XTEMOS ELEMENT
AJAX PRODUCTS TABS
Oscilloscope
This is a portable type of Oscilloscope for two traces. The band width is 0-20 MHz. The instrument is of easy operation with comfortable controls. Its reasonable structure and technology makes it convenient to repair and calibrate.
(1) Dual Trace Dual Channel Oscilloscope with Component Test Facility
(2) Bandwidth : 20 MHz
(3) Full bandwidth sweeping circuit is used in the sweeping system
(4) The flexible and convenient triggering mode has the functions for selecting signals from one channel or triggered by Ext signals
(5) ALT trigger to observe signals from two irrelative channels
(6) The instrument has the functions of TV-H / TV-V synchronization and trigger-lock to observe all kinds of signals stably
(7) From the terminal for trigger input, CH1 and CH2 signals can be output along with the triggering channel to connect the external frequency counter
(8) Y deflection operation : Y1, Y2, ALT, CHOP, ADD, mode X-Y
(9) Vertical Deflection : 5 mV / Div to 20 V / Div in factor 1-2-5 sequence in 12 steps
(10) Rising time : < 18 nS (11) Maximum Input Voltage : 400V (DC + ACp-p) (12) Triggering Source : Y1, Y2, ALT, POWER, EXT (13) Trigger Coupling : AC / DC (EXT), NORM / TV-H, TV-V (14) Horizontal Sweep Mode : AUTO, TRIG, LOCK, SINGLE (15) Sweep time factor : 0.1 uS / div to 0.2 s / div in 1-2-5 sequence in 20 steps (16) Magnification : x10 (17) X-Y Mode input : X-Axis Y1 and Y-Axis Y2 (18) Z Axis minimum input level : TTL Level (19) Component Test Facility (20) Calibration Signal : Square wave of 0.5 V at 1 kHz (21) CTR Display size : 8 cm x 10 cm (22) Auxiliary Power Supply : 220V 50Hz AC
Rheostat, Protected With Single tube
Magnetic field demo, vertical wire
Hydraulic Disc Brake Actual Working
XTEMOS ELEMENT
AJAX PRODUCTS TABS SIMPLE
Prism, Glass
Suspension Bridge Apparatus
DESCRIPTION:
Cables are frequently used to support loads over large spans such as cable stayed for suspension bridges, cable car systems and stadium roof. They are used extensively for permanent guys on structures such as microwave towers and derricks. They are also used for temporary guys during erection. The only force in a cable is direct tension. They are too flexible to carry any moment. A cable is used to carry concentrated loads, uniformly distributed load along its length and uniformly distributed load along the horizontal span. It takes the shape of a polygon under concentrated loads, a catenary under uniform load along its length (such as its own weight), and a parabola under uniform load along the horizontal span.EXPERIMENT:
• Study the Extension of each spring Balance Left & Right Both. • Study of the effect of a point loadTECHNICAL SPECIFICATION:
• Apparatus Consists of two mild steel cables 0.5cm diameter in cross section and 150cm long, pinned to two supports 90cm apart situated symmetrically. • One of the ends can be converted to a roller by applying a known load at the end with the help of suspended pulley system. • Vertical loads can be applied at various points along the span of the beam. • A dial gauge with 25mm travel (with a magnetic base) is to be supplied with the apparatus complete with a supporting stand and a set of weights.XTEMOS ELEMENT
AJAX PRODUCTS TABS ALTERNATIVE
Fashion
Vortex Shaker (Test Tube Shaker)
Compact Vortex Shaker
Compact, rugged construction. Heavy metal base & rubber feet prevent movement of the shaker during use. Choice of continuous & touch mode. Variable speed control. Include one hand insert, micro tube insert & cup attachment.Product Details
Maximum speed : 3000 rpm Usage : Laboratory Capacity : 600ml
Seeds & Fruits
Description
All Charts are made on PVC rexine, hand drawn, waterproof, in fast multi colors with a black background. Each chart is provided with rollers to hang on wall. Size 75×100 cm. Maize seed germination Gram seed germination Bean seed germination Castor seed germination Pea seed germination Dispersal of seeds & fruits Classification of fruits
XTEMOS ELEMENT
AJAX PRODUCTS TABS ARROWS PAGINATION
DC Network Analyzer
Specification
• Here we provide the bi-polar Transmission Line. • Simulated long, medium & short distribution lines selectable by patching in various length of DC Transmission line • Two no of bi-polar DC generator sources with ON/OFF control and voltage regulator potentiometer. - Two wire or Three wire Transmission Line operated in +12V DC - Each DC generator are independently control by potentiometer. • 2 digital voltmeters and ammeters provided in the input side and 2 digital volt meters and ammeters are provided in the output side • of transmission line to read the input & output parameters of transmission line. • One no of microcontroller based measuring system provide to read the input and output parameters. • 4 nos of digital ammeters provided to read the load current • 4 nos of resistive load and 4 nos of lamp loads are provided to load the transmission line.
Reagent Reservoirs
The Universal Reagent Reservoir is a graduated single reagent reservoir with maximum volume of 50 ml, reservoir with 8 separate numbered 5ml.
Reagent channels & a reservoir with 12 separate numbered 5ml. Reagent channels.
Made of polypropylene these reagent reservoirs are repeatedly autoclavable and can be used with all multi-channel pipettes.
Material : Polypropylene
| Particulars | Pack (Pcs) | |
|---|---|---|
| Reagent Reservoir 75 ml | 12 |
Thin Cylinder Apparatus
A heavy bench top unit for studying the stress and strain in a thin walled cylinder under internal pressure. A thin walled cylinder is mounted between two support blocks. Internal pistons and seals create oil sealing. A handwheel at one end of the apparatus enables the cylinder end conditions to be adjusted to either open or closed. The internal pressure is adjusted by means of a hydraulic hand pump on the apparatus. An analogue pressure gauge displays the internal pressure whilst a pressure transducer gives feedback to the Data Acquisition Interface and Software supplied. Strain gauges are arranged on the external surface of the cylinder to measure the radial and circumferential surface strain. The strain gauges are at various angles.
Elastically Coupled Beam Apparatus
Apparatus consists of a three parallel bar suspension system with elastic beam at their upper and lower ends. The upper ends of the two outer suspension rods are tied to a vertical wooden board while central suspension rod may be tied to the centre of another elastic beam supported at two outer ends only. Mild steel Apparatus to be supplied should be complete with a supporting stand and a set of weights.
XTEMOS ELEMENT
AJAX PRODUCTS TABS WITH ICONS
Mechanical Heat Pump Trainer
Heat Pump is a device to pump heat from one source to another. The heat obtained by heat pump is more than that could be obtained by direct electrical heating. The apparatus consists of refrigeration system with water cooled shell and coil type evaporator and condenser.
SPECIFICATIONS:
1.Compressor – Hermetically sealed compressor using R-12 refrigerant, having capacity 0.3 tons of refrigeration. Condensing pressure – max. 15 Kg/cm2 (Actual pressures will depend upon working conditions). 2.Condenser – Shell and coil type with continuous water flow arrangement. 3.Evaporator – Shell and coil type with continuous water flow arrangement. 4.Expansion Valve – Internally equalized thermostatic expansion valve. 5.Measurements – a) Rotameter for condenser & evaporator water flow rate measurement. b) Rotameter for liquid refrigerant flow measurement. c) Pressure gauges for condensing and evaporating pressure – 2 Nos. d) Thermometer for refrigeration cycle & water temp, measurement – 7 e) Wattmeter for compressor input measurement. f) Ammeter for compressor current measurement. 6.Controls – a) HP/LP cutout for compressor. b) Overload protector for compressor. c) Gate valve to control water flow rates. d) Necessary switches and fuse. A technical manual is accompanies the unit.SERVICES REQUIRED:
1.Floor surface area – 2m, X 2m. X 1.5m. height. 2.220V. 15Amp. Single Phase Stabilized power supply.
Conical Friction Clutch Working Model
Arthropoda
| Daphnia WM | Cyclops Male WM |
| Cyclops Female with egg sac WM | Anopheles Male adult WM |
| Anopheles Female adult WM | Anopheles Mouth Parts Male WM |
| Anopheles Larva WM | Anopheles Egg WM |
| Cockroach Mouth Parts WM | Cockroach Malpighian Tubules WM |
| Cockroach Hepatic Caeca WM, TS | Cockroach Ovary TS |
| Cockroach Testis TS | Cockroach Leg WM |
| Cockroach Thoracic Spiracle WM | Cockroach Abdominal Spiracle WM |
| Cockroach Abdominal Spiracle WM | Cockroach Gizzard TS |
| Cockroach Trachea WM | Cockroach Striated Muscles WM, TS |
| Cockroach Wing WM | Cockroach Compound Eye VS |
| Culex Mouth Part Male WM | Culex Mouth Part Female WM |
| Culex Male WM | Culex Female WM |
| Honey Bee Mouth Parts | Honey Bee Leg with Pollen Basket WM |
| Honey Bee Sting Apparatus WM | House Fly Mouth Parts |
| Butter Fly Mouth Parts | Bed Bug WM |
| Bed Bug Mouth Parts WM | Prawn Gill TS |
| Prawn Gill WM | Prawn Statocyst TS |
| Prawn Hastate Plate WM | Prawn Compound Eye V.S. |
| Different Type of Insect Mouth parts WM | Different Type of Antenna WM |
PETRI DISH
Product description:
These flat, clear Corning Petri dishes are made from soda lime silica glass and will withstand repeated sterilization (wet or dry). The edges are beaded to provide greater mechanical strength. The covered dish is not airtight. Bottoms also have a triangular enamel reference point for serial dilutions.
Size:
50mm
75mm
100mm
150mm
XTEMOS ELEMENT
AJAX PRODUCTS TABS LOAD MORE PAGINATION
SILICA CRUCIBLE WITHOUT LID
PRODUCT DESCRIPTION
- Crucible is glazed inside and outside.
- Highly resistant to alkalis and hot temperatures
- 50ml capacity
- Outside diameter 55mm, 42mm height
- No lid includedSilica crucible is glazed inside and outside. Highly resistant to alkalis and hot temperature SIZES ARE: 15ML 25ML 50ML 80ML 100ML 150ML
SILICA CRUCIBLE TALL FORM Without Lid, Translucent
XTEMOS ELEMENT
AJAX PRODUCTS TABS CAROUSEL
Flexible AC Transmission Systems
Three phase FACTS help the students to get insight of FACTS operation in Realtime by enhancing their understandings through various experiments. This module can be used to analyze the effect of shunt compensation (STATCOM- STATIC Compensator) series Compensation (SSSC - Static Synchronous Series Compensator) and Series - Shunt Compensation (UPFC - Unified Power Flow Controller) in the transmission line.
It consists of
• Generator Set-up (3Φ AC Source) • Simulated Transmission line • IGBT Based VSI Power Module • Series & Shunt Transformers with LC filter • RLC - Load setup • TMS320F2812 DSP Controller • Upgrade possibleGenerator Set-up (3Φ AC Source)
• 3 phase Alternator DC Motor Drive setup 3Φ / 1KVA / 1500 RPM / Salient Pole type coupled with 2HP/220V DC shunt motor and with suitable drive from 1Φ AC input supply with • suitable speed control, sensor and digital speed indicator. • Digital controller with IGBT based DC voltage controller for DC motor Armature Voltage variation 0-200V DC/10A & Alternator field voltage variation with necessary instruments • /meters/indicators.
PCR Tube Rack
We are one of the prime Exporters and Traders of PCR Tube Rack .
Used for keeping PCR Tubes, Top & base of this rack are made of tough & transparent polycarbonate while the middle portion is made of polypropylene.
PCR Tube Rack facilitates the use of multipipetters.
A number of racks can be stacked together to save shelf space.
Material : Polycarbonate / Polypropylene
| Particulars | Pack (Pcs) | |
|---|---|---|
| PCR Tube Rack (Rack for 96 PCR Tubes of 0.2 ml | 4 |
