XTEMOS ELEMENT
AJAX PRODUCTS TABS
Ballistic Galvano Meters
Description
Used for measurement of small quantities of electrical charge. Levelling Screws for balancing the coil. Coil with mirror suspended between long suspension at the upper end and a spring at lower end. Clamping arrangement for transportation. Consistent sensitivity over a large period. Strip provided for making it a periodic. Res. in Ohm Crit. Damp. Res. in Ohms Sensitivity mm per m Coul. Sensitivity mm per m Amp. Time period in Seconds.| 100 | 300 | 1000 | 12 | 2000 |
| 500 | 600 | 1400 | 12 | 3500 |
Demonstration Diffraction 3 in One
Description
For demonstrating the principle of the diffraction grating and the way in which its properties are dependent upon the number of lines per unit length. Comprises a card mount 90 x 40 mm approximately with three 16 x 9 mm apertures, each containing a diffraction grating replica. The gratings are of 100 lines / mm. 300 lines / mm and 600 lines / mm, respectively and are protected by cover glasses.
Rocks And Minerals Collection
XTEMOS ELEMENT
AJAX PRODUCTS TABS SIMPLE
Rat & Mosquito Cage
Description
Made of aluminium angle framework supported on wooden batons. Provided with fine wire mesh on sides. Wide wire mesh partition in the centre to facilitate mosquitoes pass into other portion. On one side a round opening with black cloth sleeve and on other side a sliding window with drop closure provided in centre. Size 45x30x30cm.
Rotary Air Compressor Test Rig
The Apparatus consists of a rotary vane compressor driven by an electric motor; Air intake is measured by an orifice meter and manometer, Discharge “pressure is measured by a pressure gauge. Power input of the compressor measured by an Energymeter. Thus the students can determine volumetric efficiency, power consumption and free air discharge of compressor.
SPECIFICATIONS:
1.Vane compressor – Rotary compressor, driven by 3 HP motor. 2.Calibrated orifice meter with water manometer to measure air intake. 3.Energy meter to measure input of the meter. 4.Pressure gauge to measure discharge pressure. 5.Control valve at delivery side. 6.Stop clock. 7.A technical manual accompanies the unit.SERVICES REQUIRED:
1.Floor space of approx. 1.5 X 1.5 m. X 1.5 M. height. 2.440V, 16A, 3ph. supply. 3.Tachometer.
Polarising Filter Stress Determination
Description
Demonstrate stress patterns in solids with this new and valuable equipment. Two polarising filters, mounted on a graduated frame are placed on a plastic base. Clear acrylic pieces of different shapes are introduced between the filters; when pressure is applied to the solids the resulting stress patterns are observed. An important method of demonstrating polarisation and stress. Includes instructions.XTEMOS ELEMENT
AJAX PRODUCTS TABS ALTERNATIVE
Fashion
Light Box and Optical Set
Description
A Robust light box in matt black finish with a 12 V 24 W axial filament lamp with flexible leads. One end of the box takes a cylindrical convex lens in an adjustable sliding mount to enable production of convergent, parallel or divergent beams. Complete with accessories which consist of: 5 Plastic blocks, one rectangular, One semicircular, One equilateral prism 60° x 60° x 60°, One right angle prism 90° x 60° x 30° and one right angle prism 90° x 45° x 45°. 3 Cylindrical acrylic lenses: one double convex, one double concave, both having the same radius of curvature and one thick convex lens. 3 Mirrors, one plane glass, one curved parabolic and one curved semi-circular. 2 Slit plates, one with three narrow and one narrow slits, the other with four narrow and one wide slits 1 Set of eight colour filters, Red, Green, Blue, Cyan, Violet, Yellow, Orange and Magenta. 1 Set of coloured cards, Red, Green, Blue, Violet, Orange, Cyan, Yellow and Pink. Complete with one spare lamp, in box.
Human Larynx With Tongue
Description
Natural size, three parts. Larynx showing cartilages, ligaments, muscles, relief of mucous membrane and thyroid gland. Tongue showing front part of the lower jaw which is detachable and separates into two parts, median section, sublingual gland and sub mandible gland are shown. on base with key card.
IoT Based Real Time Applications
Specification:
• To check the imbalance and deflection of moving machinery used for measuring various mechanical vibration • By using high performance acceleration meter realize the repetitiveness and accurate measurement. • Velocity : 0.01 – 400.0mm/s RMS 0.001-16.00inch/s • Acceleration : 0.1 – 400m/s2 equivalent peak • : 0.3 – 1312ft/s • Displacement : 0.001 – 4.000mm.
Wheel And Axle, Simple Form
Wooden double wheeled pulley
Consisting of a wooden double wheel with flat-bottomed grooves, 150 and 50 mm diameter respectively.
The wheel is pivoted on a spindle 10 mm diameter which projects for a distance of 100 mm so that the apparatus may be clamped to a normal retort stand.
The apparatus is supplied complete with two hooks and 6 meters of cord but without masses and stand.
XTEMOS ELEMENT
AJAX PRODUCTS TABS ARROWS PAGINATION
Blood Bank Rrefrigerator
Features
Temp Range/Precision : 4 ±1°C, 0.1 °C Control System : Microprocessor control Display Alarm : Large screen LED display/ Audio and visual alarm for Height or low temperature; System failure; Door ajar; Power failure Refrigeration Type : Forced air refrigeration system Door : Three-ply transparent glass door with lock, Heating film preventing frosting, Stealing joint strip with magnetic force Casters : 4 casters Power Supply : 110/220V±10%, 50/60Hz Capacity : 120L Refrigerant : R134a, CFC-Free Material Internal : Stainless steel Material External : Cold-rolled steel with anti-bacteria powder coating Drawers/Shelves : Shelves Consumption : 160W External Size(L*W*H) : 520*600*1050mm Standard Accessory : Temperature printer, 2 shelves, 6 baskets, fluorescent lightSpecifications
Temperature- 2°C to 4°C Temperature Accuracy- + / - 1°C Temperature Controller- Digital P.I.D Controller Display- LCD / LED Display Alarm- Audio visual alarm for high and low temperature. Power Failure Alarm- Yes Refrigerant- Non-CFC Refrigerant Defrost type- Automatic Air Circulation- Forced air circulation External Construction- Stainless Steel 304 grades / MS Power Coated Interior Construction -Stainless steel 304 Insulation- CFC free high density polyurethane foam insulation Shelves- Adjustable and made of quality steel wire Illumination- Fluorescent Lamp Safety Device- High and low temperature protection Power Supply - 220 Volts
Vacuum Pump with Plate
Draining Basket
We are known as the chief Exporter and Trader of the latest Draining Basket in India.
As the name suggests, the Draining Basket are available with wide net like structures on all sides.
These structures are proved really useful for draining different laboratory apparatus after washing them.
Made of polypropylene, Our Draining Basket can be repeatedly autoclaved.
| Particulars | Pack (Pcs) | |
|---|---|---|
| Draining Basket 400 x 400 x 100 mm | 6 |
5KVA IGBT Based Converter Inverter System
DC Motor Specification
• Power : 3HP • Armature voltage : 220V DC • Field voltage : 220V DC • Speed : 1500 RPM • Make : Benn • Double side shaft extensionSlip Ring Motor
• Type : 3phase slip ring induction motor. • Power : 2KW • Stator voltage : Three phase 415V AC, 4A • Rotor voltage : Three phase 210V AC, 6A • Speed : 1410 RPM • Make : BenndsPIC 30F4011 based PWM Controller
• Microchips’ dsPIC30F4011 16 bit digital signal controller operating at 20MIPS • On chip 48K Bytes flash program memory • On chip 1K Bytes data EEPROM • On chip 2K Bytes RAM • Four Compare/PWM output • Six PWM output for Motor control • One 3 channel Quadrature Encoder interface circuit/4 capture input • 9 Channels 10 bit ADC of 500Ksps conversion tune. • One RS232 Compatible serial port Opto isolated & terminated at 9 pin D male connector • 6 PWM outputs and two capture inputs and two compare outputs are terminated at 34pin FRC connector. • 4 Channels of DAC output & 5 channels of ADC inputs are terminated at 26 pin FRC connector • 16 x 2 alphanumeric LCD displayXTEMOS ELEMENT
AJAX PRODUCTS TABS WITH ICONS
Test Tube BG
Gas Tap, Economy
Description
Made of brass with superior chrome plating. Output nozzle having 6mm bore. Inlet 1/2 X 14. Flange diameter 46mm with two holes to fix on bench or any other surface with screws. To be fitted directly on fitting. Designed to operate at pressure up to 2 psi (0. 14kg/cm2). Suitable for use with coal gas, natural gas and L.P.G.Particulars
Gas Tap, One Way Gas Tap, Two Way Gas Tap, Three Way Gas Tap, Four Way
Line Ranger
Description
Our expertise enables us to develop a broad range of measuring and survey equipment and instruments such as Line Rangers. Manufactured using high grade metal and alloys, these line rangers can be availed in standard as well as customized sizes and specifications. Used for various testing and measuring activities by our clients, our range can be availed at most descent prices.
Internally Expanding Mechanical Drum Brake System
XTEMOS ELEMENT
AJAX PRODUCTS TABS LOAD MORE PAGINATION
SILICA CRUCIBLE WITHOUT LID
PRODUCT DESCRIPTION
- Crucible is glazed inside and outside.
- Highly resistant to alkalis and hot temperatures
- 50ml capacity
- Outside diameter 55mm, 42mm height
- No lid includedSilica crucible is glazed inside and outside. Highly resistant to alkalis and hot temperature SIZES ARE: 15ML 25ML 50ML 80ML 100ML 150ML
SILICA CRUCIBLE TALL FORM Without Lid, Translucent
XTEMOS ELEMENT
AJAX PRODUCTS TABS CAROUSEL
Water Cooling Tower Apparatus
The apparatus consists of a forced draught, counter flow type-cooling tower. A blower supplies cooling air. Air enters the tower at the bottom. Hot water is, obtained from a geyser. Hot water is sprayed over the mesh packing through the nozzles and it flows downwards. Evaporative cooling of water occurs due to the current of air and water gets cooled. This student can study the operation of cooling tower and calculate the energy balance.
SPECIFICATION:
Cooling tower, fabricated of M.S. Sheets, 200 X 200 mm. cross section, 1.2m. height with Perspex front. Wire mesh packing is provided in the tower. Geyser – 3 Kw Capacity to provided hot water. Centrifugal blower, 1 HP capacity to force air through the tower. Multichannel Digital Temperature indicator to measure temperature at various points. Rotameter to measure inlet water flow. Measuring tank to measure outlet water flow. Calibrated orifice and water manometer to measure airflow. Arrangement to measure dry and wet bulb temperatures of air at 5 intermediate stations. A technical manual accompanies the unit. The unit Is provided with anticorrosion an attractive color powder coating.SERVICES REQUIRED:
440V, 32A, AC supply with neutral and earthing connection. Floor space of about 2m. X 1.5m. Water flow of 10 Ht./min. at constant head
Basic Electricity Kit
Description
This economical kit consists of various components, which help students explore many electrical and electronic concepts. Supplied with instruction manual. Kit consists of: Cell Holder (12), Bulb Holder, MES, Mounted on Base (20), Push Key (8), Two Way Switch (4), Universal Clip (4), Electrode Holder (4), Variable Resistance (4), Bulbs, MES (40), Connecting Lead, 4mm, 10cm, Red (12), Connecting Lead, 4mm, 10cm, Black (12), Connecting Lead, 4mm, 25cm, Red (4), Connecting Lead, 4mm, 25cm, Black (4), Crocodile Clips (8), Carbon Rod (12), Soft Iron Rod (8), Silicon Diode (4), Resistance, Fixed (4), Copper Foil Sheet, 150×150mm (1), Copper Wire, Bare, 20SWG (1 Reel), Copper Wire, Insulated, 50m (1 Reel), Eureka Wire, 34SWG (50gm), Steel Wool (1 Pack).
Air Conditioning Trainer Window Type
Window air conditioner is becoming now a day’s necessity. The unit demonstrates the application of window air conditioner & evaluation of its performance. It consists of a small room to which a small air conditioner is connected the room is provided with a transparent front cover with a heater inside to simulate heat load in the room. Various measurements are provided so that performance of system that is COP of system, actual & theoretical cooling capacity of system & power consumption of unit with different load conditions.
SPECIFICATIONS:
1.Compressor – Hermetically sealed, Kirloskar make, having the capacity of 1/10 ton of refrigeration using R-12 refrigerant to keep room temperature between 20 to 30 c. 2.Condenser – Finned tube type, with forced air flow over the tubes, 3.Capillary tube of matched length as expansion device. 4.Evaporator – Finned tube type with forced air flow, 5.Room – 0.6 X 0.7 X 0.7 m. height, provided with transparent front wall. A heater with input control is provided inside the room. Which simulates different load conditions. 6.Measurements and Controls a) H.P. / L.P. Pressure gauges b) Digital temperature indicator to measure the temperatures at various points. c) Energy meters to measure input to compressor & heater. d) High and low pressure cutout. e) Thermostat to put off the compressor at set room temperature. f) Necessary switch for electrical components.SERVICES REQUIRED:
1.Floor area of 2m X 1 m. 2.230V, 15AC stabilized supply with earthing connection
