XTEMOS ELEMENT
AJAX PRODUCTS TABS
TDM-PAM Modulation and Demodulation
FEATURES:
• Crystal based clock generator • On-board synchronized sine wave generator (250Hz, 500 Hz,1KHz, 2KHz) • On-board DC voltage for receiver synchronization • Four channel Time Division Multiplexing &Demultiplexing • Three wire, Two wire and single wire transmission system • On-board PLL for clock Recovery • Comparator for receiver channel synchronization • Fourth order butter worth Low pass filterTECHNICAL SPECIFICATION:
• Crystal Frequency : 6.4MHz • SinewaveType : On-board synchronized • SinewaveFrequency : 250KHz, 500Hz, 1KHz, 2KHz • DC Level : 0 to 5V (Variable) • Number of Channel : Four • Multiplexer Type : Switch Based • DemultiplexerType : Switch Based • Channel Synchronization : Comparator • Clock Recovery : Phase Locked Loop • Filter Type : Butter worth, Low Pass Filter • Filter Cut off Frequency : 3.4 KHzTuning Forks
XTEMOS ELEMENT
AJAX PRODUCTS TABS SIMPLE

Worm Roller Type Steering System
Steering System – Actual Working
Manual Steering System
Type – Worm & Roller Type Steering System – Actual Working
The working of steering system is shown with the help of actual parts assembled on square iron pipe frame. All the necessary parts of steering system are shown in actual working form. This model helps the student to understand the working of the steering system very easily. It is specially made dissectible for demonstration purposes.
Tubing, Rubber, Extra Soft
Draining Rack
Draining Rack provides an excellent option for post wash draining of tubes & bottles in the laboratory.
The back plate of this Draining Rack has 20 holes into which pegs are tightened with the help of screw-nuts.
Bottom of the rack is provided with a tray which collects all the waste water drained down which can further be collected in a container via drain tube.
This rack not rot, stain or rust.
Material : Acrylopitrile Butadiene Styrene / Polycarbonate
Particulars | Pack (Pcs) | |
---|---|---|
Draining Rack | 1 |
Instrument Tray
Acquire from us comprehensive range of Instrument Tray which is well reckoned for its quality.
This Instrument Tray has cover which fits into groove of trays to minimize spillage of material.
Smaller size can be used to sterilize small instruments whereas the larger size allows pipettes to be fully immersed in disinfectant prior to sterilizing.
Material : Polypropylene
Particulars | Pack (Pcs) | |
---|---|---|
Instrument Tray 220 x 150 x 70 mm | 2 | |
Instrument Tray 450 x 150 x 70 mm | 2 |
XTEMOS ELEMENT
AJAX PRODUCTS TABS ALTERNATIVE
Fashion
Crystal Model Set
We offer Crystal Model Set to the esteemed clients.
The Crystal Model Sets contain different colored jacks (Red, Black & White) & connectors (long & short) in a prescribed number to be joined together in an illustrated way to form structures like Diamond, Graphite & Sodium Chloride.
Material : Polyethylene
Particulars | Pack (Pcs) | |
---|---|---|
Crystal Model Set - Diamond | 1 | |
Crystal Model Set - Sodium Chloride | 1 | |
Crystal Model Set - Graphite | 1 |
Storage Vial (O Ring)
Conductors and Insulators
Separatory Funnel
We bring forth the finest range of Separatory Funnel.
Our Separatory Funnel are designed in such a way that they make filling of carboys, drums and barrels very convenient.
The handles of these funnels make their handling very easy.
We offer these Separatory Funnel at market leading prices.
Material : Polypropylene
Particulars | Pack (Pcs) | |
---|---|---|
Separatory Funnel 100 ml | 2 | |
Separatory Funnel 250 ml | 2 | |
Separatory Funnel 500 ml | 2 |
XTEMOS ELEMENT
AJAX PRODUCTS TABS ARROWS PAGINATION

Survey Umbrella
BOD Incubator
Specification
BOD Incubator is designed for low temperature incubation and determination of Bio Chemical Oxygen Demand (B.O.D). The BOD Incubator comes with a double wall construction. The Inner chamber is made of richly anodized aluminum or highly polished stainless steel with two / three removable perforated shelves. The exterior chamber of the BOD Incubator is made of thick mild steel sheet duly finished in enamel paint. Outer double wall door is provided with magnetic gasket and lock & key arrangement. The inner door is made out of clear acrylic sheet allowing inspection of material in the chamber without disturbing the chamber temperature. Door operated inner illumination has been provided. The gap between walls of equipment are filled with glass wool for temperature insulation. The cabinet is mounted on castors. The temperature in the BOD Incubator is controlled by a sensitive thermostat from 5oC to 50oC ± 1oC. For lower temperature working, a standard cooling unit with sealed compressor with protective devices has been provided below the chamber for safe and efficient working. Heating arrangement has made within the chamber for higher temperature. Inner air circulating system is provided to achieve uniform temperature in the whole chamber.Inner Chamber Size | Cap. | Material |
---|---|---|
455 x 410 x 610 mm | 4cu. Ft. or 112 Ltr. | Aluminium |
455 x 410 x 610 mm | 4cu. Ft. or 112 Ltr. | S.S. |
505 x 451 x 830 mm | 6cu. Ft. or 171 Ltr. | Aluminium |
505 x 451 x 830 mm | 6cu. Ft. or 171 Ltr. | S.S. |
565 x 565 x 865 mm | 10cu. Ft. or 280 Ltr. | Aluminium |
565 x 565 x 865 mm | 10cu. Ft. or 280 Ltr. | S.S. |
Optional
Timer 0-24 hours day night cycle. Internal illumination with 3 fluorescent tubes. Digital temp. Indicator-cum-Controller.Hand Microtome
Description
A handy and simple model with wide flat top, suitable for sectioning of fresh tissues. Screw drum is graduated in 100 close divisions and will cut the specimen in steps of 10 microns each. Complete with a single edged razor blade. But with differential screw, screw drum is graduated in 50 wide divisions.Constant Mesh Gear Box Actual Cut Section
Constant Mesh Gear Box – Actual Cut Section
The working of gear box is shown with the help of actual parts assembled on square iron pipe frame. All the necessary parts of gear box are shown in actual working form. This model helps the student to understand the working of the gear box very easily. It is specially made dissectible for demonstration purposes.
XTEMOS ELEMENT
AJAX PRODUCTS TABS WITH ICONS
Soil Thermometer
Worm Sector Type Steering System
Worm & Sector Type Steering System – Actual Working
The working of steering system is shown with the help of actual parts assembled on square iron pipe frame. All the necessary parts of steering system are shown in actual working form. This model helps the student to understand the working of the steering system very easily. It is specially made dissectible for demonstration purposes.
Restless Earth
TMS320F2812 Based DSP Trainer
FEATURES:
• 12 Motor control PWM & 4 Individual PWM output • 16 channel, 12 bit ADC • 56 Individually programmable GPIO lines • 2 Quadrature encoder interface / 6 capture input • 128K x 16 bit flash memory • 1K x 16 bit OTP ROM • 14K x 16 bit SARAM • 16 LEDs are provided for user program development & debug • Opto isolated USB to Serial Interface • 3 Switches are provided for user interface like, frequency, speed variations etc., • Bead Inductances provided for RF EMI rejection • 16 ADC inputs are protected and terminated at 26 Pin FRC connector. • 8 I/O lines are protected and terminated at 50 Pin FRC connector • 12 PWM outputs and 6 capture inputs are terminated at 34 pin FRC connector • On board isolated USB to JTAG interfaceXTEMOS ELEMENT
AJAX PRODUCTS TABS LOAD MORE PAGINATION
SILICA CRUCIBLE WITHOUT LID
PRODUCT DESCRIPTION
- Crucible is glazed inside and outside.
- Highly resistant to alkalis and hot temperatures
- 50ml capacity
- Outside diameter 55mm, 42mm height
- No lid includedSilica crucible is glazed inside and outside. Highly resistant to alkalis and hot temperature SIZES ARE: 15ML 25ML 50ML 80ML 100ML 150ML
SILICA CRUCIBLE TALL FORM Without Lid, Translucent
XTEMOS ELEMENT