XTEMOS ELEMENT
AJAX PRODUCTS TABS
Pulley Rod Mounting
Single Nose Microscope
Laplace Law Apparatus
Hydraulic Bench Apparatus
OBJECTIVE:
To conduct the experiment of hydraulic bench, with separate experiential set ups i.e. Hydrostatic Pressure, Flow over Weirs, Bernoulli’s Theorem, Flow meter Demonstration, Impact of jet and Orifice Discharge etc. which are accessories of the Hydraulic Bench.DESCRIPTION OF APPARATUS:
The set up is a self-contained, water recirculation unit provided with a top tray, sump tank and a measuring tank. Drain valve and over-flow are provided on the sump tank. A centrifugal pump is fitted for water circulation. Flow control valve and bypass valve is fitted in water line to conduct the experiment at different flow rates. Flow rate of water is measured with the help of measuring tank and stop watch. Measuring tank is provided to measure the discharge. Drain valve is provided in the measuring tank to empty water in sump tank after measuring discharge. Separate level indicator and scale is provided to read the level of water in the measuring tank.UTILITIES REQUIRED:
1.Water Supply (Fill approx 250 Ltrs Initially). 2.Drain Required. 3.220 V AC, 50 Hz, single phase electric supply source. 4.Floor area 1.75 m x 1.50 m.SPECFICATION:
1. Top Tray : 1060 mm x 650 mm. 2.Pump : 1 HP 3.Flow Measurement : Using measuring Tank (Material SS) 4.Tank : Capacity 40 Ltr. 5.Sump Tank : Capacity 120 Ltr. Material SS. The whole set-up is well designed and arranged in a good quality powder coating painted structure.XTEMOS ELEMENT
AJAX PRODUCTS TABS SIMPLE
Tripple Prism Set
Post Office Box, Wheatstone Bridge
Description
With two ratio dials of 10,100 and 1000 ohms each and a resistance arm of four dials, each of ten coils of 1, 10, 100 and 1000 ohms, giving total resistance of 11,110 ohms with 4 mm socket terminals for battery, galvanometer and unknown resistance. Highly stable resistances are used. Accuracy ±0.1%
XTEMOS ELEMENT
AJAX PRODUCTS TABS ALTERNATIVE
Fashion
Shell Tube Heat Exchanger Water To Water
Heat exchanger is the devices used to transfer the heat from one fluid to other. The shell and tube heat exchanger is two tube single pass heat exchanger. The hot fluid is hot water obtained from water heater. The coil fluid is cold water. The schematic flow arrangement is shown in figure. Hot water enters the lower side of end box, flows through the tubes in lower half of shell and comes to the other end of the shell. It reverses its direction, flows through tubes in upper half of the shell and leaves out. Cold water enters lower part of the shell passes over the tubes between the baffles and leaves out the shell through outlet at upper surface of shell.
SPECIFICATIONS:
1.Shell – 150NB, 750 m.m. long provided with end boxes. a.One end box with divider plate. b.25% cut baffles – 4 Nos. in the shell. 2.Tubes – 4.5mm I.D., 6.35mm O.D.,250 m.m. length copper tubes with triangular pitch. 3.Instantaneous water heater, 3 Kw capacity, to supply hot water. 4.Thermometer for measuring the water temperature. 5.Valves to control hot and cold water flow.SERVICES REQUIRED:
1.3 P H, AC supply 2.Floor space 1.5m. X 1m, 3.230V, 15A, AC supply with earthing connection. 4.Water supply at the rate of about 10 lit/min at constant heat.
IoT Based Real Time Applications
Specification:
• To check the imbalance and deflection of moving machinery used for measuring various mechanical vibration • By using high performance acceleration meter realize the repetitiveness and accurate measurement. • Velocity : 0.01 – 400.0mm/s RMS 0.001-16.00inch/s • Acceleration : 0.1 – 400m/s2 equivalent peak • : 0.3 – 1312ft/s • Displacement : 0.001 – 4.000mm.
Planck’s Constant
Modern LEDs (light emitting diodes) cover the range from deep blue (440 nm) to infra-red (940 nm). By monitoring the voltage at which each LED just begins to emit light a graph of energy input as a function of light emitted frequency can be plotted and an approximate value of Planck’s constant deduced. Complete with viewing tube but without power supply.
Aluminum Calorimeter, with wooden box
XTEMOS ELEMENT
AJAX PRODUCTS TABS ARROWS PAGINATION
Vacuum Assisted Hydraulic Drum Brake
Vacuum Assisted Hydraulic Drum Brake With Vacuum Booster & Motorised Vacuum Pump
Suitably sectionised full size unit. Consisting of original parts such as :- vacuum booster with master cylinder assembly, wheel cylinder, brake shoes, brake drums, motorised vacuum pump and necessary connections. Completed with operating lever and mounted on heavy iron stand.
Specific Gravity Blocks
Polishing Pan
XTEMOS ELEMENT
AJAX PRODUCTS TABS WITH ICONS
Laser Distancing Meter
Description
Laser Distancing Meter The professional Laser Distance Meter is designed to give special users a high accuracy, one person distance measuring and estimating tool measure remote and difficult reaching places. The compact and handy base model was specifically designed for indoor applications. Shortcut keys for addition, subtraction, Pythagoras, area and volume calculation make measuring fast and very reliable. The last 20 measurements are also stored. Simple to Operate: Due to the shortcut keys addition and subtraction, as well as surface and volume calculations could be easier. Features : Area, Volume Calculations Indirect measurement using Pythagoras Addition/ Subtraction Continuous Measurement Min/ Max. Distance Tracking Display illumination and multi-line display Buzzer indication Multifunctional end pieces.
Storage Vial
These polypropylene vials add to the existing range of Polylab storage vials.
Available in 5 ml. & 10 ml. capacities, these vials have polypropylene cap with built in seal ring which makes it a leak proof vial.
These vials are also used for the storage of biological material, animal & human cells etc.
Material : Polypropylene
| Particulars | Pack (Pcs) | |
|---|---|---|
| Storage Vail 2.0 ml | 500 | |
| Storage Vail 5.0 ml | 500 | |
| SV - 10 ml | 500 | |
| SV - 5 ml | 500 |
4 Stroke 4/3 Cylinder Petrol Engine
4 Stroke 4 Cylinder Diesel Engine – Motor Driven Actual Cut Section Working Model With Valve Timing Attachment
The engine be sectioned to show the internal constructional details.The working of individual part and accessories like Valves,Pistons,pumps,Crank and Camshaft,etc.will be demonstrated.It is provided with Flyweel and it is mounted on a sturdy iron frame. This actual cut section engine helps the student to understand about the parts and the working of the engine very easily. It is specially made dissectible for demonstration purposes.The actual cut section engine will be supplied with key card & very interesting literature regarding working.
PAM-PPM-PWM Modulation and Demodulation Trainer
PAM- PPM- PWM is the basic pulse modulation techniques. This trainer provides complete setup to the students for performing Experiments on these techniques. They can study Sampling, Pulse Modulation &Signal reconstruction process. Separate circuits are provided for each Techniques.
FEATURES:
• PAM- PPM- PWM Modulation and Demodulation Techniques,using Natural and Flat - top Sampling. • Natural Sample, Sample and Hold and Flat-top outputs. • Selectable 2 different sampling pulse frequencies on board. • On board Sine wave generators. • Voice communication using dynamic microphone and speaker • On board Filters and Amplifier • Functional blocks indicated on board schematic • Input- Output and Test points provided on board. • Built in DC Power Supply • Fully documented operating ManualTECHNICAL SPECIFICATION:
• Crystal Frequency : 6.14MHz • Sampling Frequency : 16 KHz, 32 KHz • Sine wave Generator : 1 KHz &500Hz, Amplitude (0-5)V, Tolerance +5% • Low Pass Filter : 4 Order BW Filter • Cut off frequency : 3.4 KHz • Voice Communication : Voice Link using dynamic mic& speaker • AC Amplifier : With Adjustable Gain control • Microphone type : Dynamic, 600 Ohm. • Audio Pre-amplifier : Op-amp based • Power amplifier : 1W Mono • Interconnections : BS2 Connector. • Power : 230V, 50HzXTEMOS ELEMENT
AJAX PRODUCTS TABS LOAD MORE PAGINATION
SILICA CRUCIBLE WITHOUT LID
PRODUCT DESCRIPTION
- Crucible is glazed inside and outside.
- Highly resistant to alkalis and hot temperatures
- 50ml capacity
- Outside diameter 55mm, 42mm height
- No lid includedSilica crucible is glazed inside and outside. Highly resistant to alkalis and hot temperature SIZES ARE: 15ML 25ML 50ML 80ML 100ML 150ML
SILICA CRUCIBLE TALL FORM Without Lid, Translucent
XTEMOS ELEMENT
AJAX PRODUCTS TABS CAROUSEL
Worm Roller Type Steering System
Steering System – Actual Working
Manual Steering System
Type – Worm & Roller Type Steering System – Actual Working
The working of steering system is shown with the help of actual parts assembled on square iron pipe frame. All the necessary parts of steering system are shown in actual working form. This model helps the student to understand the working of the steering system very easily. It is specially made dissectible for demonstration purposes.
Heart Models
Our capability and industrial know how has enabled us to manufacture, supply and export Heart Models.
Made of superior quality raw materials that are supposed to be the best in the market, these products have a descriptive structure and construction.
With clear depiction of external features and internal structures of the heart, these provide an appropriate indication of various large blood vessels.
These products help in education medical students about the clearer conception of the routes of the systemic and pulmonary circulation in the heart.
Heart Models are packed in special packaging material so as to ensure its safe and secure transit.
Bottle Filling Module
Specification
• One proximity sensor to detect the bottle presence • Opto coupler sensor to detect the bottle position. • A mechanical base fixed with stepper motor and gear mechanism provided to hold 5 bottles and rotate in circular motion. • A tank is provided to store the liquid. • One solenoid valve to control the volume of liquid flow into the bottle. • One Reservoir tank with FHP pump to feed the water to supply tank. • Two magnetic switches provided to maintain the level of water in supply tank.  
Aves Histology
Educational Equipments Manufacturer, Exporters & Suppliers - School Educational Equipments Manufacturers & Exporters of Educational Equipments for Lab.
Science Lab Products, Teaching Aids, Classroom Instruments, Educational Laboratory
| Skin VS | Skin VS with Feather |
| Bird Filoplume Feather WM | Bird Down Feather WM |
| Epiglottis TS | Oesophagus TS |
| Proventriculus TS | Duodenum TS |
| Small Intestine TS | Large Intestine TS |
| Gizzard TS | Spleen TS |
| Spleen TS | Liver TS |
| Pancreas TS | Trachea TS Lung TS |
| Kidney TS | Ovary TS |
| Testis TS | Heart TS Ventricle |
| Heart TS Auricle | Heart LS |
| Artery TS | Vein TS |
| Bone TS | Spinal Cord TS |
| Nerve TS | Choaca TS |
| Eye Pectin | Brain TS through different Regions |
