XTEMOS ELEMENT
AJAX PRODUCTS TABS
Plates For Simple Cell
Fully Automatic Battery Charger
XTEMOS ELEMENT
AJAX PRODUCTS TABS SIMPLE
Laboratory Spatula
Acquire from us high quality Laboratory Spatula at affordable price range.
Moulded in Polypropylene, Spatula consists of a spoon on one side while the other end is a flat construction with a knife edge.
This is helpful in breaking up crystals of different salts while the spoon is used to draw salts from the containers.
| Particulars | Pack (Pcs) | |
|---|---|---|
| Spatula 150 mm | 12 | |
| Spatula 200 mm | 12 |
TMS320VC5416 Based DSP Trainer
This Kit provides new performance enhancing Features such as USB Communications. This is Suitable for applications that require optimized Combination of Power Performance & area. Suitable for the range of Signal processing applications, including speech Compression / decompression Speech recogniation, echo generation and Cancellation.
ON-CHIP FEATURES:
• 160MIPS Performance, can operate upto 160MHz • Advanced multi bus architecture with one program bus, three data buses and four address buses • 40-bit arithmetic logic unit (ALU), including a 40-bit barrel shifter and two independent 40-bit accumulators • 17-bit × 17-bit parallel multiplier coupled toa 40-bit dedicated adder for non pipelined single-cycle multiply/accumulate (MAC) operation. • Compare, select, store unit (CSSU) for the add/compare selection of the Viterbi operator • Exponent encoder to compute the exponent of a 40-bit accumulator value in a single cycle • Two address generators, including eight auxiliary registers and two auxiliary register arithmetic units.ON-BOARD FEATURES:
• 4 Mbit (256Kb x 16) Flash Memory • 4 Meg (256K x 16-Bit) Static RAM for External Program/Data • 8 way DIP switch & LED • ON Board JTAG Emulator (XDS 100 version - 2) • PCM3002 AUDIO CODEC • Expansion connector for GPIO & Peripheral interface • On board USB for serial communication
XTEMOS ELEMENT
AJAX PRODUCTS TABS ALTERNATIVE
Fashion
Rocks And Volcanoes
LCR Resonance Apparatus
Objective : To plot Frequency Vs. Current Characteristics of LCR circuit when connected in series or in parallel.
Features : Instrument comprises of 3 Resistances, 3 Capacitors and 1 Inductance connected inside and connections brought out at Sockets. 2 AC moving coil meters to measure voltage and current.
Optional Acc. : Audio Frequency Function Generator
Microprocessor Photo Colorimeter
Microprocessor Photo Colorimeter is a compact and easy to operate instrument for Photo Colorimeter analysis of any concentration.
The output is available on a 16 x 2 line alphanumeric backlit LCD display in terms of %Transmission (%T), Absorbance (Abs.), Concentration (Conc.) and K Factor.
This instrument has 100 sample storage memory and printer output facility for printing data with any dot matrix printer.
The use of microcontroller has made it extremely versatile and accurate instrument.
10 mm path length matched test tubes are used for sample and blank.
The use of high class standard wide range glass filters covering 400 to 700 nm give extremely good results.
The filter setting is controlled by a rotating disc having 8 filters.
An automatic shutter is provided to stop the light reaching the photocell, when test tube is not inserted in the tube holder.
This increases the life of photocell tremendously.
Facility has been provided to store the last K Factor and the standard concentration value.
User can also enter any known ‘Factor’ for a test, thereby eliminating the need to re-run the standards again and again.
Specifications
| Wavelength Range | 400 - 700 nm | |
| Resolution | %T: 1, Abs: 0.01, Conc.: 0.01, K Factor: 0.01 | |
| Photometric Range | %T: 0 - 100, Abs: 0 - 1.99, Conc.: 0 - 1999, K Factor: 0 - 1999 | |
| Detector | Wide range Silicon Photodiode/Photocell | |
| Display | 16 x 2 line alphanumeric backlit LCD display | |
| Keyboard | Soft Touch Membrane Keys | |
| Data Storage | Up-to 100 Samples (0 - 99) | |
| Light Sources | 6.8 V, 0.3 Amp Tungsten Lamp | |
| Sample System | 10 mm path length matched glass test tube | |
| Filters | 400, 450, 490, 520, 540, 570, 620, 680 nm | |
| Printer Interface | Centronics Parallel Printer interface for Dot Matrix Printer | |
| Serial Interface | RS-232C interface (optional available on request) | |
| Power | 230 V ± 10% AC, 50 Hz | |
| Dimensions | (L x B x H) 240 x 254 x 90 mm (Approx.) | |
| Weight | 2.5 Kg (Approx.) |
Accessories
Matched Test Tube: A set of 5, Spare Lamp, Mains Lead, Operation Manual and Dust Cover.
Autoclaves Pressure Steam Sterilizers Economy
Specification
These autoclaves are made of 10 gauge aluminum. The drum is deep drawn & the ring on top is riveted. The lid is made by casting. Locking of lid by 6 nuts with rubber gasket seal in between (not metal to metal seal). Two safety valves, pressure gauge, flexible metal rubbing to exhaust air. Includes outer stand, inner aluminum container, inner tripod stand.| Capacity (Lt.) | Power | Size | |
|---|---|---|---|
| 20 Lt. | Electric | 300 x 300mm = 12” x 12” | |
| 20 Lt. | Non Electric | 300 x 300mm = 12” x 12” | |
| 25 Lt. | Electric | 300 x 380mm = 12” x 15” | |
| 25 Lt. | Non Electric | 300 x 380mm = 12” x 15” | |
| 35 Lt. | Electric | 350 x 380mm = 14"x15" | |
| 35 Lt. | Non Electric | 350 x 380mm = 14"x15" |
XTEMOS ELEMENT
AJAX PRODUCTS TABS ARROWS PAGINATION
Wide Range Adjustable Micrometer
Description
Micrometer is used to measure short lengths accurately Technical Details : Printed Marking on the Vernier Scale Carbide Tipped Measuring Faces Blue Metallic Finsh Frame Plate Frame With Locking Clamp and ratchet stop Least Count: 0.01/0.001” Wide Range Measurement Interchangeable Anvils Type Sizes 300-400mm 400-500mm 500-600mm 600-700mm 700-800mm 800-900mm 900-1000mm 1000-1200mm 1200-1400mm 1400-1600mm Specifications: Guarantee ; 6 Months without abuse Packing ; Wooden Box Calibration ; In house.
Blood Collection Vials (VACUTAINER) Plain/EDTA
Blood collection and storage is done is special tubes which allow the preservation of the blood sample over long periods.
These tubes can be made of glass or plastic and the caps of these vials are coloured to indicate the additives in them.
Some of the additives are anticoagulants such as EDTA, sodium citrate or heparin.
Other substances include preservatives. The containers containing coagulants are capped with gold, red or orange caps.
The ones containing anti-coagulants are green, which contain heparin, purple or lavender indicates ones which contain EDTA, grey capped tubes contain sodium fluoride or oxalate. Blood collection tubes (also called as vacutainers) are extensively used in hospitals, medical centres and diagnostic centres.
In biological labs, it is used in experiments like haemolysis etc.
Non Vacuum Vials (Pk of 100)
Vacuum Vials (Pk of 100)
Human Nose, L. S.
Masses Aluminium
XTEMOS ELEMENT
AJAX PRODUCTS TABS WITH ICONS
Aids Virus
Description
HIV virus model is enlarged millions of times, shows the outer lipid membrane with protein structures and the internal nucleus which contains the viral hereditary matter [RNA]. The nucleus is removable and condoms can be put underneath to provide a message regarding measures to be taken for protecting against HIV infections. Supplied without condoms on stand with key card.
Transmission Line Trainer
This trainer is designed for study of co-oxial cable characteristics like Impedance measurement, VSWR measurement etc., It is based, i) The latest technology of DDS Based RF source. ii) Directional coupler for VSWR Measurement. iii) TDR to measure the cable fault.
Specification
• DDS RF Source - Frequency: 10 to 400MHz. - Step Size: 1KHz. - Direct Digital Synthesis (DDS) Method Based. - Since DDS Device is primarily digital, it offers. • Display: Graphics LCD display of 240x128 pixels with backlight to plot VSWR, TDR characteristics etc., • One directional coupler provided for VSWR, Return loss measurement. • In-Built RF Detector for 10-400MHz Frequency range. • In-Built TDR (Time Domain Reflectometer) to measure and study nature of discontinuation in the co-axial cable. • Output Impedance: 50 ohms. • Co-axial cable: Various lengths of 50 ohm, 75 ohm cables supplied. • All relevant waveforms are displayed graphically in the Graphics LCD
Demonstration Dynamo Model
Rheostat, Single Tube
Description
A layer of oxidized resistance wire is wound on a porcelain tube which is supported by end supports. A sliding contact and three 4 mm socket terminals are provided for use as a rheostat or as a potentiometer. Other ranges also available on request.| Ohms | Ampere | Tube length | |
|---|---|---|---|
| 23 | 2.3 | 150mm | |
| 10 | 3.3 | 150mm | |
| 22 | 2.8 | 200mm | |
| 24 | 3.3 | 250mm | |
| 28 | 4.2 | 400mm |
XTEMOS ELEMENT
AJAX PRODUCTS TABS LOAD MORE PAGINATION
SILICA CRUCIBLE WITHOUT LID
PRODUCT DESCRIPTION
- Crucible is glazed inside and outside.
- Highly resistant to alkalis and hot temperatures
- 50ml capacity
- Outside diameter 55mm, 42mm height
- No lid includedSilica crucible is glazed inside and outside. Highly resistant to alkalis and hot temperature SIZES ARE: 15ML 25ML 50ML 80ML 100ML 150ML
SILICA CRUCIBLE TALL FORM Without Lid, Translucent
XTEMOS ELEMENT
AJAX PRODUCTS TABS CAROUSEL
PATHOLOGY INCLINED MONOCULAR MICROSCOPE
PRODUCT DESCRIPTION:
OBSERVATION HEAD: MONOCULAR Inclined at 45° and Rota table 360º with perfectly centered Quadruple BAL Bearing revolving nose piece. OBJECTIVE- 4/5x, 10x, 40/ 45x, 100x (oil). EYE PIECES- 10x WF (one), Huygenian 5x or 15x (Any one)MECHANICAL STAGE: Double plate 130x140 mm Low drive mechanical stage for X & Y movement with Sub stage bright field condenser N.A. 1.25 & iris diaphragm with built in swing out filter holder and up-down movement through rack & pinion. FOCUSING SYSTEM: Separate Coarse & highly sensitive fine movement mechanical graduated to 0.02mm. With locking device. EXTRA LARGE BASE: To support the robust arm, has built in with LED cooled bright Illumination or 6V 20 W HALOGEN LAMP with soft start continuously variable intensity controlled regulator & quick change bulb provision. PACKING: Microscope supplied one Plano concave mirror for use in day light, duster, cover & instruction manual.
Coplin Jar
We present to our valued clients the special range of Coplin Jars.
Our Coplin Jars are made up of polypropylene and can hold 10 sliders of the size 1" x 3" back to back.
The interior of the Coplin Jar is grooved in way to hold slides in erect position.
Domed & shallow threaded screw cap provides protection to the slides.
Material : Polypropylene
| Particulars | Pack (Pcs) | |
|---|---|---|
| Coplin Jar | 12 |
Laboratory Timer
This is a versatile timer quartz crystal controlled for very high accuracy.
which can be used for conducting experiments related to timing and motion with high accuracy.
Can be used for G by free fall liner air tracks, dynamic trolleys etc.
This timer has an in built power supply for the coil for G by free fall apparatus and lamps for photo gates.
Range : 0.001, 0.01, 0.1 Sec.
The above timer has a built in power source for photo gates and the coil for 'G' by free fall apparatus.
Phase Shift Keying Modulation and Demodulation
This Instrument is design to demonstrate the method to transmit signals via. Electromagnetic transmission and to study the Phase Shift Keying Modulation and Demodulation. Whole instrument is placed in plastic moulded box and 2 mm banana plug leads are provided for modulation and demodulation connections.
Technical Specification:-
1. Fixed Output DC Regulated Power Supplies of ±12 V and ±5 V.
2. Built in Carrier wave Generator (Sine Wave) of 5 Vpp, 22 KHz ± 5% Frequency range with output on sockets.
3. Built in Data Generator using IC 7490 with four modulating signal outputs on sockets.
4. IC TL084 & IC 7486 are using for PSK demodulator.
5. Circuit diagram is printed on the milky white top panel and important connections are brought out on the sockets.
Color Target Comparator
Description
Color Target Comparator The colour meter for both colour and luminance measures surface colours of products. The CR series colour meter is included in our professional range. This colour meter can read the difference in colour in L d*a*b*, L*C*H* and Delta E*ab according to your requirements. The most popular model of colour meter in our range of products is the PCE-RGB. Aside from being easy to use and economical, the colour meter is used for determining the location of a colour on the XYZ axis of non-radioactive products. The geometry of the measurement of these colours, with luminosity including a field of measurement of 8mm, allows for universal use for all types of materials. Furthermore, these devices are used by artisans, paint manufacturers, architects, painters and designers for testing colours (for colour card, NCS, RAL, HKS) or for establishing colours after mixing various colours. If you have any queries, please contact us at.
