XTEMOS ELEMENT
AJAX PRODUCTS TABS
Sonometer 3-Wire
Description :-
Hollow wooden sounding box 1290 x 130 x 110 mm, with mm scale, has two fixed bridges 72 cm apart over which wires are stretched.
To one wire is fitted a spring balance reading to 100 N x 5 N and its tension can be adjusted by a winged nut and measured.
Another wire passes over a pulley and can be loaded as desired.
A third wire, for comparison, can have its tension adjusted by a wrest-pin.
With 3 movable bridges, wrest-pin key, spring balance, and set of four wires of different diameters, each 1.5 meter long, without masses.
Botany Charts
Description
Poly art Charts are multi colored, accurate in details, printed on plastic, laminated on both sides, washable, non-tearable and long lasting, with plastic rollers, size 75 x 100 cm. T.S. in Dicot & Monocot stem Pinus-1 Male & Female Strobli L.S. Shoot Apex & it’s different regions T.S. Shoot Apex & it’s different regions Plant Tissue Cork L.S. in Flower with T.S. in Anther Plant tissue Xylem T.S. in simple Pit Pinus II through female Strobilus L.S. through ovules Plant tissue Collenchyma Marchantia Life Cycle Plant Tissue Parenchyma L.S. in Root Tip & T.S. in its different regions Marchantia T.S. of Root (Secondary Growth) Adiantum Life Cycle Stages of formation of Female Gametophyte with the process of Pollination, Fertilisation & Formation of seed Plant Tissue Phloem Plant Tissue Sclerenchyma T.S. in Stem to show growth with a drawing of Lenticel Adiantum T.S. Dicot & Monocot Root Typical plant cell, English only Plant Mitosis English only Plant Meiosis, English only Classification of Plants, English only
Collapsible Tube Filling Machine (Hand Operated)
Friction In Pile Lines Apparatus
DESCRIPTION:-
The Set-up consists of 2 pipes of different diameters, which are connected in parallel. Pressure tapings are provided on each pipe to measure the pressure losses with the help of a Differential Manometer. Control valves are fitted on each pipe, which enables to use one pipe at a time for experiment. Present set-up is self-contained water re-circulating unit, provided with a sump tank and a centrifugal pump etc. Flow control valve and by-pass valve are fitted in water line to conduct the experiment on different flow rates. Flow rate of water is measured with the help of measuring tank and stop watch.EXPERIMENTS:-
Ø To determine the losses due to fiction in pipes Ø To determine the friction factor for Darcy Weis back equationUTILITIES REQUIRED: –
Ø Water Supply & Drain Ø Electricity Supply: Single Phase, 220 VAC, 0.5 kWTECHNICAL SPECIFICATION: –
Ø Pipes (2 Nos.) : Material GI of ½ “ & 1” Diameter Ø Pipe Test Section : Length 1 m Ø Water Circulation : FHP Pump, Crompton / Sharp make Ø Flow Measurement : Using Measuring Tank with Piezometer,Capacity 25 Ltrs. Ø Sump Tank : Stainless Steel, Capacity 50 Ltrs. Ø Stop Watch : Mechanical / Electronic Ø Control Panel : On / Off Switch, Mains Indicator etc. The whole Set-up is well designed and arranged in a good quality painted StructureXTEMOS ELEMENT
AJAX PRODUCTS TABS SIMPLE
Light Box and Optical Set
Description
A Robust light box in matt black finish with a 12 V 24 W axial filament lamp with flexible leads. One end of the box takes a cylindrical convex lens in an adjustable sliding mount to enable production of convergent, parallel or divergent beams. Complete with accessories which consist of: 5 Plastic blocks, one rectangular, One semicircular, One equilateral prism 60° x 60° x 60°, One right angle prism 90° x 60° x 30° and one right angle prism 90° x 45° x 45°. 3 Cylindrical acrylic lenses: one double convex, one double concave, both having the same radius of curvature and one thick convex lens. 3 Mirrors, one plane glass, one curved parabolic and one curved semi-circular. 2 Slit plates, one with three narrow and one narrow slits, the other with four narrow and one wide slits 1 Set of eight colour filters, Red, Green, Blue, Cyan, Violet, Yellow, Orange and Magenta. 1 Set of coloured cards, Red, Green, Blue, Violet, Orange, Cyan, Yellow and Pink. Complete with one spare lamp, in box.
Burner Bunsen Natural Gas
Action of Cams
XTEMOS ELEMENT
AJAX PRODUCTS TABS ALTERNATIVE
Fashion
Concave Mirror, Spherical
T-Joint
XTEMOS ELEMENT
AJAX PRODUCTS TABS ARROWS PAGINATION
Spectrometer, Standard
Description
Reads to 6 minutes of arc (0.1°) 170 mm diameter metal scale graduated 360° x 1°, independently rotatable, with locking screw, vernier attached to the telescope reads to 0.1° (6 minutes of arc). Collimator is mounted on a fixed pillar, with an achromatic objective of 150 mm focal length and 21 mm aperture, and has an adjustable slit 6 mm long. The telescope is on a movable pillar, with a fine adjustment screw, an achromatic objective of 170 mm focal length, 21 mm aperture, Ramsden eye-piece and glass crosswire graticule. Both collimator and telescope have spiral focusing system and have axis adjusting arrangement. The table has 3 leveling screws, with lines marked to assist prism placement. With prism and grating holders, one small screw driver and one Tommy bar for axis adjustment Without prism.
Corcyra Cage
Slip Creep Measurement Apparatus
The apparatus consists of a variable speed D.C. Motor, Driving pulley and Driven pulley of equal diameter. The pulleys are mounted on input shaft (Motor shaft) and output shaft. The driven pulley can slide on the base with bearing block to change initial tension in belt. Brake drum is mounted on output shaft helps to measure power output. The motor speed is varied by dimmerstat. A two channel RPM Indicator is provided to measure speeds of driven and driving pullies respectively.
Specifications:
1.D.C. Motor – 1 HP, 1500 RPM, variable speed. 2.Driving & Driven puilies of equal diameters. 3.Brake drum along with spring balance. 4.Fiat Belt of fixed length of following materials – (i)Fabric Belt (ii)Canvas Belt. (iii)Rubber Belt. 5.Belt tightening arrangement. 6.Speed Controller unit. 7.Two Channel digital RPM Indicator. 8.Stroboscope.Experimentation –
1. To measure co-efficient of friction between pulley material and different belt materials. 2. To measure power transmitted with varied belt tensions and plotting graph of (T1 – T2).Tension Characteristics. 3. To measure percentage slip at fixed belt tension by varying load on brake drum and plot graph of (T1-T2) Vs.percentage slip.i.e. Slip Characteristics. Finding a creep zone from graph. 4. To measure belt slip speed and observe the limiting value float at constant speed when the slip just starts.Service Required:
1.230 V.A.C. stabilized power supply 2.Space -. 1.5m x 1.5 m.XTEMOS ELEMENT
AJAX PRODUCTS TABS WITH ICONS
Chrysopa Breeding Nest
Description
Teakwood frame with silk screen net on sides and collapsible cover on side. Cover can be fixed in position with help of lever. Top sliding plank of MDF covered with black cloth from inside and spirit polished from outside. A sapre plank supplied for replacement. Combs for removal of insect from plank. Beautiful spirit polish finish. Size 60x60x30cm
Rotary Compressor Actual Cut Section
This model will be made out of original parts. The model will be suitably sectioned to demonstrate the internal construction details showing the minute information, and working of the same, the model will be suitably painted and mounted on a metal or wooden base & supplied with key card & very interesting literature regarding working of the same.
Air Brake Actual Working
Flower & Embryology
Description
All Charts are made on PVC rexine, hand drawn, waterproof, in fast multi colors with a black background. Each chart is provided with rollers to hang on wall. Size 75×100 cm. Typical flower showing parts Fertilization showing germination of pollen T.S Anther & its development Germination of pollen grain and development of male Gametophyte Megasporogensis Development of embryo and endosperms Development of embryo in sagittaria Embryo in Capasella Microsporangium Types of emchryo sacs Forms of Androecium Form of Gynaecium Development of Monocot embryo Placentation Aestivation L.H. Datura Inflorescene Part – I showing simple racemose & simple cymose Inflorescene Part – II showing compound & special Pollination different types Forms of ovules Forms of Calx & corollaXTEMOS ELEMENT
AJAX PRODUCTS TABS LOAD MORE PAGINATION
SILICA CRUCIBLE WITHOUT LID
PRODUCT DESCRIPTION
- Crucible is glazed inside and outside.
- Highly resistant to alkalis and hot temperatures
- 50ml capacity
- Outside diameter 55mm, 42mm height
- No lid includedSilica crucible is glazed inside and outside. Highly resistant to alkalis and hot temperature SIZES ARE: 15ML 25ML 50ML 80ML 100ML 150ML
SILICA CRUCIBLE TALL FORM Without Lid, Translucent
XTEMOS ELEMENT
AJAX PRODUCTS TABS CAROUSEL
Full Functional Elderly Nursing Manikin
Description
Designed according to the demand of the clinical principles and the guidelines of nursing training. This multifunctional simulator could simulate an actual circumstance for practice. Multiple functions, rural practice, easy assembly, well shaped appearance and correct anatomical landmarks provides a very good training for practice.Features:
Head Care Body care Patient moving Different lying pose Bilateral and Unilateral oxygen inhalation Atomization inhalation therapy Nasal Feeding Gastric lavage training Intravenous Injection Intramuscular Injection Hypodermic Injection Various fistula orifice washing practice Female Catheterization Female Bladder Washing Enema Treatment Simulator Assembly
Pipette Pump
fast release Pipette Pump for precise pipetting & zip quick emptying.
The Knurled thumb wheel can be rotated to draw up or dispense liquids while the releaser may be pushed in for zip-quick emptying.
The moulded chuck has silicon rubber coller inside to hold various pipettes of standard sizes.
The Pipette Pump resists acids & alkalis and can be easily disassembled for thorough cleaning.
Material : Acrylonitrile Butadiene Styrene
| Particulars | Pack (Pcs) | |
|---|---|---|
| Pipette Pump 2 ml | 12 | |
| Pipette Pump 10 ml | 12 | |
| Pipette Pump 25 ml | 12 |
Rack Pinion Type Steering System
Rack & Pinion Type Steering System – Actual Working
The working of steering system is shown with the help of actual parts assembled on square iron pipe frame. All the necessary parts of steering system are shown in actual working form. This model helps the student to understand the working of the steering system very easily. It is specially made dissectible for demonstration purposes.
Theodolite
Description
We bring forth for our customers watts theodolites which are scientific instruments extensively employed in surveying and engineering work. These are mainly used for measuring angular values in a traverse or network between survey marks. Watts theodolites can also determine a line of sight along a level plane by combining a spirit level and a telescope. Our range of products is subject to customization to meet the needs of our clients, and can be availed reasonable rates.Watts theodolites is mainly used for :
• Surveying and engineering work • Measuring angular values in a traverse or network • Determination of a line of sight along a level plane
PLC-SIE2 with Demo Panel Training Kit
This trainer consists of PLC, Demonstration Panel & Programming Software.
PLC Specification
• Make : SIEMENS • Model : CPU1212C • Digital Inputs : 8 Nos • Digital Outputs : 6 Nos • Program Memory : 24KB • Data Memory : 10KB • PLC to PC interface : PROFINET • PWM & HSC channels provided • Windows based programming software providedPanel Specification
• SPDT switches provided for Digital inputs • LEDs provided with fuse protection for Digital outputs • Inbuilt 24V DC power supply provided • Connectors provided for external interface applications
