XTEMOS ELEMENT
AJAX PRODUCTS TABS
Phase Shift Keying Modulation and Demodulation
This Instrument is design to demonstrate the method to transmit signals via. Electromagnetic transmission and to study the Phase Shift Keying Modulation and Demodulation. Whole instrument is placed in plastic moulded box and 2 mm banana plug leads are provided for modulation and demodulation connections.
Technical Specification:-
1. Fixed Output DC Regulated Power Supplies of ±12 V and ±5 V.
2. Built in Carrier wave Generator (Sine Wave) of 5 Vpp, 22 KHz ± 5% Frequency range with output on sockets.
3. Built in Data Generator using IC 7490 with four modulating signal outputs on sockets.
4. IC TL084 & IC 7486 are using for PSK demodulator.
5. Circuit diagram is printed on the milky white top panel and important connections are brought out on the sockets.
Human Tooth Set
Porcelain Mortar & Pestle
Description
Adarsh present optimum quality Porcelain Mortar & Pestle. The Mortar is provided with lip, glazed outside except bottom and unglazed inside. Pestle unglazed at grinding surface & glazed upwards for hand comfort in grinding.| Mortar Top ID (mm) | Mortar Top OD (mm) | Capacity (ml) | Mortar Height (mm) | |
|---|---|---|---|---|
| 60 | 80 | 60 | 44 | |
| 75 | 90 | 100 | 48 | |
| 85 | 105 | 150 | 70 | |
| 100 | 125 | 275 | 70 | |
| 125 | 155 | 550 | 88 | |
| 150 | 180 | 900 | 100 | |
| 175 | 200 | 1500 | 115 | |
| 200 | 230 | 2000 | 140 | |
| 250 | 285 | 4200 | 175 | |
| 300 | 300 | 7000 | 205 | |
| 350 | 400 | Available on demand | ||
| 400 | 450 | Available on demand |
XTEMOS ELEMENT
AJAX PRODUCTS TABS SIMPLE
Interference Undercutting
The board shows the demonstration of this phenomenon of Interference and Undercutting. When we rotate the teeth in anticlockwise direction, as the teeth is undercut is gives us a smooth working. When we give a rotation in clockwise direction, we can observe that the rack tip will be resisted by the tooth flank thus giving interference.
Lens Holder Wooden
Advanced Universal FPGA Trainer
The universal FPGA trainer consist of a main board with many peripheral like USB Device, Ethernet, Serial ports, Parallel Port, VGA port, Graphics LCD, Switches, LED, ADC etc. This motherboard has 4Nos of high speed connectors for plugging the daughter boards, which contains the FPGA of any manufacturers. Separately 2Nos of 100 pin high speed connectors provided for hardware expansion as plug in boards.
• Industry standard interconnection
- 10 MBPS Ethernet
- USB 2.0 Interface
- Two RS232 ports
- 9 pin D connector
• Memory Sub system
- 8 MB x 16 Bit SDRAM
- 4MB x 16 bit flash EEPROM
- 256KB I2C EEPROM
• Additional Features
- One 240 x 128 graphics LCD
- 16 Nos of dip switches
- 16 discrete LEDs
- 4 digit multiplexed 7 segment LED display
- 4 x 4 matrix keyboard
- One VGA Port at 15 pin D connector
- One PS2 connector for keyboard and mouse
- Reset Switch
- I2C Real time Clock
• Analog Input & Output
- 2MSPS SPI ADC (12 Channel)
- Temperature sensor interface
- One 16 bit Stereo CODEC
• 2 Nos. of 100 pin high speed connectors provided to hardware expansion can be used as hardware bus.
• Multilayer board for superior signal integrity.
• 54 I/O pins terminated at 3Nos of 20 pin connector for external interfacing.
Counters
XTEMOS ELEMENT
AJAX PRODUCTS TABS ALTERNATIVE
Fashion
Combined Object and Receiving Screen
Newton Meters
LPC 2148 Evaluation Board
ON Chip Features
• CPU - LPC2148. • Core - 16/32 Bit ARM7TDMI-S. • Speed - Max 60 MHZ. • Flash - 512KB. • RAM (on-chip) - 40KB. • 46 x General Purpose I/O Pins. • USB2.0 Full speed Compliant Device. • One 10bit ADC with 14 Analog inputs. • One 10bit D/A Converter. • Two 32bit Timers/ External Event Counters. • Low Power Real Time Clock. • Six PWM, Watchdog. • Two UARTS (16c550). • Two Fast I2C (400Kb/s) Module.ON Board Features
• Eight Digital Output - LED Interface. • Two Digital Input. • 16 x 2 Character LCD Interface. • 7 Segment Display via I2C Interface. • 10 Base T Ethernet Connectivity. • SD Card Interface Support. • Audio Interface. • Jtag connector is provided for Debugger. • USB to serial interface provided.
Slide Wire Wheatstone Bridge
Description
Consists of a resistance wire with a sliding contact and a strip of aluminum to provide two “arms” of the bridge for known and unknown resistance. Strips of heavy aluminum are provided with a single gap in each of two arms for the resistance. All components are mounted on a heavy sheet metal base with Instructions.XTEMOS ELEMENT
AJAX PRODUCTS TABS ARROWS PAGINATION
Induction Coil, Ruhmkorff
Description
Coils are wound with highly insulated copper wire impregnated with paraffin wax; input 6-8 V dc through two 4 mm socket terminals, with an adjustable trembler system. The spark suppression capacitor is housed in the base. A pair of pointer electrodes with insulated handles for adjustment of the spark gap is provided. Spark length 10 mm Spark length 25 mm Spark length 50 mm Spark length 75 mm Spark length 100 mm
89C51 Development Board
Specification:
• High Performance MCU:P89V51RD2 8 bit with 64K program flash, 1xUART, 4x 8bit I/O, 4level priority,7 interrupt sources, upto 40 MHz operation • All the IO lines are terminated through 4nos Pin FRC Connectors • One SPDT Switch provided for PROG/EXEC mode selection and one SPDT switch for Power ON/OFF Control. • RS232 interface with two status LEDs for Programming and UART interface • One 8 – way DIP switch for Digital Logical Input • On board 8 Leds for Digital Logial Output • 4x4 Matrix Keypad, On board 16x2 LCD • On board RTC interface with four function keys • Two 12V relay with driver Circuit for DC Motor 0.5 Kg Stepper Motor with relevant driver circuit • On board DAC terminated via 2-pin Phoenix Connector • On board 8 channel ADC with Temperature sensor
Water Turbine with Dynamo
XTEMOS ELEMENT
AJAX PRODUCTS TABS WITH ICONS
Disintegration Test Unit
Features
Digital timer with 1 second resolution. Accurate time out provided by microprocessor based time totalizer. Baskets move Up & Down as per IP/USP test specifications. Temperature Controlled by sensitive thermostats. Digital Tablet Disintegration Apparatus is designed for accurate estimation of disintegration time of tablets as per IP/USP standards. The instrument is designed to test to batches of six tablets, simultaneously. The unit consists of two beakers having capacity of 1000 cc each. In these beakers, suitable disintegration media can be taken. These can be temperature controlled using a in-built heater and a highly thermostat fitted inside the instrument. Microprocessor based time to talizer is provided for accurate time readout.Specifications
System :Digital Tablet Disintegration Apparatus. Up and Down Speed:30 rpm ± 2 rpm. Accuracy: 2% Resolution:1 sec. Operating Temp. Range:0 - 100°C Power:230V ± 10%, 50Hz.AC
Multi Process Trainer
Features
• Pressure transmitter mounted at the bottom of the process tank • Flow transmitter (DPT) with rotameter mounted across the pipe line to sense the flow of water • Temperature sensor of (RTD) type mounted at the outlet of the heater • An industrial type heater as a heat source • FHP pump for water Circulation • SS Storage tank of 15 liters Capacity • Power driver provided to vary the pump speed and Heater Power. • Orifice plate is used for pressure drop measurement. • An electronic signal conditioner is provided. • Bourdon tube pressure gauge is provided to measure the tank. • Latest power driver is used to drive the pump & heater. • USB/Serial port data acquisition is provided.
Geographical Terms
Reagent Reservoirs
The Universal Reagent Reservoir is a graduated single reagent reservoir with maximum volume of 50 ml, reservoir with 8 separate numbered 5ml.
Reagent channels & a reservoir with 12 separate numbered 5ml. Reagent channels.
Made of polypropylene these reagent reservoirs are repeatedly autoclavable and can be used with all multi-channel pipettes.
Material : Polypropylene
| Particulars | Pack (Pcs) | |
|---|---|---|
| Reagent Reservoir 75 ml | 12 |
XTEMOS ELEMENT
AJAX PRODUCTS TABS LOAD MORE PAGINATION
SILICA CRUCIBLE WITHOUT LID
PRODUCT DESCRIPTION
- Crucible is glazed inside and outside.
- Highly resistant to alkalis and hot temperatures
- 50ml capacity
- Outside diameter 55mm, 42mm height
- No lid includedSilica crucible is glazed inside and outside. Highly resistant to alkalis and hot temperature SIZES ARE: 15ML 25ML 50ML 80ML 100ML 150ML
SILICA CRUCIBLE TALL FORM Without Lid, Translucent
XTEMOS ELEMENT
AJAX PRODUCTS TABS CAROUSEL
Advanced Nursing &Wound Care Manikins
Description
This Advanced Nursing and Wound care model is a full-body lifelike manikin, which is specifically designed for professional nursing training. This high quality manikin will provide a wide range of possible exercises including both first aid and emergency situations.NURSING SKILLS
Head care: hair washing, face washing. Irrigation of the eyes and ears. Oral cavity care. Oral cavity and nasal cavity intubation. Oxygen inhaling. Oral and nasal feeding. Lavage. Organs structure of thorax. Venipuncture and injection, transfusion. Deltoid injection. Puncture of thorax, abdominal cavity, liver, medulla and lumbar. Enema. Urethral Catheterization for male and female. Irrigation of bladder for male and female. Ostomy irrigation. Gluteus injection. Organs structure of abdominal cavity. General care, bed bathes, dressing and undressing19. Wound care: disinfection, dressing change, binding, hemostasia. Trauma parts; The suturing care for the wound on the chest wall. The suturing care for the wound on the abdomen. The suturing care for the wound on the thigh. The care for the bruise of the skin of thigh. The care for the infectious ulceration. The care for the foot gangrene. Wound of forearm amputation. Wound of calf amputation.
Mechanical Heat Pump Trainer
Heat Pump is a device to pump heat from one source to another. The heat obtained by heat pump is more than that could be obtained by direct electrical heating. The apparatus consists of refrigeration system with water cooled shell and coil type evaporator and condenser.
SPECIFICATIONS:
1.Compressor – Hermetically sealed compressor using R-12 refrigerant, having capacity 0.3 tons of refrigeration. Condensing pressure – max. 15 Kg/cm2 (Actual pressures will depend upon working conditions). 2.Condenser – Shell and coil type with continuous water flow arrangement. 3.Evaporator – Shell and coil type with continuous water flow arrangement. 4.Expansion Valve – Internally equalized thermostatic expansion valve. 5.Measurements – a) Rotameter for condenser & evaporator water flow rate measurement. b) Rotameter for liquid refrigerant flow measurement. c) Pressure gauges for condensing and evaporating pressure – 2 Nos. d) Thermometer for refrigeration cycle & water temp, measurement – 7 e) Wattmeter for compressor input measurement. f) Ammeter for compressor current measurement. 6.Controls – a) HP/LP cutout for compressor. b) Overload protector for compressor. c) Gate valve to control water flow rates. d) Necessary switches and fuse. A technical manual is accompanies the unit.SERVICES REQUIRED:
1.Floor surface area – 2m, X 2m. X 1.5m. height. 2.220V. 15Amp. Single Phase Stabilized power supply.
Light Box and Optical Set
Description
A Robust light box in matt black finish with a 12 V 24 W axial filament lamp with flexible leads. One end of the box takes a cylindrical convex lens in an adjustable sliding mount to enable production of convergent, parallel or divergent beams. Complete with accessories which consist of: 5 Plastic blocks, one rectangular, One semicircular, One equilateral prism 60° x 60° x 60°, One right angle prism 90° x 60° x 30° and one right angle prism 90° x 45° x 45°. 3 Cylindrical acrylic lenses: one double convex, one double concave, both having the same radius of curvature and one thick convex lens. 3 Mirrors, one plane glass, one curved parabolic and one curved semi-circular. 2 Slit plates, one with three narrow and one narrow slits, the other with four narrow and one wide slits 1 Set of eight colour filters, Red, Green, Blue, Cyan, Violet, Yellow, Orange and Magenta. 1 Set of coloured cards, Red, Green, Blue, Violet, Orange, Cyan, Yellow and Pink. Complete with one spare lamp, in box.
