XTEMOS ELEMENT
AJAX PRODUCTS TABS
Cold Chisels
Linear Expansion Apparatus, Micrometer Screw Form
Description
A 500 mm long metal rod is supported in a plated brass tube with three tubules for steam inlet, outlet and thermometer. The tube is mounted on a stand with an adjusting screw at one end and a micrometer screw reading to 0.01 mm on the other, with terminals for connecting a bell or galvanometer to indicate contact. With copper, brass and iron test rods but without thermometer.
Autoclave Vertical Sterilizer
Specifications
Made of stainless steel with the inner chamber of a thick pressure gauge. The outer surface has a mirror polish. The lid of this autoclave is thick along with a safety valve, pressure release valve, and drain valve. Spring loaded valve to adjust the pressure. Works on 220V AC. Radial or wing nut type door locking. Digital temperature indicator. Water level indicator.| Dimension | Power | Capacity | |
|---|---|---|---|
| 250x450mm | 2KW | 22litres | |
| 300x500mm | 3KW | 40litres | |
| 350x550mm | 4KW | 50litres | |
| 400x600mm | 5KW | 75litres | |
| 450x600mm | 5KW | 95litres | |
| 550x750mm | 6KW | 187litres |
XTEMOS ELEMENT
AJAX PRODUCTS TABS SIMPLE
LPC 2148 Development Kit
ON Chip Features
• CPU - LPC2148. • Core - 16/32 Bit ARM7TDMI-S. • Speed - Max 60 MHZ. • Flash - 512KB. • RAM (on-chip) - 40KB. • 46 x General Purpose I/O Pins. • USB2.0 Full speed Compliant Device. • One 10bit ADC with 14 Analog inputs. • One 10bit D/A Converter. • Two 32bit Timers/ External Event Counters. • Low Power Real Time Clock. • Six PWM & Watchdog. • Two UARTS (16c550). • Two Fast I2C (400Kb/s) Module.On-Board Features
• Two Digital output. • Two Digital input. • 10 base T Ethernet Interface. • USB 2.0 Connectivity. • SD Card Interface. • 16 x 2 character LCD Interface. • 2 Analog Inputs are Terminated at Potentiometer. • RS232 lines are terminated at 9 pin D-type connector. • CPU lines are terminated at 20 pin connector.
RNA Model on Stand
BEEHIVE SHELVE
XTEMOS ELEMENT
AJAX PRODUCTS TABS ALTERNATIVE
Fashion
Oxygen And Carbon Cycle In Nature
Basic Electro Pneumatic Trainer Kit
Features
• This trainer kit helps to design the circuits with logic sequence. • FRL unit receives air from compressor then filters, regulates & lubricates the air. • 5/2 direction control valve provided to control the double acting cylinder. • 3/2 direction control valve provided to control the single acting cylinder. • One way flow control valves provided to control the air flow. • Magnetic read switches are provided to indicate the position of the cylinder. • Control module controls the direction control valves using Switches, Relays and Timer.XTEMOS ELEMENT
AJAX PRODUCTS TABS ARROWS PAGINATION
Laser Distancing Meter
Description
Laser Distancing Meter The professional Laser Distance Meter is designed to give special users a high accuracy, one person distance measuring and estimating tool measure remote and difficult reaching places. The compact and handy base model was specifically designed for indoor applications. Shortcut keys for addition, subtraction, Pythagoras, area and volume calculation make measuring fast and very reliable. The last 20 measurements are also stored. Simple to Operate: Due to the shortcut keys addition and subtraction, as well as surface and volume calculations could be easier. Features : Area, Volume Calculations Indirect measurement using Pythagoras Addition/ Subtraction Continuous Measurement Min/ Max. Distance Tracking Display illumination and multi-line display Buzzer indication Multifunctional end pieces.
Half lower Jaw small
Handheld GPS
Description
We offer all varieties of portable handheld GPS, hand held GPS systems and export all varieties of GPS, presently used by people around the World. Area measurement using hand-held gps. simply walk, ride, drive or fly around the perimeter, and press a button simple. Handheld gps at the gps store, inc. your source for garmin gps map 62, garmin oregon and montana handheld gps, magellan explorist units, gps map receivers and more.XTEMOS ELEMENT
AJAX PRODUCTS TABS WITH ICONS
Human Kidney With Adrenal Gland
Galvano Meter
Citical Radius Of Insulating Material
Citical Radius of Insulating Material:
At particular radius of insulation over a cylinder, loss of heat is maximum. The unit consists of a G.I. pipe provided with plaster of Paris insulation on out side surface. Four pipes are provided with heater inside having input control. Input to heaters is measured by common voltmeter and ammeter, by controlling input to heaters, it is shown that critical radius of insulation is ratio of thermal conductivity and outside heat transfer co-efficient.
SPECIFICATIONS:
1.G. I. Pipes with electrical heater inside – 4 Nos. 2.Insulation over the pipes of different thickness. 3.Controls and Measurements – a) Dimmerstat to control heater input – 4 Nos. b) A voltmeter and ammeter to measure inputs to heater. c) Digital temperature indicator to measure temperatures across insulation. d) Necessary switches and controls. A technical manual accompanies the unit.SERVICES REQUIRED:
230 V, 5 Amp., A.C., Supply with earthing connection. Floor Area of 1 m. X 1 m X 1.5m. height.
XTEMOS ELEMENT
AJAX PRODUCTS TABS LOAD MORE PAGINATION
SILICA CRUCIBLE WITHOUT LID
PRODUCT DESCRIPTION
- Crucible is glazed inside and outside.
- Highly resistant to alkalis and hot temperatures
- 50ml capacity
- Outside diameter 55mm, 42mm height
- No lid includedSilica crucible is glazed inside and outside. Highly resistant to alkalis and hot temperature SIZES ARE: 15ML 25ML 50ML 80ML 100ML 150ML
SILICA CRUCIBLE TALL FORM Without Lid, Translucent
XTEMOS ELEMENT
AJAX PRODUCTS TABS CAROUSEL
Test Tube Caps
The Test Tube Caps offered by us, come with a transparent polypropylene cap for test tubes, which proves to be an excellent protection to the contents of the tubes.
The grooves inside the cap tighten the fitting on the tube while the outer set in the tube making the combination a leak proof one.
Material : Polypropylene
| Particulars | Pack (Pcs) | |
|---|---|---|
| Test Tube With Screw Cap 16 x 100 mm | 500 | |
| Cap For Test Tube Ø 25 mm | 500 |
Distributed Control System
A powerful, modular & upgradable DCS has been designed and configured based on Siemens controller SIMATIC PCS7 ASRTX (Micro Box). Distributed I/O system ET200M can be provided for field automation. The distributed I/O can be connected via Profibus, Communication. DCS consists of controller, Power supply unit, distributed I/O, Digital Input and Output modules, Analog Input and Output module. a Demo Panel and Simatic PCS7 V9.0 Software.
DCS Controller
• Make : SIEMENS. • Controller : SIMATIC PCS 7 AS RTX BOX. • Profibus Communication done via CP5611 onboard. • Transmission Rate of Profibus cable is 12 Mbit/s. • 2 x GBIT & RJ45 LAN • Core 17-3517 Processor 1.7GHz, 4GB DDR3 RAM, SSD 80GB, 4xUSB V3.0 • Mouse and Keyboard • Windows7 • Win AC RTX 2010 software controllerDistributed I/O station ET200M
• Support HART, PROFIBUS, Foundation Field bus. • 16 No’s of digital Inputs with 24V DC. • 16 No’s of digital Outputs with 24V DC. • 8 channels of Analog Inputs with 4-20mA. • 8 channels of Analog Outputs with 4-20mA. • 24VDC /10A inbuilt power supply.
Peritoneal Dialysis Simulator
Description
For Continuous Ambulatory Peritoneal Dialysis. Designed to introduce patients, students, and nurses to the essentials of CAPD procedures and care. The realistic torso offers a realistic method to demonstrate and practice peritoneal dialysis. Success with CAPD is dependent on the patient’s following dialysis procedures with extreme care. This Life/form simulator gives the patient an opportunity to gain the confidence necessary for prolonged success with CAPD. Complete with indwelling Tenckh off catheter in a hard carry case. Dialysis materials not included.
Crucible with Lid High Form
Description
Chemical porcelain crucibles are glazed inside and out, except outside bottom and rim. Crucible covers are completely glazed except for rim. For use in temperatures up to 1150 C (2102 F). Not recommended for minerals or metals.Capacity :
100mlHeight :
2.13 inch (54mm)Top Outside Diameter :
2.56 inch (65mm)
