XTEMOS ELEMENT
AJAX PRODUCTS TABS
Wire helix (Slinky)
Single Phase Cyclo Converter
Specification
• Consists of firing circuit, SCR power circuit and load. • Line synchronized IC based linear firing circuit. • Line synchronization achieved by step - down transformer. • Four nos. firing pulse with pulse transformer isolation to trigger four SCR. • One no. potentiometer used to vary the firing angle (180° - 0°). • Carrier logic implemented with carrier frequency of 4KHz. • One no. toggle switch with debounceogic for pulse ON/OFF. • EPROM Based firing pulse frequency variation. • Two nos. toggle switch to select different frequency (Hz, 50/2Hz, 50/3Hz, 50/4Hz). • Power circuit consists of Four nos. SCR with fuse protection. • Anode, Cathode, Gate terminals are terminated in the front panel for user connection. • 24V AC, 1Amp Provided for power circuit input with ON/OFF switch. • One no. fixed R, load provided Center tapped inductor for power circuit. • 230V, 50Hz AC input with ON/OFF rocker switch, fuse for over load.XTEMOS ELEMENT
AJAX PRODUCTS TABS SIMPLE
Vernier Calipers Precision
Single Shoe Brake Working Model
Human Ear, Enlarged, 2 Parts
XTEMOS ELEMENT
AJAX PRODUCTS TABS ALTERNATIVE
Fashion
Cortex M4 Development Board
Cortex M4 is an ideal replacement solution for the traditional Microcontroller & DSP Processors. Vi-S32 based on ST Microelectronics cortex M4 processor offers many features for Embedded Real Time world. The full range of hardware features on the board is provided to help you to evaluate and develop many applications. STM32 Embedded target enables systems and software Engineers to quickly deploy their application models in Matlab& Simulink to Cortex M4 ARM.
Specification
• STM32F407VGT6 microcontroller high performance 32bit ARM Cortex M4. • Operating upto 168MHz • 196Kbytes of SRAM • 2.4 MSPS Analog to Digital Converter • Two Nos. of Potentiometer interface for ADC input. • Two Nos. of DAC with simultaneous conversion • 1MB On-Chip Flash. • 4 Nos. of User LEDs, Relay Interface. • 8 way dipswitch for user input • I2C Based 2 digit 7 Segment display interface. • 4 keys keypad, Stepper Motor driver interface. • USB OTG FS with micro AB connector interface. • RTC with battery backup • I2C EEPROM device interface • SPI based temperature sensor interface • 1 Gbyte Micro SD Card interface • RS232 UART interface at a pin D connector/USB connector • CAN 2.0 lines are terminated at 9 pin D female connector • 3.2inch 240 x 320 TFT color LCD with Touch Screen • 10/100Mbps Ethernet interface • Extension header for I2C, SPI & CAN • Camera Interface
Investigation With Mirrors Kit
Description
To Conduct basic experiments on the reflection of light from flat mirrors. The kit shows how adjacent mirrors reflect multiple images and demonstrates the principles of the periscope and kaleidoscope. The unit contains all the materials for the construction of a periscope and a kaleidoscope, including two sets of mirrors, mirror supports, and tubes. With instructions for assembly activity guide.
Conical Measures
The Conical Measures offered by us are very effectively for measuring small quantities of reagents.
Moulded in Polypropylene, these autoclavable measures have a hexagonal base, which provides it excellent stability.
The measures are clear, have good chemical resistance, and have raised graduation for easy.
Material : Polypropylene
| Particulars | Pack (Pcs) | |
|---|---|---|
| Conical Measure 12 ml | 12 | |
| Conical Measure 25 ml | 12 | |
| Conical Measure 50 ml | 12 | |
| Conical Measure 125 ml | 12 | |
| Conical Measure 200 ml | 12 |
Ring & Ball
XTEMOS ELEMENT
AJAX PRODUCTS TABS ARROWS PAGINATION
Tubing, Rubber, High Pressure
Front Suspension System
In this model the working of front suspension system is shown with the help of actual parts assembled on a metal stand. All the necessary parts of a front suspension system are shown in actual working form. This model helps the student to understand the working of the front suspension system very easily. It is specially made dissectible for demonstration purposes.
(A) Macpherson Type Suspension System
(B) Double Wishbone Type Suspension System
(C) Longitudinal Torsion Bar Type Suspension System
Digit Counter Micrometer (DCM)
Description
Micrometer is used to measure short lengths accurately Technical Details : Printed Marking on the Vernier Scale Carbide Tipped Measuring Faces Blue Metallic Finish Frame With Locking Clamp and ratchet stop Least Count : 0.01mm With Digit Counter to withstand abuse at work Sizes : 0-2 25-5 50-7 75-100 Specifications: Guarantee ; 6 Months without abuse Packing ; Plastic Box Calibration ; In house.
XTEMOS ELEMENT
AJAX PRODUCTS TABS WITH ICONS
Straight Joint
Bernoulli S Theorem Apparatus
DESCRIPTION:-
The Set-up is designed to verify Bernoulli’s Theorem experimentally. Set up consists of a one piece clear acrylic test section with convergent and divergent part section, supply tank, measuring tank, inlet water tank and pump for closed loop water circulation. The test section is connected to Piezometer tubes through pressure tapping at different locations on the section to demonstrate the Bernoulli’s Theorem. The flow rate of water is measured using measuring tank and stop watch provided.EXPERIMENTS:-
Ø To verify Bernoulli’s Theorem experimentally.FEATURES:-
Ø Clear test section Ø Closed loop water circulation Ø Compact & stand alone setup Ø Stainless Steel tanks and wetted parts Ø Superb Painted structure Ø Simple to operate & maintainUTILITIES REQUIRED: –
Ø Electricity Supply: Provide 230 +/- 10 VAC, 50 Hz, Single Phase electric supply with proper earthing (Neutral – Earth voltage less than 5 VAC) 5 A, three pin socket with switch for pump Ø Water Supply : Tap water connection ½ “ BSP, Distilled water @ 60 Ltrs. (Optional)TECHNICAL SPECIFICATION: –
Ø Test Section : Material Acrylic, Size Ø Inlet Tank : Capacity 20 Liters., Stainless Steel Ø Supply Tank : Capacity 70 Liters., Stainless Steel Ø Measuring Tank : Capacity 20 Ltrs. Fitted with Piezometer Tube & Scale Ø Piezometer Tubes : Material P.U. Tubes (9 Nos.) Ø Pump : FHP Capacity make Tullu/Crompton Graves Ø Piping : GI / PVC Size BSP Ø Stop Watch : Electronic Ø The whole Set-up is well designed and arranged in a good quality painted Structure.
Manual Steering System
Steering System – Actual Working
Manual Steering System
The working of steering system is shown with the help of actual parts assembled on square iron pipe frame. All the necessary parts of steering system are shown in actual working form. This model helps the student to understand the working of the steering system very easily. It is specially made dissectible for demonstration purposes.
XTEMOS ELEMENT
AJAX PRODUCTS TABS LOAD MORE PAGINATION
SILICA CRUCIBLE WITHOUT LID
PRODUCT DESCRIPTION
- Crucible is glazed inside and outside.
- Highly resistant to alkalis and hot temperatures
- 50ml capacity
- Outside diameter 55mm, 42mm height
- No lid includedSilica crucible is glazed inside and outside. Highly resistant to alkalis and hot temperature SIZES ARE: 15ML 25ML 50ML 80ML 100ML 150ML
SILICA CRUCIBLE TALL FORM Without Lid, Translucent
XTEMOS ELEMENT
AJAX PRODUCTS TABS CAROUSEL
Measuring Cylinder (Round Base)
We are a credible Exporter and Supplier of Measuring Cylinder (Round Base).
Measuring Cylinder is laboratory equipment used to measure the volume of a liquid.
It is more accurate and precise than laboratory flasks and beakers.
Sometimes, Measuring Cylinder is also used to indirectly measure the volume of a solid by measuring the displacement of a liquid.
Available in high grade polypropylene or polymethylpentene material, our Measuring Cylinder comes with molded graduations in variegated divisions and capacities.
They are transparent and possess optimum resistant against chemical.
They have a round base and pouring spout.
We make available Measuring Cylinder as per the requirement at the best market prices.
| Particulars | Pack (Pcs) | |
|---|---|---|
| Measuring Cylinder 10 ml | 24 | |
| Measuring Cylinder 25 ml | 12 | |
| Measuring Cylinder 50 ml | 12 | |
| Measuring Cylinder 100 ml | 12 | |
| Measuring Cylinder 250 ml | 6 | |
| Measuring Cylinder 500 ml | 4 | |
| Measuring Cylinder 1000 ml | 3 | |
| Measuring Cylinder 2000 ml | 2 |
Android Based WSN Evaluation Kit
We are pleased to introduce a trainer which offers all the components (ARM 11 processor Board + GSM module + CMOS Camera + GPS module + ZigBee module +SD Wi-Fi module) of a Smart Cell Phone which works on Android OS which also Occupies 50% of the smart cell phone market. This Development Board gives you an Comprehensive solution integrating both hardware and software. These features make it easily and widely used in MID development, auto electronic devices, industrial applications, GPS systems and multimedia systems. It is good for educational training, embedded development and DIY as well.
Features
• ARM11 Samsung S3C6410, ARM1176JZF-S, up to 667MHz • 256MByte mDDR RAM and 1GByte NAND Flash • 1 x 4-wire resistor touch screen interface, • 1 x 100M Ethernet interface, • 1 x DB9 5-wire serial port • 1 x Mini USB 2.0-OTG interface and USB Host 1.1 interface, • 1 x 3.5mm audio output and on board microphone interface, • 1 x TV-OUT • 1 x SD card socket, • 1 x Infrared receiver, • 4 x TTL serial port, • 1 x CMOS camera interface, • 1 x SDIO2 interface (can be connected to SD WiFi module), • 1 x 10pin JTAG interface, • 1 x PWM buzzer, • 1 x I2C-EEPROM, • 1 x backup battery for RTC, • 1 x AD adjustable resistor, • 8 x User button and 4 x LED
Tuning Forks welch type
Description :-
Consists of aluminum tuning forks, mallet in a wooden box.
Tuning forks are stamped with frequency and note.
Set of 8 (C-256, D-288, E-320, F-341.3, G-384, A-426.6, B-480, C-512)
Set of 13 (G-100, C-128, C-256, D-288, E-320, F-341.3, G-384, A-426.6, B-480, C-512, C-1024, C-2048 and C-4096)
Set of 8 (C-256, D-288, E-320, F-341.3, G-384, A-426.6, B-480, C-512)
Set of 13 (G-100, C-128, C-256, D-288, E-320, F-341.3, G-384, A-426.6, B-480, C-512, C-1024, C-2048 and C-4096)
Tray Dryer
| Design | Standard, Customized | |
| Capacity | 96 trays | |
| Automatic Grade | Automatic, Semi-Automatic | |
| Max Temperature | 250 degree C |
| Chamber Size (HxWxD) | Tray Capacity mm Inches | |
|---|---|---|
| 430x840x650 8Tray | 16”x32”x 1 1/4 | |
| 430x840x910 12Tray | 16”x32”x 1 1/4 | |
| 910x840x910 24Tray | 16”x32”x 1 1/4 | |
| 960x1270x1450 45Tray | 16”x32”x 1 1/4 | |
| 960x1700x1700 96Tray | 16”x32”x 1 1/4 |
Optional
Timer 0-24 hours. Digital temp. Indicator-cum-controller. Tray 16”x32”x 1 1/4 size.
Frequency Shift Keying Modulation And Demodulation
This Instrument is design to demonstrate the method to transmit signals via. Electromagnetic transmission and to study the Frequency Shift Keying Modulation and Demodulation. Whole instrument is placed in plastic moulded box and 2 mm banana plug leads are provided for modulation and demodulation connections.
