XTEMOS ELEMENT
AJAX PRODUCTS TABS
Automatic Knife Sharpener
Description
Portable, precision automatic knife sharpener with timer 0-60 minutes to adjust sharpening time. This equipment can sharpen all microtome knives up to 140 mm in length. Complete with one universal holder, two honing plates, one bottle honing glass compound, one knife inspection block and one re-dressing pad but without micro abrasives.
Coil Ignition System Of An Automobile
TMS320C6747 Based DSP Trainer
KEY FEATURES:
• TMS320C674x Fixed/Floating-Point VLIW DSP Core Operating upto 300MHz • 64 General-Purpose Registers (32 Bit) • Six ALU (32-/40-Bit) Functional Units • Two Multiply Functional Units • Instruction Packing Reduces Code Size • All Instructions Conditional • Hardware Support for Modulo Loop Operation • On Chip RTCON-CHIP MEMORY:
• Two Level Cache Memory Architecture • 32K-Byte L1P Program RAM/Cache • 32K-Byte L1D Data RAM/Cache • 256K-Byte L2 Unified Mapped RAM/Cache • 128K-Byte RAM Shared MemoryON-BOARD FEATURES:
• Boot mode selection Switch • 1M x 16 Bit x 4 Bank SDRAM. • 10/100M Ethernet Interface • USB1.0 & USB 2.0 Interface. • Embedded JTAG for Emulation. • 8 LED & 8 Switch for user Interface. • Expansion Connector For GPIO & Peripheral Interface. • VSDA Expansion Card for 4 Channels ADC & 4 Channels DAC. • Provision to connect external JTAG Emulator • RS232 Serial Port Interface
XTEMOS ELEMENT
AJAX PRODUCTS TABS SIMPLE
Prism, Glass
Automobile Parts Actual Cut Section
This model helps the student to understand the working of automobile parts very easily. It is specially made dissectible for demonstration purposes.
1 Self Starter
2 Battery
3 Distributor
4 Ignition Coil
5 Spark Plug
6 Magneto
7 Electrical Fuel Pump
8 Mechanical Fuel Pump
9 Master Cylinder
10 Brake Cylinder
11 Gear Lubricating Pump
12 Water Pump or Water Body
13 Radiator
14 Crank Shaft
15 Cam Shaft
16 Connecting Rod
17 Piston With Rings
18 I.C. Injector
19 Speedometer
20 Shock Absorber
Water Bath Recangular Type
Specifications
It is a double walled unit inner chamber made up of S.S. Sheet and outside of M.S. duly powder coated. The gap between the walls is fitted with special grade glass wool in order to avoid thermal losses. Concentric rings can be removed to accommodate containers of various sizes. Temperature from ambient to 100°C is controlled by Hydraulic capillary type thermostat with accuracy of ± 1° C . Workable on 220V AC 50Hz Single Phase.| Chamber Size In mms | Holes | Cap. (Aprox.) |
|---|---|---|
| 300x250x100 | 6 holes of 75 mm | 8 L |
| 355x405x100 | 12 Holes of 75mm | 15 L |
Surface Tension Balance, Searle’s
A horizontal frame is mounted on a rod fitted to a base & carries a steel wire stretched across it, the tension of which can be adjusted by a tightening screw.
A light metal pointer with a counterpoise is attached to the centre of the wire clamp.
A pan is hung from a notch in the pointer and has a hook at its underside from which can be suspended a light weight rectangular frame or a metal clip to hold a micro slide edge.
The tip of the pointer moves over a graduated scale. With rectangular wire frame, slide clip, six micro slides & 3 meters of spare wire.
XTEMOS ELEMENT
AJAX PRODUCTS TABS ALTERNATIVE
Fashion
2 Stroke Diesel Engine Sectional Working Model
Dynamic Trolley, Wooden
Hydraulic Linear Actuation System Trainer with Labview Interfacing
Features
• This trainer helps to learn the characteristics of double acting cylinder namely direction, speed & force. • A Microcontroller ADC relay driver provided to actuate the cylinder. • Gear pump supplies the hydraulic fluid to double acting cylinder through direction control valve. • Pressure control valve controls the flow rate of fluid to cylinder. • Single phase induction motor drives the pump. • Control unit communicate with PC and controls the double acting cylinder using LabVIEWSoftwares. • Two proximity sensors are provided to indicate the position of the cylinder. • Load cell measures the force developed by the cylinder. • 5/2 Double Solenoid Valve directs the cylinder. • One tank is used to store the hydraulic fluid.
XTEMOS ELEMENT
AJAX PRODUCTS TABS ARROWS PAGINATION
SILICA CRUCIBLE WITHOUT LID
PRODUCT DESCRIPTION
- Crucible is glazed inside and outside.
- Highly resistant to alkalis and hot temperatures
- 50ml capacity
- Outside diameter 55mm, 42mm height
- No lid includedSilica crucible is glazed inside and outside. Highly resistant to alkalis and hot temperature SIZES ARE: 15ML 25ML 50ML 80ML 100ML 150ML
Balance Weights
Fuel Supply System Of A Diesel Engine
XTEMOS ELEMENT
AJAX PRODUCTS TABS WITH ICONS
Teeth model w/descrip
Balance Spring
Moving Coil Meters
Description
Meters are designed for D.C. measurements to meet every need of schools, colleges and technical institutions. All meters are housed in moulded dust proof cases with zero-adjuster and have connections terminals. Type MO-65 Round.| Case | : | ABS Plastic | |
| Accuracy | : | Class 2.5 | |
| Scale length | : | 50 mm. | |
| Overall size | : | 100x90x90 mm. approx. |
XTEMOS ELEMENT
AJAX PRODUCTS TABS LOAD MORE PAGINATION
SILICA CRUCIBLE WITHOUT LID
PRODUCT DESCRIPTION
- Crucible is glazed inside and outside.
- Highly resistant to alkalis and hot temperatures
- 50ml capacity
- Outside diameter 55mm, 42mm height
- No lid includedSilica crucible is glazed inside and outside. Highly resistant to alkalis and hot temperature SIZES ARE: 15ML 25ML 50ML 80ML 100ML 150ML
SILICA CRUCIBLE TALL FORM Without Lid, Translucent
XTEMOS ELEMENT
AJAX PRODUCTS TABS CAROUSEL
Curved Member Apparatus
Apparatus consists of a steel bar which is used to make the different curved members Viz. circle, semicircle with straight arm, a quadrant of a circle and quadrant of a circle with straight arm. The bottom ends of the members are fixed to the base. Under the application of load at free end, its horizontal and vertical deflection can be measured with the help of dial gauges. A dial gauge with 25mm travel (with a magnetic base) is supplied with the apparatus. Apparatus to be supplied should be complete with a supporting stand and a set of weights.
Experimental Capabilities: Apparatus is supplied complete with a supporting stand and a set of weights.
Trinocular Microscope
| Viewing Head | : | Trinocular Head Inclined at 45°, 360° Rotatable; 55-75mm interpupillary distance. Digital Camera or Digital Screen can be to the trinocular head. | |
| Eyepiece | : | Paired Wide Field 10x, WF 15x. | |
| Nosepiece | : | Quadruple Nosepiece. | |
| Achromatic Objectives | : | 4x, 10x, 40x (SL), 100x (SL, Oil Immersion). | |
| Stage | : | Stage is fitted with co-axial mechanical stage. | |
| Focusing | : | Coaxial coarse & fine focus knob. | |
| Condenser | : | Two lens abbe condenser NA 1.25 with iris diaphragm, filter holder and blue filter, movable by rack and pinion mechanism. | |
| Illumination | : | LED Illumination with adjustable intensity. |
