XTEMOS ELEMENT
AJAX PRODUCTS TABS
Demonstration Gear Model System
Description
A series of models to demonstrate different gearing systems. With transparent slideplates, the gears may easily be seen and where necessary there is an index on the primary and secondary shafts to show the change in the direction of rotation and the relative speed of rotation. A simple three-speed and reverse-gear system using spur gears. Reverse gear is obtained by interposing a small lay-shaft mounted pinion between the two main shafts. Gear selection is by means of a short ball-ended lever.
Ice Melting Kit
Description
Demonstrates the difference in thermal conductivity of two different materials. The kit consists of two identical blocks, one made of aluminum and other made of plastic. When an ice cube is placed on aluminum it turns into water in seconds, while on plastic block it melts slowly. The aluminum block has a larger heat capacity and a higher thermal conductivity while the plastic block has lower values of both parameters. With instructions.
XTEMOS ELEMENT
AJAX PRODUCTS TABS SIMPLE
Hydraulic Ram Test Setup
DESCRIPTION:
The Set-up is designed to study the Hydraulic Ram. Hydraulic RAM is used for pump little quantity of water to high head from a large quantity of water available at low head. It works on a principle of water hammer stating that “When flowing water is suddenly stopped in a long pipe a pressure wave travels along the pipe creating an effect of water hammer”. The Set-up consists of a pipe section fitted with a pulse valve and non-return valve, a supply reservoir on a stand which is connected to an overhead tank, an air vessel above the valve chamber smoothes cyclic fluctuations from the Ram delivery. Different pressure may be applied to the pulse valve to change the closing pressure and hence the operating characteristic. The flow rate of useful and waste water is measured using measuring tank and stop watch provided. Pressure and Vacuum Gauge are connected on delivery and suction side for the purpose of measurement.EXPERIMENT:
Ø To find out discharge of useful water and waste water. Ø To find out the efficiency of the Hydraulic RAMFEATURES:
Ø Closed loop water circulation Ø Compact & stand alone set-up Ø MS Excel sample calculation program on demand Ø Stainless Steel tanks and wetted parts Ø Superb painted structure Ø Simple to Operate & MaintainUTILITIES REQUIRED:
Electric Supply: – Provide 230 +/- 10 VAC, 50 Hz, Single Phase Electric Supply with proper earthing. (Neutral – Earth voltage less than 5 VAC) 5 A, three pin socket with switch for pump. Water Supply: Tap water connection ½ “ BSP Distilled water @ 90 Ltrs. (Optional)TECHNICAL SPECIFICATIONS:
Ø Product : Hydraulic RAM Ø RAM : Size 50 x 15 mm, Supply Head 2.5m, Delivery Head 10 m (max.) Ø Air Vessel : Suitable Capacity MOC SS Ø Delivery Line : For RAM, Dia 50 mm Length 6 m. Ø Pump : Capacity 1 HP, Crompton / Sharp / Hero make Ø Supply Tank : Capacity 150 Ltrs. Ø Overhead Tank : Capacity 100 Ltrs. Ø Measuring Tank : Suitable Capacity one each for useful and waste MOC SS fitted (2 Nos.) with Piezometer Tube & Scale Ø Piping : GI / PVC Ø Stop Watch : Electronic Ø Pressure Gauge : Bourdon Type Ø Control Panel : Comprises of Standard make On/Off Switch, Mains Indicator etc. Ø Tanks will be made of Stainless Steel. Ø The whole Set-up is well designed and arranged in a good quality painted structure.
Westminister Electromagnetic Kit
Description
A very effective and motivating learning aid in elementary electromagnetism. Consists of 8 anisotropic alloy magnets, 8 ceramic ferrite magnets, 4 steel magnet yokes, 6 plotting compasses, 4 hardboard formers to take compasses, 1 bottle iron filings 250 gm, 4 dispensers for iron filings , 4 double C-cores, 4 clips for C cores, 4 Aluminium rings, 4 Aluminium split rings, 4 armatures with axle tubes, 4 Aluminium axle rods, 8 split pins, 16 rivets, 4 formers for coils, 4 reels cello tape, 4 reels copper wire, 4 sheets white pasteboard, 4 plain postcards, 4 reels white cotton thread, 1 length latex rubber tubing, 4 each resistors 100 ohms and 10 ohms, 4 support bases, 10 MES bulbs, 8 MES bulb holders,1 wood clamp and 1 wooden block. With instructions.
XTEMOS ELEMENT
AJAX PRODUCTS TABS ALTERNATIVE
Fashion
Shear Centre Apparatus
Apparatus consists of sturdy base frame and Channel, Equal angle, Semicircle and Z-Section are supplied with apparatus. Standard length of each of the four sections in M. S. is supplied. Each is provided with end clamp for fixing to the rigid bracket. A special load hanger is provided so as to change the load position so that with the help of two dial-gauges, the vertical plane of Shear-centre for the particular section can be determined.
RANGE OF EXPERIMENTS:
1. Determination of the vertical plane of shear center for different cross sections commonly used for structures
Pole Holder
Description
We are supply of high quality Pole Holders for prisms. These have been manufactured using the finest quality of aluminium and brass, in order to ensure their strength and durability. We provide the poles in the shape of a tripod for increased sturdiness while holding prisms and other survey instruments. We also offer customization and can supply these products in accordance with the demands of our clients.The specifications of the Pole holder :
• Manufactured using fine quality aluminium and brass • High on parameters like strength and durability • Improved sturdiness while holding survey instruments
Curved Member Apparatus
Apparatus consists of a steel bar which is used to make the different curved members Viz. circle, semicircle with straight arm, a quadrant of a circle and quadrant of a circle with straight arm. The bottom ends of the members are fixed to the base. Under the application of load at free end, its horizontal and vertical deflection can be measured with the help of dial gauges. A dial gauge with 25mm travel (with a magnetic base) is supplied with the apparatus. Apparatus to be supplied should be complete with a supporting stand and a set of weights.
Experimental Capabilities: Apparatus is supplied complete with a supporting stand and a set of weights.
XTEMOS ELEMENT
AJAX PRODUCTS TABS ARROWS PAGINATION
Funnel and Burette Combined Stand, Polished Wood
Tablet Hardness Tester (Pfizer Type)
Product Description
A handy, tough and direct dial reading type tablet hardness tester, working as pair of plairs, generates breaking force in single grip. The instrument offers accurate and reproducible results much faster other conventional hardness testers.Specifications
Accuracy : ±0.2 Kg Least Count: 0.2 Kg Safe Testing Force: 20 Kg Maximum Tablet Diameter: 25mm
Laboratory Spatula
Acquire from us high quality Laboratory Spatula at affordable price range.
Moulded in Polypropylene, Spatula consists of a spoon on one side while the other end is a flat construction with a knife edge.
This is helpful in breaking up crystals of different salts while the spoon is used to draw salts from the containers.
| Particulars | Pack (Pcs) | |
|---|---|---|
| Spatula 150 mm | 12 | |
| Spatula 200 mm | 12 |
89C51 Development Board
Specification:
• High Performance MCU:P89V51RD2 8 bit with 64K program flash, 1xUART, 4x 8bit I/O, 4level priority,7 interrupt sources, upto 40 MHz operation • All the IO lines are terminated through 4nos Pin FRC Connectors • One SPDT Switch provided for PROG/EXEC mode selection and one SPDT switch for Power ON/OFF Control. • RS232 interface with two status LEDs for Programming and UART interface • One 8 – way DIP switch for Digital Logical Input • On board 8 Leds for Digital Logial Output • 4x4 Matrix Keypad, On board 16x2 LCD • On board RTC interface with four function keys • Two 12V relay with driver Circuit for DC Motor 0.5 Kg Stepper Motor with relevant driver circuit • On board DAC terminated via 2-pin Phoenix Connector • On board 8 channel ADC with Temperature sensorXTEMOS ELEMENT
AJAX PRODUCTS TABS WITH ICONS
Verification Clarke S Maxwell Reciprocal Theorem
Apparatus for Verification of Clarke’s Maxwell Reciprocal Theorem
Apparatus consist of a mild steel beam 100cm long and 1.25cm x 4mm in cross section with graduations at every 10cm along the length. It should be supported on two knife edge supports 70cm apart with a 30cm overhang on one side. Reciprocal theorem can be verified by direct measurements of the deflections of various points with the help of a dial gauge due to a load placed at the reciprocal points. A dial gauge with 25mm travel (with a magnetic base) should be supplied with the apparatus. Apparatus to be supplied should be complete with a supporting stand and a set of weights.
Experimental Capabilities: To verify Clerk’s Maxwell reciprocal theorem by means of a mild steel be
Insect Box with Stretching Strips
Description
Suitable for taking in field where the insects can be stretched on the spot and can securely be kept inside the box Teakwood frame with melamine lamination on top & MDF sheet bottom is nicely polished. Top & bottom lined with EVA sheet over which adjustable strips provided for stretching insects. Strips can be fixed at one place with fine screws and fly nuts. Fitted with brass hinges, index card holder, clips and handle. Size Approx. 43 x 30 x 11cm.
XTEMOS ELEMENT
AJAX PRODUCTS TABS LOAD MORE PAGINATION
SILICA CRUCIBLE WITHOUT LID
PRODUCT DESCRIPTION
- Crucible is glazed inside and outside.
- Highly resistant to alkalis and hot temperatures
- 50ml capacity
- Outside diameter 55mm, 42mm height
- No lid includedSilica crucible is glazed inside and outside. Highly resistant to alkalis and hot temperature SIZES ARE: 15ML 25ML 50ML 80ML 100ML 150ML
SILICA CRUCIBLE TALL FORM Without Lid, Translucent
XTEMOS ELEMENT
AJAX PRODUCTS TABS CAROUSEL
Pressure Measurement Trainer
This module consists of a (0-100) psi pressure transducer of strain gauge type fixed in a pressure tank, one manually operated pump to develop pressure, pressure gauge and 3½ digital indicator to display the pressure.
Specification
• One metal pressure tank fitted with strain gauge type pressure cell. • A ball valve fitted in a pressure tank to release the pressure. • Bourden type pressure gauge provided in the tank to indicate pressure. • One manually operated foot pump to generate a pressure of the tank. • Signal conditioner for pressure cell output (0-5V) • Provision for offset/span adjustment. • A 3½ digit digital display indicator to indicate the pressure inside the tank
Magnetic Stirrer with Hot Plate
Maximum speed 1200 RPM.
Suitable for stirring all volumes, supplied with a teflon coated magnetic stirring bar.
Particulars
Magnetic Stirrer with Hot Plate, Volume 2 litre Magnetic Stirrer with Hot Plate, Volume 5 litreFeatures
Automation Type : Automatic Material (Body) : Mild Steel Material (Top Plate) : Stainless Steel Phase : Single Phase Power : 220 V Frequency : 50 Hz
Microwave Integrated Circuit Trainer
This trainer is used to study Microstrip components and its characteristics. A useful trainer to get hands on experience on Microstrip components and instrument. We offer Three solutions.
1GHz RF Source with Detector
• Frequency Range : 0.05 to 1GHz. • Resolution : 100KHz. • Automatic Level Control (ALC) RF Detecter& Directional coupler provided for many RF measurements. • Output Impedance : 50 Ohm.1GHz Micro Strip Component
• Ring Resonator. • 3dB Power divider. • Direction of Coupler.
SILICON RUBBER CORK
PRODUCT DESCRIPTION
A Bung, Stopper or Cork is a truncated cylindrical or conical closure to seal a container such as bottle, tube or barrel. Unlike a lid, which encloses a container from outside without displacing the inner volume, a bung is partially inserted inside the container to act as a seal. These can be used for all types of glass bottles. These stoppers fit tightly to prevent chemical leaks. We are one of the very few manufacturers of silicone rubber corks, septa gasket, silicone rubber stoppers in India.
Features:
- Silicon rubber cork / stopper /bung,
- Silicon rubber cork for filtration flask.
Sphygmomanometer
For measurement of systolic and diastolic blood pressure of human beings in metabolic rate.
Mercury type manometer, manually operated instrument, includes inflatable cuff-arm with Velcro, inflating rubber-bulb below with non-return air valve having captive air bleed screw, all connected through flexible rubber tubing.
Comes in a metal box.
