XTEMOS ELEMENT
AJAX PRODUCTS TABS
Xilinx Spartan 3E FPGA Trainer Kit
Specification
• XC3S250E - 4PQ208C / XC3S500E-4PQ208C • 16 Nos. of digital input using slide switches with LED indication • 16Nos. Of digital outputs using discrete LEDs • 16 x 2 LCD is provided for display the text message. • One Reset Switch • One switch is provided for giving manual clock • FPGA configuration through - JTAG Port - On board Flash Prom XCF02S • Total 158 I/O pins : 124 pins used for integrating peripherals like LED, Switches etc., balance pins available to user in 20 pin • header (3.3V compatible) • 1No of 26pin header to interface VLIM cards like Traffic Light Controller (5V compatible) • On board programmable PLL oscillator from 1 MHz to 100 MHz using jumpers • 4 Nos of 7 segment LED display • One relay and Buzzer provided. • Stepper & DC motor Driver provided. • 4 * 4 matrix key provided • Housed in a sleek plastic cabinet with built in SMPS 5V/2A. • Compatible with Xilinx ISE Design Suite WebPACK Software. • On board USB to JTAG is available for configure FPGA (Supports only with Vi JTAG 5.0 Software)
Specific Gravity Specimen Cylinders with Hooks
Crucible with Lid Low Form
Description
Chemical porcelain crucibles are glazed inside and out, except outside bottom and rim. Crucible covers are completely glazed except for rim. For use in temperatures up to 1150 C (2102 F). Not recommended for minerals or metals.Capacity :
250mlHeight :
2.36 inch (60mm)Top Outside Diameter :
4.02 inch (102mm)
ZigBee Debugger/Dongle
Features
• USB Full Speed Connectivity • Program and Debug the flash of RF SoC chip • USB MCU Debug • 5V Supply Provision • Capable of powering target Board from the Debugger • Capture supports IEEE 802.15.4 ZigBee 2003 ZigBee 2007 Compliant • Analyze a large physically dispersed networkXTEMOS ELEMENT
AJAX PRODUCTS TABS SIMPLE
Basic Electro Pneumatic Trainer Kit
Features
• This trainer kit helps to design the circuits with logic sequence. • FRL unit receives air from compressor then filters, regulates & lubricates the air. • 5/2 direction control valve provided to control the double acting cylinder. • 3/2 direction control valve provided to control the single acting cylinder. • One way flow control valves provided to control the air flow. • Magnetic read switches are provided to indicate the position of the cylinder. • Control module controls the direction control valves using Switches, Relays and Timer.
Human Torso, With Head, Half Size
Water Tap, Swan Neck, Light
XTEMOS ELEMENT
AJAX PRODUCTS TABS ALTERNATIVE
Fashion
Basic Electricity Kit
Description
This economical kit consists of various components, which help students explore many electrical and electronic concepts. Supplied with instruction manual. Kit consists of: Cell Holder (12), Bulb Holder, MES, Mounted on Base (20), Push Key (8), Two Way Switch (4), Universal Clip (4), Electrode Holder (4), Variable Resistance (4), Bulbs, MES (40), Connecting Lead, 4mm, 10cm, Red (12), Connecting Lead, 4mm, 10cm, Black (12), Connecting Lead, 4mm, 25cm, Red (4), Connecting Lead, 4mm, 25cm, Black (4), Crocodile Clips (8), Carbon Rod (12), Soft Iron Rod (8), Silicon Diode (4), Resistance, Fixed (4), Copper Foil Sheet, 150×150mm (1), Copper Wire, Bare, 20SWG (1 Reel), Copper Wire, Insulated, 50m (1 Reel), Eureka Wire, 34SWG (50gm), Steel Wool (1 Pack).
Insect Showcase Cabinet (Large)
Description
Provided with 53x45x9cm size drawer for keeping insects. Drawer of MDF with MDF sheet bottom and removable glass top is lined with 8mm thick EVA sheet and is glazed white from inside. Strips with provision for insecticide fitted inside drawer. Glass top frame designed to make box air-tight and pest proof. Fitted with index card holder and puller knobs. Nicely polished. Cabinet frame of plyboard with index card holder and puller knobs. nicely polished. Cabinet frame of plyboard with melamine lamination. Hinged door is provided with lock and handle and is lined with velvet. Insect Showcase Cabinet (Large) with 12 drawers Insect Showcase Cabinet (Large) with 24 drawers
XTEMOS ELEMENT
AJAX PRODUCTS TABS ARROWS PAGINATION
Critical Heat Flux Apparatus
The apparatus demonstrates the regimes of pool boiling. The test section consists of a test wire surrounded by water of constant temperature. The surface temperature of the test wire is heated by passing current through it. Due to the temperature difference between the wire surface and surroundings, the difference regimes are observed till the burnout point.
Specifications:
1.Test wire -35 gauge or 40 gauges. Length = 10cm. 2.Nichrome heater- 1 kw capacity – 1 nos. 3.Glass trough of sufficient capacity. 4.Table light to observe the test wire. 5.Voltmeter and ammeter to measure the input to the test wire. 6.Dimmerstat to adjust the voltage. A technical manual accompanies the unit.SERVICES REQUIRED:
1.220v, ISA, stabilized single-phase supply. 2.Floor surface- 1m x 1m at working height.
Motor Generator Model Set
Description
This motor-generator set gives students an insight into the physical and technical relationships on which electric motors, generators and transformers are based. The modular system allows to set up different function models without tools: Various DC motors Series and shunt motor Synchronous motor DC generator and alternator Transformer. This set allows the performance of 10 student experiments about the following topics: Magnetic field of a coil Conversion of electrical energy into kinetic energy Commutator Direct current motor Synchronous motor Series and shunt-wound motors Electromagnetic induction The electrical generator Engine-generator Transformer
XTEMOS ELEMENT
AJAX PRODUCTS TABS WITH ICONS
Orbital Shaking Incubator cum B.O.D
Specification
Orbital shaking incubator cum B.O.D incubator is specifically designed to controlled incubation with orbital shaking arrangement with powerful geared motor for many labotatory procedures such as tissue culture, fermentations studies, enzyme reactions, growth studies etc. The outer chamber is made up of M.S sheet duly powder coated & inner chamber is made of thick S.S. sheet. The gap between wall is fitted with high grade glass wool to avoid thermal loss. The plexi glass window provided to inspect the specimen without disturbing the inner temp. The incubator is illuminated with one door operated or panel operated flurescent tube. The unit has a temp. Range from 5°C to 60°C. The temperature is controlled by Dual Display Microprocessor PID Temperature Indicator cum Controller with a accurancy of + 0.5°C. Air circulation fan is provided to maintain stability throughout. The speed of shaker is variable from 30 RPM to 250 RPM. The tray of the shaker is also made of S.S sheet with lotus type clamps to hold flasks. The unit is fitted with Digital RPM meter, 999 min digital timer.Optional Accessories
Timer 0-24 Hours. Automatic voltage stabilizer 3KVA (Most rec.).Size
16 Flasks of 500ml. 25 Flasks of 250ml. 36 Flasks of 100ml.
Vacuum Pump with Plate
Emitting Diode (LED’s)
Bridge rectifier is designed with four LED’s internally arranged in bridge pattern fitted inside a plastic moulded case. Two LED’s are red and two LED’s are green. This device is used to demonstrate the functioning of a bridge rectifier, i.e., to convert alternating current (AC) into direct current (DC). Two yellow sockets are used for AC input. Two sockets, one red and one black, are used for DC output. For the easy understanding of the internal circuitry, the circuit diagram is printed on the box.
XTEMOS ELEMENT
AJAX PRODUCTS TABS LOAD MORE PAGINATION
SILICA CRUCIBLE WITHOUT LID
PRODUCT DESCRIPTION
- Crucible is glazed inside and outside.
- Highly resistant to alkalis and hot temperatures
- 50ml capacity
- Outside diameter 55mm, 42mm height
- No lid includedSilica crucible is glazed inside and outside. Highly resistant to alkalis and hot temperature SIZES ARE: 15ML 25ML 50ML 80ML 100ML 150ML
SILICA CRUCIBLE TALL FORM Without Lid, Translucent
XTEMOS ELEMENT
AJAX PRODUCTS TABS CAROUSEL
ANALYTICAL BALANCE
 DESCRIPTION
- Student Physical Balances with flat beam.
- Chemical Balances with Flat beam and rider using facility.
- Chainomatic Analytical Balances with external alteration of weights up to 100 mg.
- Analytical Balances with Triangular beam with rider using facility / Flat beam with vernier scale.
- Capacity 1mg to 100gms
- Capacity 1mg to 200gms
- IDDC Certified & Tested, 100gm
- Capacity 1mg to 500gm
- 1gm
- 2gm
- 5gm
- 10gm
- 20gm
- 50gm
- 100gm
- 200gm
Bell Jar and Vacuum Pump Set
Description :- Simple, innovative kit allows you to perform a number of experiments on vacuum and air pressure.
The kit clearly demonstrates the method by which a pump works.
Also illustrates that air has mass and helps find its mass and density.
Explain the effect of surrounding air pressure on a sealed balloon.
The balloon will expand when the surrounding air is removed.
And also demonstrate that liquid boils at reduced temperature when the surrounding air pressure is reduced with instructions.
