, echo generation and Cancellation.
ON-CHIP FEATURES:
• 160MIPS Performance, can operate upto 160MHz • Advanced multi bus architecture with one program bus, three data buses and four address buses • 40-bit arithmetic logic unit (ALU), including a 40-bit barrel shifter and two independent 40-bit accumulators • 17-bit × 17-bit parallel multiplier coupled toa 40-bit dedicated adder for non pipelined single-cycle multiply/accumulate (MAC) operation. • Compare, select, store unit (CSSU) for the add/compare selection of the Viterbi operator • Exponent encoder to compute the exponent of a 40-bit accumulator value in a single cycle • Two address generators, including eight auxiliary registers and two auxiliary register arithmetic units.ON-BOARD FEATURES:
• 4 Mbit (256Kb x 16) Flash Memory • 4 Meg (256K x 16-Bit) Static RAM for External Program/Data • 8 way DIP switch & LED • ON Board JTAG Emulator (XDS 100 version - 2) • PCM3002 AUDIO CODEC • Expansion connector for GPIO & Peripheral interface • On board USB for serial communication
BEEHIVE SHELVE
Thermocouple Calibration Test Rig
The Unit helps in calibrating given thermocouple for the range 0°C to 100°C. While calibrating, thermocouple is once dipped in ice for 0Q C and then in boiling water for 100°C. This is done till the thermocouple shows the actual temperature of ice (0° C) and boiling wafer (100°C) and a linear calibration is set. A mV meter is provided to know the corresponding voltage.
SPECIFICATIONS:
1.A digital mV Meter and a digital temperature indicator with 2 different type of thermocouples. 2.A water container with heater of 1 KW. 3.A technical manual accompanies the unit.SERVICES REQUIRED:
1.Table surface area – 2 m X 1 m X 0.5 m height. 2.220V, 50hz. Stabilize Electric Power Supply. 3.Ice cubes – 0.5Kg. Approx.
Specific Gravity Blocks
XTEMOS ELEMENT
AJAX PRODUCTS TABS SIMPLE
RF Signal Source with Detector
Specification
• 25 to 6000MHz RF synthesized signal generator. • Programmable attenuator 5, 10, 20, 30dBm up to 1.5GHz. • 40 x 2 LCD Display to display the frequency of the RF signal and RF signal level. • Output level : 0dBm +/2dB upto 1GHz, -5dBm, +/-2dB upto 3GHz, -10dBm, +/-3dB upto 6GHz. • Output impedance : 50 ohm. • One RF Power detector provided for 50 to 1000MHz frequency range and this output is measured • by an ADC and display on the LCD display. • 6 Keys keypad provided to select the desired frequency, attenuation level, Sweep mode. • Step size : 1MHz. • Connectors: - 2 Nos. of 'N' type connector for RF out and RF in. - One "BNC" type connector for RF detector output.
Physical Optics Kit
Description
Consists of: 1. Eight Plano-convex lens fl 500 mm, 1 Plano convex lens of fl 150 mm. 2. Twelve lens holders. 3. Four plates of different apertures, 32, 22, 11 and 5.5 mm diameter resp. 4.Three plates with small holes in circles of 29, 22, 10 mm diameter 5. One plate with circular aperture of 5.5 mm diameter 6. Four multi-aperture plates. 7. Four stop plates. 8. Two slide holders. 9. Six translucent screens. 10. Ten white cards. 11. Four Eye-pieces. 12. Fifteen each Red, Green and Blue filters. 13. Forty Black cards with holes. 14. Forty razor blades. 15. 120 Rubber bands. 16. One piece black chiffon for diffraction effects
Set of Masses, Brass
Set comprises masses of brass with slots, brass hangers with hook. Fine finish, masses removable and replaceable on hanger.
Set of 9 weights, one hanger each of 10 gm. Total weight 100 gm.
Set of 9 weights, one hanger each of 25 gm. Total weight 250gm.
Set of 4 weights, one hanger each of 50 gm. Total weight 250gm.
Set of 9 weights, one hanger each of 100gm. Total weight 1000gm.
Set of one hanger 20 gm. three weights 20 gm. Total weight 100gm.
Set of one hanger 50 gm, nine weights 20 gm. One weight 10 gm. and two weights 5 gm. Total 250 gm.
Spare slotted weights and Hangers 5gm., 10gm., 20gm., 50gm., and 100 gm. are also available.
XTEMOS ELEMENT
AJAX PRODUCTS TABS ALTERNATIVE
Fashion
Cortex M4 Development Board
Cortex M4 is an ideal replacement solution for the traditional Microcontroller & DSP Processors. Vi-S32 based on ST Microelectronics cortex M4 processor offers many features for Embedded Real Time world. The full range of hardware features on the board is provided to help you to evaluate and develop many applications. STM32 Embedded target enables systems and software Engineers to quickly deploy their application models in Matlab& Simulink to Cortex M4 ARM.
Specification
• STM32F407VGT6 microcontroller high performance 32bit ARM Cortex M4. • Operating upto 168MHz • 196Kbytes of SRAM • 2.4 MSPS Analog to Digital Converter • Two Nos. of Potentiometer interface for ADC input. • Two Nos. of DAC with simultaneous conversion • 1MB On-Chip Flash. • 4 Nos. of User LEDs, Relay Interface. • 8 way dipswitch for user input • I2C Based 2 digit 7 Segment display interface. • 4 keys keypad, Stepper Motor driver interface. • USB OTG FS with micro AB connector interface. • RTC with battery backup • I2C EEPROM device interface • SPI based temperature sensor interface • 1 Gbyte Micro SD Card interface • RS232 UART interface at a pin D connector/USB connector • CAN 2.0 lines are terminated at 9 pin D female connector • 3.2inch 240 x 320 TFT color LCD with Touch Screen • 10/100Mbps Ethernet interface • Extension header for I2C, SPI & CAN • Camera Interface
RF Telemetry
RF telemetry system consists of a radio frequency transmitter and matching radio frequency receiver both operating at 433 MHz. The system is designed for the radio frequency transmission and reception. The radio frequency transmitter sends out a variable audio signal and the radio frequency receiver with built in loud speaker receives the signal. The system enables the teachers to demonstrate a variety of wave phenomenon. The system also enables the properties of the radio communications to be investigated and compared with those of visible light and other wave motions such as audible sound and water waves etc. For the operation of the system, a 9 V PP3 battery is required.
2 Stroke Petrol Engine Sectional Working Model
Pulley Single
XTEMOS ELEMENT
AJAX PRODUCTS TABS ARROWS PAGINATION
Wide Mouth Reagent Bottle
Our Wide Mouth Reagent Bottle is available in Polypropylene.
The PP Wide Mouth Reagent Bottle, offered by us, are largely demanded for their unique features.
These features include Rigid, Translucent and have Excellent Contact Clarity.
Moreover, our Wide Mouth Reagent Bottle is available at affordable prices.
| Particulars | Pack (Pcs) | |
|---|---|---|
| Reagent Bottle (Wide Mouth) 30 ml | 12 | |
| Reagent Bottle (Wide Mouth) 60 ml | 12 | |
| Reagent Bottle (Wide Mouth) 125 ml | 12 | |
| Reagent Bottle (Wide Mouth) 250 ml | 12 | |
| Reagent Bottle (Wide Mouth) 500 ml | 12 | |
| Reagent Bottle (Wide Mouth) 1000 ml | 6 | |
| Narrow Mouth Bottle 4000 ml | 1 | |
| Wide Mouth Square Bottle 4000 ml | 1 | |
| Heavy Duty Vaccum Bottle 2000 ml | 1 |
Motorised Gyroscope Apparatus
The apparatus consists of a rotor mounted in bearings. This rotor is free to rotate about
(i) Its own axis i.e. axis of spin.
(ii) Axis of precession.
(iii) Axis of gyroscopic couple.
The rotor is connected to the variable speed motor. The weight of the motor is balanced by another weight, which is on either side of the rotor. By putting weights on the weight platform torque can be supplied to rotor, which is also called gyroscopic couple.
SPECIFICATIONS OF MOTORISED GYROSCOPE APPARATUS:
1.Rotor dia. 250mm free about 3 axis of rotation driven by variable speed motor. 2.Dimmerstat to control the motor speed. 3.Stopwatch to measure the angular speed about the axis of precession. 4.Weights – 0.2 kg, 0.5 kg and 1 kg. 5.A technical manual accompanies the unit.SERVICES REQUIRE FOR MOTORISED GYROSCOPE APPARATUS:
1.220v stabilized AC supply with earthing connection. 2.Bench area – 0.5 x 0.5m at working height. 3.Tachometer for speed measurement (can be supplied at extra cost).
Set of Masses, Brass
Set comprises masses of brass with slots, brass hangers with hook. Fine finish, masses removable and replaceable on hanger.
Set of 9 weights, one hanger each of 10 gm. Total weight 100 gm.
Set of 9 weights, one hanger each of 25 gm. Total weight 250gm.
Set of 4 weights, one hanger each of 50 gm. Total weight 250gm.
Set of 9 weights, one hanger each of 100gm. Total weight 1000gm.
Set of one hanger 20 gm. three weights 20 gm. Total weight 100gm.
Set of one hanger 50 gm, nine weights 20 gm. One weight 10 gm. and two weights 5 gm. Total 250 gm.
Spare slotted weights and Hangers 5gm., 10gm., 20gm., 50gm., and 100 gm. are also available.
Germanium Diode Unit
XTEMOS ELEMENT
AJAX PRODUCTS TABS WITH ICONS
Unit Cubes
Interlinking Cubes are one of the most widely-used math manipulative in the world. The colorful, interlocking cubes help children to learn number and math concepts. These cubes represent units and link in all direction. Interlinking cubes are used for patterning, grouping, sorting, counting, numbers, addition, subtraction, multiplication, division and measurement. Each unit is a cubic centimeter measuring 1 cm x 1 cm x 1 cm
XTEMOS ELEMENT
AJAX PRODUCTS TABS LOAD MORE PAGINATION
SILICA CRUCIBLE WITHOUT LID
PRODUCT DESCRIPTION
- Crucible is glazed inside and outside.
- Highly resistant to alkalis and hot temperatures
- 50ml capacity
- Outside diameter 55mm, 42mm height
- No lid includedSilica crucible is glazed inside and outside. Highly resistant to alkalis and hot temperature SIZES ARE: 15ML 25ML 50ML 80ML 100ML 150ML
SILICA CRUCIBLE TALL FORM Without Lid, Translucent
XTEMOS ELEMENT
AJAX PRODUCTS TABS CAROUSEL
Sine / Square Oscillator 1 Hz – 1MHz
Wave Shapes : Sine and Square waves output 4 mm sockets.
Frequency Range : 1 Hz to 1 MHz using fine and coarse controls.
Accuracy : ± 5% on all ranges.
Amplitude for sine wave output : 30 Vpp.
Amplitude for Square wave output : 15 Vpp
Output Impedance for sine wave : Approx. 600 Ohms.
Output Impedance for square wave : Approx. 400 Ohms
Digital Multi Meter
Description
| D.C. Voltage | 200mV-1000V +0.5% +2 digits | |
| A.C. Voltage | 200V-750V +1.2% +10 digits | |
| D.C. Current | 200mA-10A +1% + digits | |
| Resistance | 200Ohms-2000kOhms+0.8%+2 digits | |
| Max. Display | 1999 | |
| Display Size | 16x48mm., 3½digits LCD | |
| Range | Manual | |
| Transistor Test | Yes Standard | |
| Accessories | Battery, Testing Probes with Instruction Manual, in case, CE Marked |
