XTEMOS ELEMENT
AJAX PRODUCTS TABS
Dissecting Set, Simple
Insect Collecting Net’ Executive’ (Telescopic)
Slotted Mas Set-Cast Iron
XTEMOS ELEMENT
AJAX PRODUCTS TABS SIMPLE
Planck’s Constant
Modern LEDs (light emitting diodes) cover the range from deep blue (440 nm) to infra-red (940 nm). By monitoring the voltage at which each LED just begins to emit light a graph of energy input as a function of light emitted frequency can be plotted and an approximate value of Planck’s constant deduced. Complete with viewing tube but without power supply.
Cortex M4 Development Board
Cortex M4 is an ideal replacement solution for the traditional Microcontroller & DSP Processors. Vi-S32 based on ST Microelectronics cortex M4 processor offers many features for Embedded Real Time world. The full range of hardware features on the board is provided to help you to evaluate and develop many applications. STM32 Embedded target enables systems and software Engineers to quickly deploy their application models in Matlab& Simulink to Cortex M4 ARM.
Specification
• STM32F407VGT6 microcontroller high performance 32bit ARM Cortex M4. • Operating upto 168MHz • 196Kbytes of SRAM • 2.4 MSPS Analog to Digital Converter • Two Nos. of Potentiometer interface for ADC input. • Two Nos. of DAC with simultaneous conversion • 1MB On-Chip Flash. • 4 Nos. of User LEDs, Relay Interface. • 8 way dipswitch for user input • I2C Based 2 digit 7 Segment display interface. • 4 keys keypad, Stepper Motor driver interface. • USB OTG FS with micro AB connector interface. • RTC with battery backup • I2C EEPROM device interface • SPI based temperature sensor interface • 1 Gbyte Micro SD Card interface • RS232 UART interface at a pin D connector/USB connector • CAN 2.0 lines are terminated at 9 pin D female connector • 3.2inch 240 x 320 TFT color LCD with Touch Screen • 10/100Mbps Ethernet interface • Extension header for I2C, SPI & CAN • Camera Interface
Ohm’s Meter
Meiotic Cell Division
XTEMOS ELEMENT
AJAX PRODUCTS TABS ALTERNATIVE
Fashion
Projection Measuring Microscope
Specifications
The instrument is used for microscopy applications.The device is used to examine or view the specimens that can't observe with a naked eye. It is a dual-purpose testing device which is provided with the fine grain screen to observe the samples. The major difference between the base model and advanced model is the objectives that are provided with the device i.e. 5x, 10x and 20x. It is easy to operate instrument that offers highly accurate test results. The instrument is supplied complete with the vinyl cover in a packing of a cardboard box. The instrument provides high-quality and clear images.The instrument is provided with the fine grain glass screen with the magnification range up to 400X. It is a dual purpose instrument which is equipped with the halogen projection bulb. The works efficiently on the power supply of 220AC. The device is assembled with the effective cooling fan inside the instrument.
Scalpel Blades
Round Bottom Centrifuge Tube
Avail from us, a flawless variety of Round Bottom Centrifuge Tube , which is popular for its better quality and precise engineering.
Being one of the chief Exporter and Trader in this industry, the company provides Round Bottom Centrifuge Tube at the most competitive prices.
| Particulars | Pack (Pcs) | |
|---|---|---|
| Centrifuge Tube Round Bottom 16 ml (P.P) | 50 | |
| Centrifuge Tube Round Bottom 50 ml (P.P) | 50 | |
| Centrifuge Tube Round Bottom 16 ml (P.C) | 50 | |
| Centrifuge Tube Round Bottom 50 ml (P.C) | 50 | |
| Cap for 16 ml Centrifuge Tube Round Bottom | 100 | |
| Cap for 50 ml Centrifuge Tube Round Bottom | 100 | |
| Oak Ridge Centrifuge Tubes 30 ml | 12 | |
| Oak Ridge Centrifuge Tubes 50 ml | 12 | |
| Oak Ridge Centrifuge Tubes 100 ml | 12 |
XTEMOS ELEMENT
AJAX PRODUCTS TABS ARROWS PAGINATION
Medical Microscope
Specification
Medical Microscopes is a straight tube monocular research microscope. The body can be inclined up to 90° with separate coarse and fine adjustment. Triple revolving nose-piece, double lens condenser numerical aperture of 1.2 with iris-diaphragm and rack-n-pinion adjustment. Fixed slide stage with detachable mechanical stage, plano-concave reflecting mirror inter-changeable with removable LED microscope lamp. With 10x, 15x or 5x hymenia eyepieces (2 Nos.) 10x, 45x, 100x oil-immersion (spring loaded) achromatic objectives. Magnification : up to 1500x.
Resistor Set
Description
Consisting of six resisters of resistances with different current ratings. The resistors can be used in either the series or parallel mode. The resistors can be connected to any of the desired circuits through the safety sockets provided on the top of the kit for each resistor separately. Accuracy ± 5% . The specifications of each resistor are printed on the top panel of the kit. Mounted in moulded box.
Rocks And Minerals Collection
Porcelain Combustion Boat
Description
We offer Porcelain Combustion Boats all around the world. These Porcelain Combustion Boats are made available in varied specifications and grades. Besides, our Unglazed Porcelain Combustion Boat is highly demanded in European, Asian and other markets for its quality and diverse laboratory applications.| Capacity (ml) | Height (mm) | Width (mm) | Length (mm) | |
|---|---|---|---|---|
| -- | 10 | 12 | 80 | |
| -- | 11 | 13 | 86 | |
| -- | 11 | 13 | 90 | |
| -- | 11 | 13 | 120 |
XTEMOS ELEMENT
AJAX PRODUCTS TABS WITH ICONS
Rock Cycle Model
Hand Stroboscope
Levelling Staff
Specifications :
• The levelling staff of sturdy design that meets the requirements for intensive field work. • The staff material should be one of the following: teak, cypress, kail, aimi, champ, hollock or aluminium alloy. • If timber is used as staff material, then it has well seasoned, sawn in radial direction and free of defects. • The staff is telescopic, comprising three sections without any joint in length. • The top plate made of aluminium, anodised black. • Length 4 mAccessories
• Circular bubble sensitivity of 25 minutes per 2 mm run. • Carrying case canvas. • Plummet fittings for test and adjustment of bubble.
Double Shoe Brake Working Model
XTEMOS ELEMENT
AJAX PRODUCTS TABS LOAD MORE PAGINATION
SILICA CRUCIBLE WITHOUT LID
PRODUCT DESCRIPTION
- Crucible is glazed inside and outside.
- Highly resistant to alkalis and hot temperatures
- 50ml capacity
- Outside diameter 55mm, 42mm height
- No lid includedSilica crucible is glazed inside and outside. Highly resistant to alkalis and hot temperature SIZES ARE: 15ML 25ML 50ML 80ML 100ML 150ML
SILICA CRUCIBLE TALL FORM Without Lid, Translucent
XTEMOS ELEMENT
AJAX PRODUCTS TABS CAROUSEL
PLC-Logo 6 Pack with Demo Panel Trainer Kit
This Training kit based on Siemens model “Logo” PLC controller, is modulator, versatile, scalable & flexible with integrated Ethernet interface. Many features like High Speed configurable Analog Input etc make it as an Ideal PLC for basic training purpose
PLC Specification
• Make : SIEMENS • Model : CPU LOGORCE • Input Supply : 12/24V DC • Timers &Counters : 256 Nos Each • Digital Inputs : 8 Nos • Digital Outputs : 4 Nos • Program Memory : 400 Blocks • 4 Inputs can be configured as Analog Input (0-10V) DC • Optional SD cards for data logging • Ethernet Communication Interface • Networking with up to 8 unitsDemo Panel Specification
• 8 Nos of toggle switches & LEDs provided for Digital Inputs • 6 Nos of LEDs provided for Digital outputs indication purpose • All I/Os are terminated into SP7 connectors for external trainer interfacing • Patch chords provided for interfacing the external trainers • Modules and all the components mounted on an attractive powder coated metal cabinet • Mimic diagram with screen printing provided in the panel
Anaerobic Culture Jar
Description
Transparent Anaerobic Culture Jar of 3.5.lit. capacity which is made of Polycarbonate. The lid of the jar is made of Aluminum pressure die Casting fitted with Pressure Valve, Vacuum Valve, Safety Valve & compound Pressure cum vacuum gauge, three finger aluminum clamp and sealing "O" ring. This is recommended only where inside air of jar is removed thru vacuum pump and CO2 is filled in the jar thru CO2 gas cylinder to generate anaerobic condition in the jar. Also supplied with plain aluminum pressure die casted lid which can be fitted when readymade gas packs are used to generate the anaerobic conditions inside the jar. When readymade gas packs are used, there is no need of lid fitted with dial gauge etc., for extra life of equipment.
Primary and Secondary Coil
Description
The apparatus demonstrates the principle of Electromagnetic Induction and helps explain the concept of a transformer. Primary and Secondary coil consist of coils mounted on plastic spools, with 2 binding posts on each coil. You can slide the primary coil inside the secondary coil. Also includes a soft iron core for induction experiments. Primary coil has 480 turns while secondary coil has 3800 turns. Requires a galvanometer and bar magnets, not supplied with apparatus.
