XTEMOS ELEMENT
AJAX PRODUCTS TABS
Spring Unit of Mechanical Model
Description
For showing potential energy in a wound-up spring and its conversion to electrical energy by driving a dynamo and lighting a lamp. May also be used to wind up a weight on a cord showing the change from potential energy to kinetic and back to potential in the raised weight. The steel shaft carries a clock spring with a free wheel device and winding ratchet, also an aluminium 'V' pulley 56 mm. diameter. One end of the shaft overhangs the base for use as line shaft when winding up a weight. Dimensions 220 x 100 x 100 mm. high Supplied complete with driving belt.
Resistance Unit
XTEMOS ELEMENT
AJAX PRODUCTS TABS SIMPLE
TI MSP430 Development Board
ON Chip Features
• CPU - MSP430F1611 • Core - 16 bit RISC Architecture. • Speed - Up to 8 MHZ. • Flash - 48 KB + 256B. • SRAM (on-chip) - 10KB. • 48 GPIO Lines. Two UARTs. • One I2C Module. One SPI Module. • Two 16 bit Timers. • Five Power Saving Mode. • 12 bit ADC with single channel. • 12 bit DAC with two channel.ON Board Features
• Eight Digital Output - LED Interface. • Two Digital Input. • 16 x 2 Character LCD Interface. • 7 Segment Display via I2C Interface. • 10 Base T Ethernet Connectivity. • SD Card Interface Support. • Audio Interface. • Jtag connector is provided for Debugger. • USB to serial interface provided.
Oxygen And Carbon Cycle In Nature
Spectrometer Prism
XTEMOS ELEMENT
AJAX PRODUCTS TABS ALTERNATIVE
Fashion
Ultrasonic Interferometer
Ultrasonic Interferometer is a simple and easy to use unit for the accurate measurement of ultrasonic velocity in a Liquids and Liquid systems at the desired temperature (and at desired frequencies).
FEATURES:
• Accuracy in wavelength measurement – 0.01mm • Digital Panel Meter ( DPM) for observing the change in the reading between nodes /anti nodes (75mV approximate between a node and anti node) • Easy replacement of transducers with other frequency • Only one Liquid cell is required for all frequencies • Built in IC regulated power supplies. • The frequency of the Crystal oscillator at the piezo electric transducer is so matched at the 3 digit Decimal accuracy • The accuracy of Meter is 3 Digit Decimal • Stainless Steel based mechanical setup.ACCESSORIES:
• Liquid cell - One (with provision for water circulation) • Transducer (Longitudinal, 2MHz) - One • Micrometer assembly - One (with Tx)
Porcelain Mortar & Pestle
Description
Adarsh present optimum quality Porcelain Mortar & Pestle. The Mortar is provided with lip, glazed outside except bottom and unglazed inside. Pestle unglazed at grinding surface & glazed upwards for hand comfort in grinding.| Mortar Top ID (mm) | Mortar Top OD (mm) | Capacity (ml) | Mortar Height (mm) | |
|---|---|---|---|---|
| 60 | 80 | 60 | 44 | |
| 75 | 90 | 100 | 48 | |
| 85 | 105 | 150 | 70 | |
| 100 | 125 | 275 | 70 | |
| 125 | 155 | 550 | 88 | |
| 150 | 180 | 900 | 100 | |
| 175 | 200 | 1500 | 115 | |
| 200 | 230 | 2000 | 140 | |
| 250 | 285 | 4200 | 175 | |
| 300 | 300 | 7000 | 205 | |
| 350 | 400 | Available on demand | ||
| 400 | 450 | Available on demand |
XTEMOS ELEMENT
AJAX PRODUCTS TABS ARROWS PAGINATION
Tubing, Silicon
Utility Tray
We excel in providing high quality Utility Tray to our valuable clients.
Our range of Utility Tray is well appreciated in the market for its high quality and durability.
this Polypropylene Tray can be utilized for wide range of purposes ranging from drying glassware to sterilizing and for storing any laboratory apparatus.
Material : Polypropylene
| Particulars | Pack (Pcs) | |
|---|---|---|
| Utility Tray 375 x 350 x 130 mm | 6 |
Reciprocating Pump Test Setup
DESCRIPTION:
The Set-up is designed to study the performance of Reciprocating Pump. The Set-up consists of a Reciprocating Pump coupled with electrical motor, supply tank, measuring tank & pipe fittings for closed loop water circulation. Pressure and Vacuum Gauge are connected on delivery and suction side of pump for the purpose of measurement. The flow rate of water is measured using measuring tank and stop watch provided.EXPERIMENT:
To determine overall efficiency and pump efficiency of the Reciprocating Pump To plot Head vs. Discharge, Pump efficiency vs. DischargeFEATURES:
Closed loop water circulation Compact & stand alone set-up MS Excel sample calculation program on demand Stainless Steel tanks and wetted parts Superb painted structure Simple to Operate & MaintainUTILITIES REQUIRED:
Electric Supply: – Provide 230 +/- 10 VAC, 50 Hz, Single Phase Electric Supply with proper earthing. (Neutral – Earth voltage less than 5 VAC) 5 A, three pin socket with switch for pump. Water Supply: Tap water connection ½” BSP., Distilled water @ 80 Ltrs. (Optional extra cost)TECHNICALS SPECIFICATIONS:
Pump : Double acting, single Cylinder, Capacity 1 HP Speed 250 RPM (max.), Head 5 Kg/cm2 (max.) Drive : AC Motor with step cone pulley arrangement for 3 prefixed speed Or DC Motor with DC Drive along with non-contact type Digital RPM Indicator Supply Tank : Capacity 70 Ltrs. Measuring Tank : Capacity 50 Ltrs. fitted with Piezometer Tube & Scale Piping : GI / PVC Stop Watch : Electronic Control Panel : With required electrical instrumentation The whole Set-up is well designed and arranged in a good quality painted structure.
Zener Diode Unit
XTEMOS ELEMENT
AJAX PRODUCTS TABS WITH ICONS
Monocot Root T.S.
Micro Controller Development Board
Microcontroller development board is designed to train engineers about the structural design, instructions and utilize the 8051 microcontroller board. A 40 pin ZIF socket for easy insertion of 89 series microcontroller with four 10 Pin FRC connectors is provided on the board. Outputs from I/O port from microcontroller are available on FRC connectors those can be easily connect with different modules. Microcontroller Development Board consists of EEPROM with 4K memory changeable with more RTC DS1307 with 32 KHz crystal with battery backup One 12 V stepper motor with drivers.One 16 x 2 LCD display. 8 Output LED indicators. 4 multiplexed 7-segment display. 8 single bit toggle switch. 4 x 4 matrix keyboard. Single Channel ADC with potentiometer and provision of external inputs RS 232 serial communication. One 12 V DC motor driver.
Bryophyta
| Anthoceros Thallus VS | Anthoceros Cporophyte LS |
| Marchantia Thallus VS | Marchantia Gemma Cup VS |
| Marchantia Antheridial Head VS | Marchantia Archegonial Head VS |
| Marchantia Sporophyte VS | Moss Protonema WM |
| Moss with Capsule WM | Moss Leaf TS, WM |
| Moss Archegonia WM | Moss Stem TS |
| Moss Archegonial Head WM Moss Antheridia WM | Moss Antheridia Head VS |
| Moss Capsule LS, WM | Moss Capsule TS |
| Porella Veg. WM | Porella Antheridial WM |
| Porella Archegonial WM | Riccia Thallus TS |
| Riccia Antheridial VS | Riccia Thallas WM |
| Riccia Archegonial VS | Riccia Mature Sporophyte VS |
Peripherally Inserted Central Catheter
Description
The model is suitable for central venipuncture of internal carotid vein and subclavical vein and peripheric venipuncture (arm veins) of cephalic vein. The cervical veins and arm veins can be filled with simulative blood.Features:
The model is a simulative right half of adult torso with right arm. There are apparent anatomical marks: clavicle suprasternal notch, stenocleidomastoid muscle, pectoralis major muscle, ribs and deltoid muscle. Lifelike veins: Superior vena cava, internal jugular vein, subclavical vein, cephalic vein, basilic vein and median cubital vein etc. With apparent anatomical marks, the model can be used to train puncture and catheterization of internal carotid vein, subclavical vein, cephalic vein and heart catheterization. The skin and veins can be replaced, Students will feel an apparent “POP” when puncture needle has been thrust into the veins. The heart floating swan-ganz intubation can be exercisedXTEMOS ELEMENT
AJAX PRODUCTS TABS LOAD MORE PAGINATION
SILICA CRUCIBLE WITHOUT LID
PRODUCT DESCRIPTION
- Crucible is glazed inside and outside.
- Highly resistant to alkalis and hot temperatures
- 50ml capacity
- Outside diameter 55mm, 42mm height
- No lid includedSilica crucible is glazed inside and outside. Highly resistant to alkalis and hot temperature SIZES ARE: 15ML 25ML 50ML 80ML 100ML 150ML
SILICA CRUCIBLE TALL FORM Without Lid, Translucent
XTEMOS ELEMENT
AJAX PRODUCTS TABS CAROUSEL
Behaviour Of Column Struts Apparatus
Apparatus consist of four spring steel columns which are put along a vertical wooden board. These four columns have different end conditions as below:
1. Both ends pinned
2. Both ends fixed
3. One end pinned and other fixed
4. One end fixed and other end free
Apparatus to be supplied should be complete with a supporting stand and a set of weights.
Fuel Supply System Petrol MPFI Type
Fuel Supply System Petrol MPFI Type (Actual Working Model) Multi Point Fuel Injection
This is an actual working model of fuel supply system of a MPFI petrol engine. The parts details is as under :
1. Fuel Tank
2. Fuel Filter
3. Motorised Fuel Pump
4. Pressure Gauge
5. Fuel Rail
6. Fuel Injectors
7. ECU
8. Igniter & Ignition Coil
9. Distributor
10. Spark Plugs
11. Power Supply
12. Fuel Gauge & Control Panel
This model helps the student to understand about the parts & working of MPFI system. It is specially designed for demonstration purposes. The model will be supplied with key card & very interesting literature regarding working.
